Bogen WB1EZ Manual

Bogen Ikke kategoriseret WB1EZ

Læs gratis den danske manual til Bogen WB1EZ (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 23 personer og har en gennemsnitlig bedømmelse på 4.0 stjerner ud af 12 anmeldelser. Har du et spørgsmål om Bogen WB1EZ, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

A=10 feet

Easy DesignTM Speaker

Model WB1EZ

Speaker Layout

The layout of the speakers should be planned prior to

installation. Because wall baffle speakers are designed

to project forward, it is best to aim them in the same

direction, as this provides for both greater coverage and

clarity. You can use the buildingʼs roof pillars or other

available supports for mounting the wall baffles.

In some cases, it may be necessary to mount the wall

baffles on opposing walls. In these cases, the speakers

will project sound in opposing directions.

HALLWAY/ROOM - Wall baffle speakers work well with

rooms and hallways that are 20ʼ to 60ʼ wide. Layout

starts at one end of the hallway or room. The first

speaker should be installed 10ʼ from the end of the

hallway or room. The next speaker on that wall should

be installed 20ʼ from the first speaker, as should any

additional speakers required to cover the length of the

hallway or room.

The first speaker on the opposing wall should be

installed 20ʼ from the end of the hallway or room, there-

by staggering the speakers. Each additional speaker

should also be installed 20ʼ apart from the previous one.

See Figure 1.

OPEN AREA - The number of speakers needed to

cover an open area and the layout of those speakers is

contingent upon the availability of suitable mounting

points in the area to be covered.

Layout starts in one corner of the room. The first speaker

should be installed 10ʼ from the wall with each addition-

al speaker in the first row installed in increments of

20ʼ from the first. Based on , install the nextFigure 2

row of speakers 30ʼ from the first row and 20ʼ from the

wall with increments of 20ʼ between each speaker.

The third row would follow the example of the first and

each additional row would continue this pattern of alter-

nating rows until the whole area is covered.

Figure 2

Figure 1

20’ to 60’

10’

20’

SPEAKER

WALL

SPEAKER

START

B=20 feet

54-5069-01B 1209

Specifications subject to change without notice.

WALL

ANCHOR

Speaker Installation

STEP 1 - Mark the point from which to hang the speaker.

Drill an appropriately sized hole in the wall and insert an

anchor. Drive the screw into the anchor leaving enough of

the screw exposed from which to hang the speaker on.

See Figure 3.

NOTE: Wall baffle speakers should be installed between

8 and 16 feet from the floor depending upon need.

STEP 2 - Make the electrical connections using the 2 screw

terminals on the WB1EZ. The recommended amplifier

connections are:

(+) 70V terminal - 70V HOT

(-) COM terminal - 70V COMMON

NOTE: The speaker will also work perfectly well with

these connections reversed. However, it is important to

be consistent in the wiring of the speakers in the system.

If adjacent speakers have reversed wiring connections,

they will tend to cancel each otherʼs bass response,

thereby diminishing the sound quality.

STEP 3 - If it is necessary to adjust the volume, insert

a thin, flat blade screwdriver into the access hole at the

bottom of the wall baffle, then turn the volume control

clockwise (as viewed from the bottom of the baffle) to

increase the volume. To reduce the volume, simply turn

the volume control in a counterclockwise motion.

See Figure 4.

BACK OF SPEAKER

RECESSED VOLUME CONTROL

Turn in a clockwise motion

to increase volume.

BOTTOM

OF SPEAKER

www.bogen.com

Figure 3

Figure 4

The WB1EZ is warranted to be free from defects in material or workmanship for three (3) years from the date of sale to the original purchaser. Any part of the product

covered by this warranty that, with normal installation and use, becomes defective will be repaired or replaced by Bogen, at our option, provided the product is shipped

insured and prepaid to: Bogen Factory Service Department, 50 Spring Street, Ramsey, NJ 07446, USA. The product(s) will be returned to you freight prepaid. This warranty

does not extend to any of our products that have been subjected to abuse, misuse, improper storage, neglect, accident, improper installation or have been modified or

repaired or altered in any manner whatsoever, or where the serial number or date code has been removed or defaced.

THE FOREGOING LIMITED WARRANTY IS BOGEN'S SOLE AND EXCLUSIVE WARRANTY AND THE PURCHASER'S SOLE AND EXCLUSIVE REMEDY. BOGEN

MAKES NO OTHER WARRANTIES OF ANY KIND, EITHER EXPRESS OR IMPLIED, AND ALL IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR

A PARTICULAR PURPOSE ARE HEREBY DISCLAIMED AND EXCLUDED TO THE MAXIMUM EXTENT ALLOWABLE BY LAW. Bogen's liability arising out of the

manufacture, sale or supplying of products or their use or disposition, whether based upon warranty, contract, tort or otherwise, shall be limited to the price of the product.

IN NO EVENT SHALL BOGEN BE LIABLE FOR SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT

LIMITED TO, LOSS OF PROFITS,

LOSS OF DATA OR LOSS OF USE DAMAGES) ARISING OUT OF THE

MANUFACTURE, SALE OR SUPPLYING OF PRODUCTS, EVEN IF BOGEN HAS BEEN ADVISED

OF THE POSSIBILITY OF SUCH DAMAGES OR LOSSES. Some States do not allow the exclusion or limitation of incidental or consequential damages, so the above

limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from State to State.

Products that are out of warranty will also be repaired by the Bogen Factory Service Department -- same address as above or call 201-934-8500. The parts and labor involved

in these repairs are warranted for 90 days when repaired by the Bogen Factory Service Department. All shipping charges in addition to parts and labor charges will be

at the owner's expense. All returns require a Return Authorization number.

7/22/2008

Limited Warranty; Exclusion of Certain Damages

Produkt Specifikationer

Mærke:	Bogen
Kategori:	Ikke kategoriseret
Model:	WB1EZ
Vægt:	8618 g
Produktfarve:	Valnød
Wi-Fi:	Ingen
Bluetooth:	Ingen
Udgangseffekt (RMS):	1 W
Anbefalet brug:	Universel
Frekvensområde:	50 - 12000 Hz
Impedens:	4900 ohm (Ω)
Forbindelsesteknologi:	Ledningsført
Lyd-output kanaler:	1.0 kanaler
Højttaler, placering:	Kan monteres på væggen
Strømkilde type:	Vekselstrøm
Antal drivere:	1
Sensitivitet:	95 dB
Antal produkter inkluderet:	1 stk
Forstærker:	Indbygget
Højttaler kabinet:	Lukket
Subwoofer driver diameter (britisk):	8 "
Dybde (efter britisk standard):	5.25 "
Højde (efter britisk standard):	9.5 "
Bredde (efter britisk standard):	9.5 "