Bogen RIO1S Manual


Læs gratis den danske manual til Bogen RIO1S (8 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 95 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 48 anmeldelser. Har du et spørgsmål om Bogen RIO1S, eller vil du spørge andre brugere om produktet?

Side 1/8
RIO S1
Relay / Input / Output
Transformer-Balanced Module
Features
Transformer-isolated, balanced line-level input
600-ohm or 0k-ohm jumper-selectable input impedance1
Transformer-isolated, balanced line-level output
8-ohm, 750mW output
Input and output level controls
Relay responds to selectable priority level
External control of priority muting
N.O. or N.C. relay contacts
Input can be muted from higher priority modules, with signal fade back
Output can activate with relay priority level
Screw terminal strips
• RJ11 connection with line output and dedicated N.O. relay contact
© 2007 Bogen Communications, Inc.
54-2097-01F 0706
Specifications subject to change without notice.
2
Module Installation
1. Turn off all power to the unit.
2. Make all necessary jumper selections.
3. Position module in front of any desired module bay opening, making sure that
the module is right-side up.
4. Slide module onto card guide rails. Make sure that both the top and bottom guides
are engaged.
5. Push the module into the bay until the faceplate contacts the unit’s chassis.
6. Use the two screws included to secure the module to the unit.
WARNING:
Turn off power to unit and make all jumper
selections before installing module in unit.
Note:
This module may include a break-away tab as pictured below. If present, remove this
tab to install module in input module bays.


Produkt Specifikationer

Mærke: Bogen
Kategori: Ikke kategoriseret
Model: RIO1S

Har du brug for hjælp?

Hvis du har brug for hjælp til Bogen RIO1S stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Bogen Manualer

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer