B-Tech BT7333 Manual

B-Tech Vægophæng BT7333

Læs gratis den danske manual til B-Tech BT7333 (5 sider) i kategorien Vægophæng. Denne vejledning er vurderet som hjælpsom af 29 personer og har en gennemsnitlig bedømmelse på 4.1 stjerner ud af 15 anmeldelser. Har du et spørgsmål om B-Tech BT7333, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/5

v.1208 OR1BX

PAGE 1 / 5

This pack contains:

1 desk stand kit Caution: Do not exceed the maximum weight limit indicated for this product.

Failure to comply may cause instability and possible serious injury.

www.btechavmounts.com

Asia Pacific

B-Tech International (Hong Kong) Ltd.

23rd Floor, Manulife Tower, North Point, HK

Tel: (+852) 2556 7337 Fax: (+852) 2556 7321

Email: info@btechavmounts.com.hk

Europe

B-Tech PRO-AV bvba

Brixtonlaan 32, Zaventem 1930,Brussels, Belgium

Tel: +32 (0)2 720 92 71 Fax: +32 (0)2 725 42 15

Email: info@btechproav.com

North America

B-Tech Audio Video Mounts.

10 Greg Street, #108, Sparks, NV 89431, USA

Tel: (1)800 975 5812 Fax: (1)800 592 2876

Email: info@btechavmounts.com

Head Oﬃce

B-Tech International Ltd.

Bennett House, Long March, Daventry, Northants NN11 4NR, UK

Tel: +44 (0)1327 300 787 Fax: +44 (0)1327 706 562

Email: info@btechavmounts.co.uk

300 mm (11.8")

• Designed to mount 3 flat screen monitors up to 22" (widescreen) onto

a desk

• The glass base is designed to hold a keyboard on top when not in

use to keep the workspace tidy

• The position of the flat screens can be adjusted along the horizontal

bar 510 – 1110mm (20” – 43.7”)

• Suitable for flat screens with the following VESA fixings:

100 100mm, 75 x 75mm and 50 x 50mm

• Maximum load: 45Kg (99lbs), 15Kg (33lbs) per interface mount

• AViBall adjusts 37° in any direction, centre interface tilts -10°/+25°

• Pole dimensions: Ø50mm (2”), 0.4M (15.7”) length

• Base dimensions: W 500mm (19.7”), D 300mm (11.8”), H 20.5 (0.8”)

• Base made from 10mm (0.4”) thick tempered safety glass with non-

slip rubber feet

• Cable management and pole end ring included

• All fixings included

Made in China

This desk mount is intended for use only with the maximum

weights indicated. Use with heavier than the maximum

indicated may result in instability causing possible injury.

1206 mm (47.5")

1110

ADJUSTMENT 510 - mm (20" - 43.7")

427,5 mm (16.8")

115 mm (4.5")

54 mm (2.1")

500 mm (19.7")

98 mm (3.8")

64,5 mm (2.5")

or 98 mm (3.8")

Important Safety Instructions.

Read first

Do not attempt to install this product until all instructions and warnings have been read and

properly understood. Please keep these instructions for future reference.

B-Tech International Limited, its distributors and dealers are not liable or responsible for

damage or injury caused by improper installation, improper use or failure to observe these

safety instructions. In such cases, all guarantees will expire.

General

B-Tech International Ltd recommends that a professional AV installer or other suitably qualified

person install this product. Great care must always be taken during installation as most AV

equipment is of a fragile nature, possibly heavy and easily damaged if dropped.

If you do not fully understand the instructions or are not sure how to install this product safely,

then please consult a professional for advice and/or to install this product for you. Failure to

mount this product correctly may cause serious injury or death both during installation and at

any time thereafter.

Do not mount any AV equipment that exceeds the specific weight limit of the product you are

installing. This weight limit will be clearly stated on each product and its packaging and will

vary from product to product.

Product location

Please pay careful attention to where this product is located.

