BT Video Baby Monitor 2000 Manual

BT Babyalarm Video Baby Monitor 2000

Læs gratis den danske manual til BT Video Baby Monitor 2000 (2 sider) i kategorien Babyalarm. Denne vejledning er vurderet som hjælpsom af 44 personer og har en gennemsnitlig bedømmelse på 3.9 stjerner ud af 22.5 anmeldelser. Har du et spørgsmål om BT Video Baby Monitor 2000, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

How to recycle your equipment

The symbol shown here and on the

product means that the product is

classed as electrical or electronic

equipment, so DO NOT put it in

your normal rubbish bin.

It’s all part of the Waste Electrical and

Electronic Equipment (WEEE) Directive to

recycle products in the best way – to be

kinder to the planet, get rid of dangerous

things more safely and bury less rubbish

in the ground.

You should contact your retailer or

supplier for advice on how to dispose

of this product in an environmentally

friendly way.

Radio Equipment Directive

Declaration of Conformity

Hereby, British Telecommunications plc

declares that the radio equipment type BT

Video Baby Monitor 2000 (088303) is in

compliance with Directive 2014/53/EU.

This device has been evaluated for

and shown compliant with European

Guidelines when installed and operated

with a minimum distance of 16mm

between the unit and your body.

The item code for both power supply

units is 089009 (BLJ06W050060P1-B).

The full text of the EU declaration of

conformity is available at the following

internet address: bt.com/producthelp

Radio transmission information

Frequency range 2415.375 –

2471.625MHz

Max power 89.54mW (19.52dBm)

General information

Welcome

Thanks for buying a BT Baby Monitor. You’ll soon

be able to relax knowing you can watch and listen

for your baby’s every breath, gurgle and wriggle.

But rst things rst. To get set up, just follow the steps

opposite. If you need any help, go to bt.com/producthelp

or give us a call on 0808 100 6554*.

Getting set up

Registered Oce: 81 Newgate Street, London EC1A 7AJ. Registered in England No. 1800000

Designed and produced by The Art & Design Partnership (ADP). Printed in China / Issue 4 / ADP12-17

Important safety notices

1. Your baby monitor is designed as just an aid.

It isn’t a substitute for responsible and proper

adult supervision.

2. Make sure all cables and units are out of your baby’s

reach – at least one metre away.

3. Never cover either unit, put them in moist places or

inside the cot, bed or playpen.

4. If you travel abroad, check the voltage on your unit’s

plugs match the local power output.

5. Do not take the product apart. If you need repairs,

get in touch with our helpdesk.

1 Plug the cable into the Parent unit, then plug it into the

mains power socket and switch the socket on.

2 Leave to charge for .12 hours

Tip

The rst time you use the Parent unit, or if you haven’t

used it for a long time, it’ll take 12 hours to fully charge.

When the battery gets very low, it’ll take about 30

minutes to charge enough for you to use it for a

short time.

To charge the Parent unit in the shortest amount of time,

turn it o while it’s charging.

3 Place the Baby unit near a power socket in the room

where you’re going to be monitoring your baby most of

the time. It should also be at least one metre away from

your baby.

4 Plug the cable into the Baby unit, then plug it into the

mains power socket and switch the socket on.

5 Slide the

Oﬀ

button on the side of the Baby unit

up to turn it on.

Tip

Keep the power cord out of baby’s reach by looping any

extra length and securing it.

Link

Help and troubleshooting

If you have any problems setting up or using your baby

monitor, see if these common questions can help

My Parent/Baby unit isn’t working. What should I do?

Check that:

1 power cables are plugged in and switched on at the

wallsocket

2 the Baby unit is plugged in and the Parent unit battery

is fully charged (for 12 hours)

3 both units are turned on

4 the Parent unit isn’t too far from the Baby unit (large

obstructions or other electrical devices might aect the

signal between the Parent and Baby unit).

5 unplugging the power cables, waiting about 15 seconds,

and then plugging them back in can help.

