PART# BMX-2017
Blend
fflounf-®
Innovat
i
ve
Mount
i
ng
Solutions
ESCORT
PASSPORT
MAX
LEFT HAND DRIVE VEHICLE
111111111111111111111111111111
2802
09
6
INSTALLATION INSTRUCTIONS FOR THE ESCORT PASSPORT
MAX
RADAR
DETECTOR
Your rear
view
mirror
has minimal clearance between the back side
of
the
mirror
and the
mirror
stem.
It
is
very
important
that
this
mount
is installed
correctly
to
ensure
mirror
adjustability is retained.
PLEASE READ THESE INSTRUCTIONS THOROUGHLY BEFORE INSTALLING THIS MOUNT
NOTE: For illustration purposes, the mount and rear view mirror shown
in
these instructions may look
slightly different then YOUR mount and rear view mirror.
OPPOSING FORCES
BOTTOM OF SPRING CLIP
IS PARALLEL WITH
RD
1 -
The
RELEASE Button on the radar detector (RD) is
NOT
used with
this mount.
To
release the tension
of
the spring clip, simply squeeze the
TRIGGER and the back side
of
the mount together. This will lower the bottom
portion
of
the spring clip allowing you to slide the RD on and off. When used
properly, the spring clip avoids putting excessive pressure on the mirror stem
when installing and removing the RD.
The
top portion
of
the
mount
should
barely
move
when the
two
opposing forces are applied.
2 -
The
bottom
of
the spring clip
must
be parallel with the top
of
the RD
to
slide
in
and
out
. SLIDE THE RD
ONTO
THE SPRING
CLIP
AS
FAR
AS
IT
WILL
GO
. Release the trigger to secure the RD
onto the mount. Before installing the mount onto your rear view
mirror, remove and install the RD a few times so you can observe
how the spring clip functions.
TOP
SECTION
MID
SECTION
BODY
SECTION
TOP
AND
MID
SECTIONS
MUST
TOUCH
AT THE
PIVOT
POINT
BEFORE CLAMP
SCREW
IS FULLY TIGHTENED
3 - Loosen the clamp screw so the top section separates from the mid section. This will
provide the necessary clearance to slide the mount over the mirror stem as shown above.
Adjust the mirror parallel to the windshield
for
ease
of
installation. As you are tightening the
clamp screw, make sure the top and mid sections touch at the pivot point.
If
they
do
not
touch at the pivot point, this
mount
Is incompatible with
your
mirror
type
. Tighten the
clamp screw until the mount is slightly snug around the mirror stem.
4 - Position the mount as far forward as you
can. Before fully tightening the clamp screw,
make sure the bottom
of
the mount is parallel
with the bottom
of
the mirror.
lnnovativ D
1gn
And
Precision Manut cturlng
BlendMount - US
PATENT#
D625,580 S, D656,811 S, D653,980 S
0690
,245 S,
0690
,246 S,
0690
,247
Sand
other patents pending
PAGE 1 OF 2