Fixing hardware

It is highly recommended that all fixing screws be used where supplied and that the purpose of

all other fixing hardware is fully understood. In some cases more AV equipment fixing

hardware will be supplied to accommodate different models of equipment and set up

configurations.

The installer must be satisfied that any supplied fixing hardware is suitable for each specific

installation. If any fixing screws or included hardware are deemed not sufficient for a safe

installation then please consult a professional or your local hardware store.

Hazard limitation

When routing cables take advantage of any built in cable management features that the

product might provide and ensure that all cables are tidy and secure. Check to see that any

moving aspect of the product can do so unhindered by any cabling.

Some products have moving parts and the potential to cause injury through the crushing or

trapping of fingers or other body parts.

Particular attention to the nature of moving parts is required especially when assembling

installing and adjusting during set up.

Immediately after installations double-check that the work done is safe and secure. Double-

check all necessary fixings are present and are of ample tightness.

It is recommended that periodic inspections of the product and its fixing points are made as

frequently as possible to ensure that safety is maintained. If in doubt consult a professional AV

installer or other suitably qualified person.

v.1208 OR1BX

25 26

29 30

No PART NAME QTY

1 50mm POLE CAP (BT7057) 1

2 ACCESSORY COLLAR (BT7053) 1

3 M8 X 15 GRUB SCREW 4

4 M8 X 65 SAFETY BOLT 1

5 ACCESSORY COLLAR COVER (BT7053) 2

6 50MM POLE 0.4M LENGTH (BT7325) 1

7 WASHER (STEEL) OD60 ID10.5 T2 1

8 FOAM PAD (SELF ADHESIVE) 1

9 GLASS BASE WITH FEET (BT7322) 1

10 WASHER (PLASTIC) OD30 ID10 T2.3 1

11 M10 X 35 ALLEN SCREW 1

12 HORIZONTAL RAIL FOR 3 SCREENS (BT7321) 1

13 HANDWHEEL 4

14 M8 X 25 CAP HEAD SCREW 2

15 AVIBALL ASSEMBLY 2

16 M5 X 6 GRUB SCREW 2

17 INTERFACE PLATE (BT7588) 2

18 WASHER (STEEL) M8 OD16 T1.6 2

19 SPRING WASHER M8 7

20 M8 X 23 SQUARE END ALLEN SCREW 2

21 M8 X 12 SECURITY ALLEN SCREW 6

22 TILT PLATE 1

23 INTERFACE PLATE (BT7511) 1

24 WASHER (PLASTIC) M8 OD19 T2.3 6

25 2.5MM ALLEN KEY

(FOR PARTS 16, A & B)

26 4MM ALLEN KEY

(FOR PART 3)

27 5MM SECURITY ALLEN KEY

(FOR PARTS 4, 20 & 21)

28 6MM ALLEN KEY

(FOR PART 11 & 14)

29 CABLE TIE MOUNT (ADHESIVE) 4

30 CABLE TIE 4

REF PART NAME QTY

A M4 X 12 ALLEN SCREW (TO FIX SCREENS) 12

B M4 X 40 ALLEN SCREW (TO FIX SCREEN) 4

C SPACER OD13 ID5.5 T30 (FOR PART B) 4

PAGE 2 / 5

18 19 20

Suitable for loads up to 45Kg (99lbs),

15Kg (33lbs) per interface mount

Produkt Specifikationer

Mærke:	B-Tech
Kategori:	Vægophæng
Model:	BT7333
Produktfarve:	Sort
Monteringstype:	Skrivebord
Højdejustering:	Ja
Drejevinkel område:	-37 - 37 °
Hældningsvinkelområde:	-37 - 37 °
Montering:	Fritstående
Maksimal vægtkapacitet:	45 kg
Forbedret kabelstyring:	Ja
Maksimal skærmstørrelse kompatibilitet:	22 "
Antal understøttede skærme:	3
Minimal skærmstørrelse kompatibilitet:	- "
Montering interface kompatibilitet (min.):	75 x 75 mm
Montering interface kompatibilitet (maks.):	100 x 100 mm