BioBrite SunRise Manual

BioBrite Lysterapi SunRise

Læs gratis den danske manual til BioBrite SunRise (7 sider) i kategorien Lysterapi. Denne vejledning er vurderet som hjælpsom af 33 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 17 anmeldelser. Har du et spørgsmål om BioBrite SunRise, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/7
SunRise AlarmTM Clock
(Programmable Model)
INSTRUCTION MANUAL
The SunRise Alarm Clock is a great way to wake up feeling more
refreshed and ready to go. Humans are naturally adapted to wake to the
rising sun and sleep when the sun goes down. Waking up to the SunRise
Clock’s simulated dawn can give your body a gentle and natural boost in the
morning. Please take a few moments to read the directions to ensure you
get off to a good start with your SunRise Alarm Clock.
Setting up the Sunrise Alarm Clock:
For best results, set the clock near your bed on a nightstand or bedside
table close to pillow level. Plug the clock into a wall outlet. Do not use a
power strip, surge protector, or long extension cord. NOTE: Until the time
has been set, or after a prolonged power cut, the clock display will flash on
and off to let you know the time needs to be set.
Before doing anything, you should familiarize yourself with the control
buttons and the clock display. The words below the time
display will show you what setting you are changing and what the current
setting is. To adjust any setting, first make sure the ALARM button
(marked “A”) is pressed IN (off) so the Alarm Set sun symbol is not lit.
Press the PROGRAM button a number of times then, within the next few
seconds, change the setting by pressing the + or – button. (NOTE: after
about 12 seconds, unless the + or – or PROGRAM button is pressed, the
clock will revert to its normal state). Once you have completed a setting
you can press the PROGRAM button again to adjust another setting. Once
you are finished with the program settings, leave the clock alone for 12
seconds, and it will return to displaying the current time.
NOTE if the display is too dim to see, press the ALARM button IN and the
display will become bright. This feature is explained in detail later in the
instructions.
Setting the Time:
Make sure the ALARM (“A”) button is pressed IN (off). Press the
PROGRAM button twice so the display reads “TIME”. Then within the next
few seconds use + and – buttons to adjust the time. The time moves
rapidly if the + or – button is held in.
Changing to a 24-Hour Display:
The clock defaults to a 12- -hour display. To change to a 24 hour display,
make sure the ALARM button is IN so the sun symbol is not lit, then press
the PROGRAM button 3 times. Then within the next few seconds press the
+ or – button. The display will alternate between "24 HOUR” and "12 HOUR".
Once the display has switched to "24 HOUR", release the buttons. To
switch back to a 12-hour display, follow the same procedure. The “PM”
symbol is only present in the 12-hour mode.
WAKE-UP SEQUENCE
Changing the Wake-Up Time:
Make sure the ALARM button is IN so the sun symbol is not lit then press
the PROGRAM button once, so the Display reads "ALARM TIME". Then
within the next few seconds adjust the alarm time with + and – buttons until
desired time is set (Note: default alarm time is 7:00 a.m.). Holding in the +
or – button will cause the time to change rapidly.
Setting the speed of the Wake-Up Sequence:
The SunRise Alarm Clock is preset for a 30 minute wake-up sequence, i.e.
the light will reach full brightness gradually over 30 minutes. If you wish to
change the wake-up sequence length, you can choose between 15, 30, 60,
and 90 minutes. To alter the wake-up sequence length make sure the
ALARM button is IN so the sun symbol is not lit then press the PROGRAM
button 6 times so the Display reads "FADEUP" followed by a number.
Within the next few seconds press the + or – button, and the Display will
alternate between "FADEUP DEMO" (a special quick mode described under
“Additional Features”), "FADEUP 30" (30 minute sunrise - this is the Default),
"FADEUP 60" (60 minutes), "FADEUP 90" (90 minutes), and "FADEUP 15" (15
minutes).
Setting the Alarm On

Produkt Specifikationer

Mærke: BioBrite
Kategori: Lysterapi
Model: SunRise

Har du brug for hjælp?

Hvis du har brug for hjælp til BioBrite SunRise stil et spørgsmål nedenfor, og andre brugere vil svare dig


Lysterapi BioBrite Manualer

BioBrite

BioBrite SunRise Manual

28 August 2024

Lysterapi Manualer

Nyeste Lysterapi Manualer

Fysic

Fysic FW450 Manual

5 August 2025
Luminette

Luminette Glasses 3 Manual

21 Februar 2025
Lanaform

Lanaform Luminescence Manual

16 November 2024
SilverCrest

SilverCrest KH2600 Manual

15 November 2024
Medel

Medel Infra Red Manual

23 Oktober 2024
Lumie

Lumie Brightspark Manual

15 September 2024
Innosol

Innosol Kubo Manual

9 September 2024
Lumie

Lumie Sunrise Alarm Manual

6 September 2024
Lumie

Lumie Bodyclock Spark 100 Manual

6 September 2024
Kogan

Kogan KAWAKLGT2SA Manual

5 September 2024