Bauknecht GSI 5599/1 G Manual

Bauknecht Opvaskemaskine GSI 5599/1 G

Læs gratis den danske manual til Bauknecht GSI 5599/1 G (32 sider) i kategorien Opvaskemaskine. Denne vejledning er vurderet som hjælpsom af 57 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 29 anmeldelser. Har du et spørgsmål om Bauknecht GSI 5599/1 G, eller vil du spørge andre brugere om produktet?

Side 1/32
Bauknecht AG, Industriestrasse 36, 5600 Lenzburg, www.bauknecht.ch
Verkauf Telefon 0848 801 002 Fax 0848 801 017 verkauf@bauknecht.ch
Kundendienst Telefon 0848 801 001 Fax 0848 801 003 service@bauknecht.ch
Ersatzteile Telefon 0848 801 005 Fax 0848 801 004 ersatzteilverkauf@bauknecht.ch
Instructions for use
GSI 5599/1 G
5019 496 96016
GB
Quick Reference Guide
Before using the dishwasher, read the user instructions!
(We reserve the right to make technical modifications)
GSI 5599 G IX
Add rinse aid
Add regeneration salt
Only add regeneration salt immediately before
starting a wash programme.
Antebacterial rinse (Sani-Rinse option)
This function executes an antibacterial rinse at the
end of the wash cycle, thereby further reducing
bacteria levels. The lamp will light up when the
function is activated. If the temperature is not
maintained during the antibacterial cycle
(e.g. if the door is opened or a power failure
occurs), the lamps will start blinking to indicate
that the antibacterial action is not guaranteed.
Half load function
Recommended when the dishwasher is not full to
save water and electricity. Press the button to
wash the top rack. Press the button to wash the
bottom rack. Press the button again to deactivate
the function. The indicator light and display show
that only one rack is selected.
WARNING: This function remains selected until
switched off.
“Delayed start” button
The wash cycle can be programmed to start after
1-12 hours. Then press the Start button. After a
prewash the set delay will start.
Display
The display shows all the information relating to
the selected functions and the indication about all
functional failures (see table on the “Instructions
for Use” manual).
1) Reference programme for energy label in compliance with
EN 50242; 2) Programme data obtained in conformity with European standard
EN 50242. Values may vary in relation to usage, e.g.: different loads,
water temperatures - above or below 15° C - as well as water
hardness and power supply voltage, etc.
Programme ON/OFF selector knob
First press and release the selector knob to access it,
and then turn it to select the desired programme;
the dishwasher switches on.
To switch off the dishwasher when the programme
has finished, turn the selector knob to off.
Start button
Press to start the wash cycle and keep pressed until
an acoustic signal confirms the start of the wash
cycle. The display shows the approximate duration
of the wash cycle.
Note: the light above the start button blinks during
the wash cycle.
The light stops blinking and remains alight to indicate
the cycle has ended (“End” on the display) or has
been interrupted due to a fault (“E1, E2....” on the
display).
Indicators
Options
Programme chart Detergent Consumption 2)
Programmes Loading instructions A B Litres kWh Minutes
P1 Pre-Rinse cold Crockery to be washed later. - - 6.0 0.02 15
P2 Rapid 30 min 45°C Lightly soiled crockery with no dried-on
food. X - 13.0 0.80 45
P3 Eco 1) 55°C Normally soiled crockery. X - 14.0 1.05 180
P4 Normal 65°C Normally or heavily soiled crockery. X - 17.0 1.28 90
P5 Intensive 70°C Recommended programme for heavily
soiled crockery, especially suitable for pans
and saucepans. X X 20.0 1.60 110
4GB96016.fm Page 1 Wednesday, September 15, 2004 5:16 PM


Produkt Specifikationer

Mærke: Bauknecht
Kategori: Opvaskemaskine
Model: GSI 5599/1 G

Har du brug for hjælp?

Hvis du har brug for hjælp til Bauknecht GSI 5599/1 G stil et spørgsmål nedenfor, og andre brugere vil svare dig