Broan QTXE110150DCL Manual

Broan Ventilator QTXE110150DCL

Læs gratis den danske manual til Broan QTXE110150DCL (12 sider) i kategorien Ventilator. Denne vejledning er vurderet som hjælpsom af 29 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 15 anmeldelser. Har du et spørgsmål om Broan QTXE110150DCL, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/12

IMPORTANT -

The ducting from this fan to the outside of the building

has a strong effect on the air ﬂow, noise and energy use of the fan. Use

the shortest, straightest duct routing possible for best performance, and

avoid installing the fan with smaller ducts than recommended. Insulation

around the ducts can reduce energy loss and inhibit mold growth. Fans

installed with existing ducts may not achieve their rated airﬂow.

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO

PERSONS, OBSERVE THE FOLLOWING:

1. Use this unit only in the manner intended by the manufacturer. If

you have questions, contact the manufacturer at the address or

telephone number listed in the warranty.

2. Before servicing or cleaning unit, switch power off at service panel

and lock the service disconnecting means to prevent power from

being switched on accidentally. When the service disconnecting

means cannot be locked, securely fasten a prominent warning

device, such as a tag, to the service panel.

3. Installation work and electrical wiring must be done by a qualiﬁed

person(s) in accordance with all applicable codes and standards,

including ﬁre-rated construction codes and standards.

4. Sufﬁcient air is needed for proper combustion and exhausting of

gases through the ﬂue (chimney) of fuel burning equipment to

prevent backdrafting. Follow the heating equipment manufacturer’s

guideline and safety standards such as those published by the

National Fire Protection Association (NFPA), and the American

Society for Heating, Refrigeration and Air Conditioning Engineers

(ASHRAE), and the local code authorities.

5. When cutting or drilling into wall or ceiling, do not damage electrical

wiring and other hidden utilities.

6. Ducted fans must always be vented to the outdoors.

7. Use only ON/OFF switch, mechanical timer or relay-switched

control.

8. Acceptable for use over a tub or shower when connected to a GFCI

(Ground Fault Circuit Interrupter) - protected branch circuit.

9. This unit must be grounded.

READ AND SAVE THESE INSTRUCTIONS

Cooking

Equipment

Floor

COOKING AREA

Do not install above or

inside this area.

NOT FOR USE IN

A COOKING AREA.

CAUTION

1. For general ventilating use only. Do not use to exhaust hazardous

or explosive materials and vapors.

2. This product can be installed in a wall if mounted 8-ft. or more

above the ﬂoor.

3. To avoid motor bearing damage and noisy and/or unbalanced

impellers, keep drywall spray, construction dust, etc. off power

unit.

4. Please read speciﬁcation label on product for further information

and requirements.

CLEANING & MAINTENANCE

For quiet and efﬁcient operation, long life, and attractive appearance

- lower or remove grille and vacuum interior of unit with the dusting

brush attachment.

The motor is permanently lubricated and never needs oiling. If the

motor bearings are making excessive or unusual noises, replace the

blower assembly (includes motor and impeller).

OPERATION

The fan and light can be operated separately. Use a 2-function wall

control.

Do not use a speed control.

QT DC Series Fan/Light

For Warranty Statement, Service Parts, Technical Support, or to

In the United States - broan-nutone.com 800-637-1453 or 888-

336-6151. In Canada - broan-nutone.ca 877-896-1119

ROOF CAP*

(with built-in

damper)

WALL CAP*

(with built-in

damper)

6-IN. ROUND

ELBOWS*

6-IN. ROUND

DUCT*

FAN

HOUSING

Seal gaps

around

housing.

Seal duct

joints with

tape.

Keep duct

runs short.

INSULATION

(Place around and

over fan housing.)

POWER

CABLE*

*Purchase

separately.

INSTALLATION STEPS

Some models only:

Select 110, 130 or 150

CFM based on your

room size and

desired

air ow.

Housing

mounted to

I-joists.

Use I-joist

spacer block

(provided).

Housing

mounted

anywhere

between

I-joists

using

hanger bars.

Housing

mounted to

joists.

Housing

mounted

anywhere

between

joists

using

hanger bars.

Housing

mounted to

truss.

Housing mounted

anywhere between

trusses using

hanger bars.

TYPICAL INSTALLATIONS

110 130 150

Plug-in and

secure blower

to housing.

Screws from

parts bag

Mount housing to joist.

SPACER

(use for

mounting

to I-Joist)

I-JOIST

Hold housing in place so

that bottom edge of housing

will be ﬂush with ﬁnished

surface of ceiling. For

1/2” thick ceiling material,

position bottom of each

mounting ﬂange ﬂush with

the bottom of joist. The

housing mounts with four

(4) screws or nails. Screw or nail housing to joist through lowest

holes in each mounting ﬂange, then through highest holes.

NOTE: Mounting to I-JOIST (shown) requires use of SPACERS

(included) between the highest hole of each mounting ﬂange and

the I-joist.

Produkt Specifikationer

Mærke:	Broan
Kategori:	Ventilator
Model:	QTXE110150DCL

Har du brug for hjælp?

Hvis du har brug for hjælp til Broan QTXE110150DCL stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ventilator Broan Manualer

Broan QTXEG110 Manual

7 August 2025

Broan ZB80L1 Manual

8 Juli 2025

Broan LP510R Manual

7 Juli 2025

Broan L500 Manual

7 Juli 2025

Broan Roomside AR80LWH Manual

7 Juli 2025

7 Juli 2025

7 Juli 2025

7 Juli 2025

7 Juli 2025

7 Juli 2025

Ventilator Manualer

Nyeste Ventilator Manualer

Grunkel MET-H16 Industrial Manual

14 September 2025

Grunkel SKYWIND-42BT Manual

13 September 2025

Grunkel TF-I45W Manual

13 September 2025

Create Air Mist Manual

13 September 2025

Antari AF-3X Manual

13 September 2025

MPM MWP-32 Manual

13 September 2025

Grunkel BreezeCraft FAN-165R Manual

13 September 2025

Be Cool BC18STTIDC Manual

11 September 2025

NuTone QTXN110HL Manual

10 September 2025

NuTone 744LEDNT Manual

10 September 2025