My Parent/Baby unit is making a high-pitched noise.

Whatshould I do?

The units might be too close together. Make sure they’re

at least one metre apart.

Why is my Parent unit beeping?

The Parent unit beeps when:

• the Baby unit is turned o

• the units are too far apart – try moving them closer

together (but not closer than one metre)

• the battery in the Parent unit isn’t charged – try charging

it for 12 hours

• Other electronic items, like TVs and mobile phones, are

causing interference – try moving the Baby unit away

from things like that.

Why is the Parent unit not making any sounds even

though there’s noise coming from my baby’s room?

• the Parent unit might not be fully charged – make sure

it’s charged (for 12 hours).

• the speaker volume might be switched o.

• the Parent unit might be out of range of the Baby unit –

try moving it closer (but not closer than one metre).

• large obstructions or other electrical devices might

be aecting the signal between the Parent and Baby

units). Try moving the Baby unit away from obstructions,

including electrical appliances like TVs or mobile phones.

Still stuck?

Try bt.com/producthelp 0808 100 6554 or call us on *.

Guarantee

Your Video Baby Monitor 2000 is

guaranteed for a period of 24 months

from the date of purchase.

Subject to the terms listed below, the

guarantee will provide for the repair of,

or at BT’s or its agent’s discretion the

option to replace the Video Baby Monitor

2000, or any component thereof, which

is identied as faulty or below standard,

or as a result of inferior workmanship or

materials. Products over 28 days old from

the date of purchase may be replaced

with a refurbished or repaired product.

The conditions of this guarantee are:

• The guarantee shall only apply to

defects that occur within the 24 month

guarantee period.

• Proof of purchase is required.

• The equipment is returned to BT or its

agent as instructed.

This guarantee does not cover any faults

or defects caused by accidents, misuse,

fair wear and tear, neglect, tampering

with the equipment, or any attempt at

adjustment or repair other than through

approved agents.

This guarantee does not aect your

statutory rights.

To nd out what to do, if your monitor is

in or outside of the 24 month guarantee,

go to bt.com/producthelp

6 After the Parent unit has charged for 12 hours you can

switch it on.

Before you do, move the Parent unit at least one metre

from the Baby unit. Any closer and you might get audio

feedback sounds.

Press the button

and hold for two

seconds to turn

the Parent unit on.

The Parent and Baby unit are automatically linked so

they are now ready to use.

What’s the range?

The maximum range between your Parent and Baby

units is about 250 metres outdoors and about 50 metres

indoors. Thick walls and doors reduce the units’ range

and aect how they link to each other.

Video Baby Monitor 2000

User Guide

Link

OnOﬀ

Set the screen to turn on and o automatically

You can set the screen to turn on by pressing any button.

On this setting, the screen will turn o automatically

when no button is pressed during 1, 3 or 5 minutes.

1. Press , then press to display and press .

2. Press and to select , or minutes and 1 3 5

press .

3. To turn the screen back on at any time, press any button.

If you want to set the screen on all the time, set the

screen setting . to o

Turn sound activated screen mode on or o

When set to On, the screen will turn on if noise is

detected from the Baby unit. If it’s set to O, the screen

will stay o even if noise is detected. To use this feature,

you need to set the standby mode rst to 1, 3 or 5

minutes as described above.

1. Press , then press to display and press .

2. Press and to select (for On) or (for O)

and press .

3. To turn the screen back on at any time, press the .

Other screen icon descriptions

Using the Baby unit

Turn on and o

1. Slide the

Oﬀ

button on the side of the unit up to

turn On and press down to turn O.

Night vision

So that you can see your baby at night, the Baby unit

automatically uses the light from its infrared LED lights

to capture images in a dark room. Because of that, it can

only show images in black and white.

The icon will be displayed at the top of the screen.

Link button

The units are pre-linked.

(Link button used if re-link ever required).

Power on/o

Slide button up to

turn on and slide

down to turn o.

