Broan L400KL Manual

Broan Ventilator L400KL

Læs gratis den danske manual til Broan L400KL (12 sider) i kategorien Ventilator. Denne vejledning er vurderet som hjælpsom af 3 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 2 anmeldelser. Har du et spørgsmål om Broan L400KL, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/12

MODELS

L400KL • L500KL

LOSONE SELECT

VENTILATORS

In-Line • 120V

READ AND SAVE THESE INSTRUCTIONS

Installer: Leave this manual with

the homeowner.

Homeowner: Use and Care

information on page 3.

Page 1

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY

TO PERSONS, OBSERVE THE FOLLOWING:

1. Use this unit only in the manner intended by the manufacturer. If

you have questions, contact the manufacturer at the address or

telephone number listed in the warranty.

2. Before servicing or cleaning unit, switch power off at service panel

and lock the service disconnecting means to prevent power from

being switched on accidentally. When the service disconnecting

means cannot be locked, securely fasten a prominent warning

device, such as a tag, to the service panel.

3. Installation work and electrical wiring must be done by a qualified

person(s) in accordance with all applicable codes and standards,

including fire-rated construction codes and standards.

4. Sufficient air is needed for proper combustion and exhausting of

gases through the flue (chimney) of fuel burning equipment to

prevent backdrafting. Follow the heating equipment

manufacturer’s guideline and safety standards such as those

published by the National Fire Protection Association (NFPA),

and the American Society for Heating, Refrigeration and Air Con-

ditioning Engineers (ASHRAE), and the local code authorities.

5. When cutting or drilling into wall or ceiling, do not damage elec-

trical wiring and other hidden utilities.

6. Ducted fans must always be vented to the outdoors.

7. To reduce the risk of fire, use only metal ductwork.

8. If this unit is to be installed over a tub or shower, it must be marked

as appropriate for the application and be connected to a GFCI

(Ground Fault Interrupter) - protected branch circuit.

9. Never place a switch where it can be reached from a tub or

shower.

10. This unit must be grounded.

TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:

1. Never leave surface units unattended at high settings. Boilovers

cause smoking and greasy spillovers that may ignite. Heat oils

slowly on low or medium settings.

2. Always turn hood ON when cooking at high heat or when cooking

flaming foods.

3. Clean ventilating fans frequently. Grease should not be allowed

to accumulate on fan or filter.

4. Use proper pan size. Always use cookware appropriate for the

size of the surface element.

TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT

OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING:*

1. SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal

tray, then turn off the burner. BE CAREFUL TO PREVENT BURNS.

If the flames do not go out immediately, EVACUATE AND CALL

THE FIRE DEPARTMENT.

2. NEVER PICK UP A FLAMING PAN - You may be burned.

3. DO NOT USE WATER, including wet dishcloths or towels - a

violent steam explosion will result.

4. Use an extinguisher ONLY if:

A. You know you have a Class ABC extinguisher and you already

know how to operate it.

B. The fire is small and contained in the area where it started.

C. The fire department is being called.

D. You can fight the fire with your back to an exit.

*Based on “Kitchen Firesafety Tips” published by NFPA.

TABLE OF CONTENTS

This manual is divided into sections as follows:

• “TYPICAL INSTALLATION”

This section shows a common installation in new and existing,

frame construction.

- Mounting (new construction)

- Mounting (existing construction)

- Wiring

- Ducting (straight-through blower discharge)

• “MOUNTING OPTIONS”

• “WIRING OPTIONS”

-Wiring Plate Position

• “DUCTING OPTIONS”

- Blower Discharge Positions

- Ducting (right angle blower discharge)

• “USE AND CARE”

• “SERVICE PARTS”

• “WARRANTY”

CAUTION

1. For general ventilating use only. Do not use to exhaust hazard-

ous or explosive materials and vapors.

2. To avoid motor bearing damage and noisy and/or unbalanced

impellers, keep drywall spray, construction dust, etc. off power

unit.

3. If ventilator is installed in an unconditioned space (such as

an attic): Surround the ventilator with thermal insulation - to mini-

mize possible condensation.

4. Please read specification label on product for further informa-

tion and requirements.

Page 2

MODELS

L400KL • L500KL

TYPICAL INSTALLATION

MOUNTING

(New Frame Construction)

CEILING

JOIST

(24” centers

shown)

10” ROUND DUCT

Factory-shipped unit installed in new construction.

MOUNTING

SCREW

Blower factory-shipped

in horizontal

discharge position.

Mounting brackets

factory-shipped in

position for ½”

ceiling material.

MOUNTING

(Existing Frame Construction)

Factory-shipped unit installed in existing construction.

TYPICAL INSTALLATION

WIRING

PLATE

WHITE

BLACK

TOP / BACK

OF HOUSING

120 VAC LINE IN

GROUND TO

WIRING PLATE

10” ROUND

DUCT

FINISHED

CEILING

MATERIAL

CEILING JOIST

(24” centers

shown)

2 X 4 FRAMING

(wide side down)

MOUNTING

BRACKETS

(Attached to

opposite sides

of housing &

upside-down,

so housing is

flush with

finished ceiling)

DUCTING

(Straight-through blower discharge)

Two ways to connect ductwork to a factory-shipped unit.

Ventilator can be wired from outside of housing.

Use UL approved connectors to wire per local codes.

ROOF CAP

10”

ROUND

ELBOW

10”

ROUND

DUCT

WALL

CAP

NOTE: Make sure the shipping tape is removed from the damper

flap and that damper flap opens and closes freely inside the

ductwork. Use duct tape to make ductwork connections secure and

air-tight.

4½” X 18½”

TO 10” ROUND

TRANSITION

MOUNTING

SCREW

4½” X 18½”

TO 10” ROUND

TRANSITION

4½” X 18½”

TO 10” ROUND

TRANSITION

10” ROUND

DUCT

4½” X 18½”

TO 10” ROUND

TRANSITION

10” ROUND

DUCT

4½” X 18½” TO 10”

ROUND TRANSITION

10”

ROUND

DUCT

Produkt Specifikationer

Mærke:	Broan
Kategori:	Ventilator
Model:	L400KL

Har du brug for hjælp?

Hvis du har brug for hjælp til Broan L400KL stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ventilator Broan Manualer

Broan Roomside AR80LWH Manual

7 Juli 2025

7 Juli 2025

7 Juli 2025

7 Juli 2025

7 Juli 2025

7 Juli 2025

7 Juli 2025

7 Juli 2025

7 Juli 2025

7 Juli 2025

Ventilator Manualer

Nyeste Ventilator Manualer

DeepCool UF120 Manual

7 Juli 2025

Soler & Palau CBM Manual

7 Juli 2025

Ideal ID6501 Manual

7 Juli 2025

Soler & Palau CTB ECOWATT Manual

7 Juli 2025

Soler & Palau CRHB/T N ECOWATT Manual

7 Juli 2025

Soler & Palau ILHT Manual

7 Juli 2025

Soler & Palau ILHB-ILHT ECOWATT Manual

7 Juli 2025

Soler & Palau EC-N Manual

7 Juli 2025

PAX Levante 30 Manual

7 Juli 2025

Soler & Palau CVAB/T-ECOWATT Manual

7 Juli 2025