When using your iron, basic safety precautions should always be followed,
including the following:
■Read all instructions.
■Use iron only for its intended use.
■To protect against a risk of electric shock, do not immerse the iron in water or
other liquid.
■The iron should always be turned to O/FILL before plugging into or unplugging
from an outlet. Never yank cord to disconnect from outlet; instead grasp plug
and pull to disconnect.
■Do not allow cord to touch hot surfaces. Let iron cool completely before
putting away. Loop cord loosely around cord wrap when storing.
■Always disconnect iron from electrical outlet when filling with or emptying of
water and when not in use. Be careful to avoid spilling water over iron
when filling.
■Do not press the self clean button while ironing.
■Do not operate iron with a damaged cord or plug or if the iron has been
dropped or damaged.
■To avoid the risk of electric shock, do not disassemble the iron; instead, take it
to an authorized service center for examination and repair. Incorrect
reassembly can cause a risk of electric shock when the iron is used.
■Close supervision is necessary for any appliance being used by or near
children. Do not leave iron unattended while connected or on an ironing
board. Always position iron carefully to prevent it from falling if ironing board
is accidentally moved or cord is pulled. Always use Heel Rest.
■Burns can occur from touching hot metal parts, hot water, or steam. Use
caution when you turn a steam iron upside down — there may be hot water in
the water tank. Avoid rapid movement of iron to minimize hot water spillage.
■Do not operate in the presence of explosive and/or flammable fumes.
■The use of attachments not recommended or sold by the appliance
manufacturer may cause fire, electric shock or injury.
■Do not use iron outdoors.
■This product is for household use only.
SPECIAL INSTRUCTIONS
■To avoid a circuit overload, do not operate another high-wattage appliance
on the same circuit.
■If an extension cord is necessary, a 10-ampere rated cord should be used.
Cords rated for less amperage may overheat. Care should be taken to
arrange the cord so that it cannot be pulled on or tripped over.
2
SAVE THESE INSTRUCTIONS
