BeamZ BUV15TL Manual
Læs nedenfor 📖 manual på dansk for BeamZ BUV15TL (5 sider) i kategorien lampe. Denne guide var nyttig for 18 personer og blev bedømt med 4.3 stjerner i gennemsnit af 9.5 brugere
Side 1/5

LAMP WITH BUILT-IN BLACK LIGHT
PROJECTOR
160.120 / 160.122 / 160.124
Instruction Manual
Gebruiksaanwijzing
Mode d’Emploi
Gebrauchsanleitung

Do not attempt to make any repairs yourself. This would invalid your warranty. Do not make any changes to the unit. This would
also invalid your warranty. The warranty is not applicable in case of accidents or damages caused by inappropriate use or
disrespect of the warnings contained in this manual. SkyTronic UK cannot be held responsible for personal injuries caused by a
disrespect of the safety recommendations and warnings. This is also applicable to all damages in whatever form.
UK
Thank you for purchasing this SkyTe Pre-programmed rope light. Please read this manual carefully before c
use and keep it for future use.
Safety Instructions
- Read the manual prior to use.
- Keep the manual for future reference.
- Keep the packaging so that you can transport the unit in its original packaging in order to avoid
damage.
- For indoor use only.
- When mounting the unit, leave enough spaces for ventilation.
- Do not use the unit close to heat sources or when exposed to direct sun light.
- Make sure that no liquids or small components can enter the housing.
- Use a damp, dust-free cloth to clean the unit. Do not use cleaners or solvents!
- The unit doesn’t contain user serviceable parts.
- Keep out of the reach of children.
- The unit should only be repaired by a SkyTronic approved repair service.
Installation and Operation
- This light eect needs to be powered by 4 AA cells. Do not use a combination of old and new
batteries.
- Make sure the batteries are correctly installed as indicated in the battery compartment.
- Switch this unit on with the power switch, the tl-bar will light up.
Replacing the lamp
When replacing the lamp, be sure that the lamp has cooled and the AA-cells are removed from the unit.
Remove the the top of the housing and gently turn the tl-bar counter clockwise to remove it. Insert a new tl-
bar and gently turn it clockwise to install. Now place the top of the housing, replace the AA-cells and turn re
the unit on.
Cleansing
The most important part of your lighteect to keep clean is the tl- as this allows the light output to be bar
transmitted. This should be cleaned with a soft damp cloth. The body of the unit may also be cleaned in the
same way. We recommend internal cleaning be carried out by a fully qualied technician.
Troubleshooting
- When the unit doesn’t work; check the four AA-batteries are properly housed and fully charged. if
- When the tl- work at rst time use; please check if the bar is correctly tted, because bar doesn’t
shipping might cause the tl-bar to loosen.
- When the unit is turned in - - light up; the tl-bar may require replacing. “on mode” and the tl bar won’t
Specications
Power supply: ................................................................................................ 6 VDC (4 x AA-cells)
Dimensions: ....................................................................................................... 55 x 23 x 160 mm
• Specications and design subject to change without prior notice
Produkt Specifikationer
Mærke: | BeamZ |
Kategori: | lampe |
Model: | BUV15TL |
Har du brug for hjælp?
Hvis du har brug for hjælp til BeamZ BUV15TL stil et spørgsmål nedenfor, og andre brugere vil svare dig
lampe BeamZ Manualer

5 Januar 2025

23 September 2024

6 September 2024

5 September 2024

5 September 2024

5 September 2024

5 September 2024

5 September 2024

5 September 2024

5 September 2024
lampe Manualer
- lampe Megatron
- lampe Signature Design By Ashley
- lampe Livarno
- lampe Monacor
- lampe AccuLux
- lampe SLV
- lampe Petzl
- lampe Sonoff
- lampe Raya
- lampe Smartwares
- lampe Honeycomb
- lampe Akasa
- lampe Qazqa
- lampe Steinel
- lampe NightStick
Nyeste lampe Manualer

4 April 2025

4 April 2025

4 April 2025

4 April 2025

4 April 2025

4 Marts 2025

4 Marts 2025

27 Februar 2025

27 Februar 2025

27 Februar 2025