Get to know your Baby unit

Get to know your Parent unit

Charging/

battery light

Blue when mains

power adapter on, red

when battery low.

Power on light

Green when Parent unit turned on.

(Remains green for one minute

while charging, after the parent

unit is turned o).

Sound level display

LED lights show the level of

sound being detected from

the Baby unit.

Press and hold to turn

the unit on and o.

Press once to switch to

standby mode.

Press to open the

main menu.

Press to scroll up or

down when you’re

in the menu.

Press to increase

or decrease the

speaker volume.

Press to move

left or right in

the menu or

increase or

decrease the

brightness level.

Power

socket

Stand

Manual pan and tilt

Gently move

the camera to

adjust the angle.

Press to select

an option in

the menu.

Using the Parent unit

Turn on and o

Press and hold for 2 seconds to turn on and o.

Using the menu

• Press to open the main menu. Scroll through the

menu options using and . When the menu

option you want is displayed, press . Use or

to scroll through the sub menus and press to select.

• Press to exit the menu and return to the main

monitoring screen.

Monitoring volume and mute

There are 8 volume settings.

1. In monitor mode, press or to change the volume.

2. Press to conrm.

3. To turn the sound o completely, turn the volume down

to 0. will be displayed on top of the screen.

Screen brightness

There are 8 brightness levels. The default is 4.

1. In monitor mode, press or to select the

brightness level.

2. Press to conrm.

Zoom in and out

1. Press . The camera zooms in, the middle of the screen

shows and the zoom icon , , , is displayed

at the top.

2. Press , , or to move the image.

3. Press to exit zoom mode.

Set a reminder

You can set an alert to remind you of something you need

to do, for example when your baby’s next feed is due. You

can set it for 2, 4 or 6 hours.

1. Press , then press to display and press .

2. Press or to select the reminder time ( , or 2H 4H

6H), then press to save. The will be displayed on

the top right of the screen.

3. To cancel the alert, select . Press to enter

zoom mode.

Power socket

Speaker

* Calls made from within the UK mainland network are free. Mobile and international call costs may vary.

Need some help?

Frequently asked questions are available online.

bt.com/producthelp

If you cannot nd the answer to your question online, call our

free Helpline. Our dedicated advisors are more likely to be able to

help you than the retailer where you bought your baby monitor.

0808 100 6554*

This user guide is also available in other formats: large print,

Braille and audio CD. Call the helpline for a copy.

Camera

Add camera Delete camera View camera Signal strength

Baby unit switched on

Camera identication

number e.g. Camera 1

Sound on

Mute

Battery status (Full battery

shown, scrolling when charging)

OnOﬀ

Produkt Specifikationer

Mærke:	BT
Kategori:	Babyalarm
Model:	Video Baby Monitor 2000

Har du brug for hjælp?

Hvis du har brug for hjælp til BT Video Baby Monitor 2000 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Babyalarm BT Manualer

BT Pacifier Manual

27 August 2024

BT Video Baby Monitor 6000 Manual

27 August 2024

BT Video Baby Monitor 3000 Manual

27 August 2024

BT Video Baby Monitor 7500 Lightshow Manual

27 August 2024

BT Video Baby Monitor 2000 Manual

27 August 2024

BT 250 Manual

27 August 2024

BT 150 Manual

27 August 2024

BT 200 Manual

12 August 2024

Babyalarm Manualer

Nyeste Babyalarm Manualer

Neno Ivo Manual

7 August 2025

Babymoov YOO Go Plus Manual

1 August 2025

Dragon Touch E40 Manual

30 Juli 2025

Dragon Touch BabyCare E40 Manual

29 Juli 2025

Dragon Touch DT24 Pro Manual

29 Juli 2025

Dragon Touch DT40 Manual

29 Juli 2025

Panasonic KX-HN1032 Manual

26 Juli 2025

Neno Gato 2 Manual

23 Juli 2025

Alecto DBX135 Manual

15 Juli 2025

British Telecom Baby Monitor 100 Manual

14 Juli 2025