WHD-PRO + i AUDIO KIT
WR WM- -PRO - - -PRO EX 503 - - SGM 990 i CABLE-HX-
INSTRUCTION MANUAL
WARNING
Do not store or use the products in high heat or humidity.
Do not use near a broadcast staon, airport or plane. You must change the frequencies if you are
interfering with other transmiers.
The system will work connuously for 10 hours on one set of baeries. If sound quality is poor,
change baeries.
Remove baeries when the system is not in use.
Thank you for purchasing the AZDEN WHD PRO Audio Kit. The following contents are included in your kit:-
-1 x WR PRO VHF Receiver
-1 x WM PRO VHF Belt Pack Transmier-
-1 x EX 503 Lavalier Microphone
-1 x SGM 990 Direconal Microphone
-1 x HX i Smartphone Connector Cable
The PRO systems operate in the low interference VHF band and have 2 switchable frequencies, -
169.445 (F1) and 170.245 (F2). You should select the quieter frequency for use.
The systems conforms to Part 90 of the FCC rules. You should contact the FCC oce for ling forms.
1. Loading Baery
Open the baery compartment lid by sliding it down and raising the lid. Insert a 9 volt -
baery into the baery compartment with the correct polarity. Direcons are on the inside of the
baery compartment. Do not force the baery compartment lid to close. If it does not close easily,
turn the baery around and try again.
2. Power/Frequency Selector Switch
This slide switch is used to turn the unit on and o as well as to select a frequency. When
not using the WR PRO, make sure that the switch is turned to OFF. -
3. Signal Indicator
This LED has 2 funcons: When you rst turn the Power/Frequency Selector Switch of the
Receiver on, but if the Transmier is not on, the LED will show red indicang that the baery is good.
If both the Transmier and the Receiver are on and they are on the same frequency, the Receiver LED
will show green and the Transmier LED will show red.
WR- PRO RECEIVER