Behringer DI20 Manual

Behringer Audio/video konverter DI20

Læs gratis den danske manual til Behringer DI20 (45 sider) i kategorien Audio/video konverter. Denne vejledning er vurderet som hjælpsom af 55 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 28 anmeldelser. Har du et spørgsmål om Behringer DI20, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/45

ULTRA-DI DI20

1. Welcome to the Behringer Family!

On stage as well as in studios, it is sometimes advantageous to

connect certain sound sources directly to the mixing console.

Sincemany instruments (keyboards, forexample) don’thave balanced

outputs they require a DI-box. Sometimes, evenguitars can’t be

directly connected to mixing consoles because their impedance is

too high.

By using a DI-box, you can directly tap into a high-impedance,

unbalanced signal—forexample, a signal between a guitar and a

guitar amplier. From this point, you can feed this signal directly to

a mixing console.

There are active and passive DI-boxes. A passive DI-box is more

aordable, but its performance is dependent on the impedance of the

device to which it is connected. When the impedance on the mixing

console’s end changes, so does the impedance at the input of the

DI-box. Such DI-boxes only function properly when the connected

impedance values are strictly specied (high at the input, low at

the output). Active DI-boxes are not aected by these impedance

considerations. The input impedance of the DI20 is extremely high,

and it absolutely does not inuence the signal ow through the

DI-box. The output impedance is balanced and always very low,

whereby the signal is far less prone to being aected by noise.

◊

◊ ◊

◊

To prevent damaging your loudspeakers, rst connect

the DI-box and then hook up the respective channel.

The same goes for alternating between battery and

phantom power operating modes.

V 1.0

2 ULTRA-DI DI20

2. Controls

Fig. 2.1: Controls of the DI20

(1) CH. 1 IN input is used to connect unbalanced as well as

balanced signal sources to channel 1.

(2) CH.1 OUT is the balanced output at mic level for channel 1.

(3) CH.2 IN input is used to connect unbalanced as well as

balanced signal sources to channel 2. In Link mode (see ) this (6)

connector functions as output and sends the signal

directly from channel 1.

(4) CH. 2 OUT is the balanced output at mic level for channel 2.

In Link Mode (see ) this connector sends the signal directly (6)

from channel 1.

Produkt Specifikationer

Mærke:	Behringer
Kategori:	Audio/video konverter
Model:	DI20
Bredde:	150 mm
Dybde:	130 mm
Højde:	60 mm
Vægt:	240 g
Produktfarve:	Black,White
Driftsspænding:	48 V
I/O-porte:	2x 1/4"TS In, 2x XLR Out