How to recycle your equipment
The symbol shown here and on the 
product means that the product is 
classed as electrical or electronic 
equipment, so DO NOT put it in  
your normal rubbish bin. 
It’s all part of the Waste Electrical and 
Electronic Equipment (WEEE) Directive to 
recycle products in the best way – to be 
kinder to the planet, get rid of dangerous 
things more safely and bury less rubbish 
in the ground.
You should contact your retailer or 
supplier for advice on how to dispose 
of this product in an environmentally 
friendly way.
Radio Equipment Directive 
Declaration of Conformity
Hereby, British Telecommunications plc 
declares that the radio equipment type BT 
Video Baby Monitor 6000 (088306) is in 
compliance with Directive 2014/53/EU.
This device has been evaluated for 
and shown compliant with European 
Guidelines when installed and operated 
with a minimum distance of 16mm 
between the unit and your body.
The item code for both power supply units 
is  .089010 (BLJ06W050100P1-B)
The full text of the EU declaration of 
conformity is available at the following 
internet address: bt.com/producthelp
Radio transmission information
Frequency range 2415.375 – 
2471.625MHz
Max power 81.28mW (19.1dBm)
General information
Welcome
Thanks for buying a BT Baby Monitor. You’ll soon 
be able to relax knowing you can watch and listen 
for your baby’s every breath, gurgle and wriggle.
But rst things rst. To get set up, just follow the steps 
opposite. If you need any help, go to bt.com/producthelp 
or give us a call on 0808 100 6554*.
Getting set up
© British Telecommunications plc 2017.
Registered Oce: 81 Newgate Street, London EC1A 7AJ. Registered in England No. 1800000
Designed and produced by The Art & Design Partnership (ADP). Printed in China / Issue 4 / ADP12-17
Important safety notices
1.   Your baby monitor is designed as just an aid. 
It isn’t a substitute for responsible and proper 
adult supervision.
2.   Make sure all cables and units are out of your baby’s 
reach – at least one metre away.
3.   Never cover either unit, put them in moist places or 
inside the cot, bed or playpen.
4.   If you travel abroad, check the voltage on your unit’s 
plugs match the local power output.
5.   Do not take the product apart. You can’t change 
the battery installed in the Parent unit. If you need 
repairs, get in touch with our helpdesk.
1 Plug the cable into the Parent unit, then plug it into the 
mains power socket and switch the socket on.
2 Leave to charge for  .12 hours
Tip
The rst time you use the Parent unit, or if you haven’t 
used it for a long time, it’ll take 12 hours to fully charge.
The battery life on a single charge lasts for 4 hours. 
We recommend you keep the cable plugged into the 
mains power socket if you’re going to use for longer than 
this or throughout the night.
When the battery gets very low, it’ll take about 30 
minutes to charge enough for you to use it for a  
short time. To charge the Parent unit in the shortest 
amount of time, turn it o while it’s charging.
3 Place the Baby unit near a power socket in the room 
where you’re going to be monitoring your baby most of 
the time. It should also be at least one metre away from 
your baby.
4 Plug the cable into the Baby unit, then plug it into the 
mains power socket and switch the socket on.
5 Slide the 
 button on the side of the Baby unit 
up to turn it on.
Tip
Keep the power cord out of baby’s reach by looping any 
extra length and securing it.
Link
Troubleshooting
My Parent/Baby unit isn’t working. What should I do?
Check that:
1 power cables are plugged in and switched on at the 
wallsocket
2 the Baby unit is plugged in and the Parent unit battery 
is fully charged (for 12 hours) 
3 both units are turned on
4 the Parent unit isn’t too far from the Baby unit (large 
obstructions or other electrical devices might aect the 
signal between the Parent and Baby unit).
5 unplugging the power cables, waiting about 15 seconds, 
and then plugging them back in can help.
My Parent/Baby unit is making a high-pitched noise. 
Whatshould I do?
The units might be too close together. Make sure they’re 
at least one metre apart, even when you’re using the 
button.
Why is my Parent unit beeping?
The Parent unit beeps when:
•  the Baby unit is turned o
•  the units are too far apart – try moving them closer 
together (but not closer than one metre)
•  the battery in the Parent unit isn’t charged – try charging 
it for 12 hours
•  Other electronic items, like TVs and mobile phones, are 
causing interference – try moving the Baby unit away 
from things like that.
Why is the Parent unit not making any sounds even 
though there’s noise coming from my baby’s room?
•  the Parent unit might not be fully charged – make sure 
it’s charged (for 12 hours). 
•  the speaker volume might be switched o. 
•  the Parent unit might be out of range of the Baby unit – 
try moving it closer (but not closer than one metre). 
•  large obstructions or other electrical devices might 
be aecting the signal between the Parent and Baby 
units). Try moving the Baby unit away from obstructions, 
including electrical appliances like TVs or mobile phones.
6 After the Parent unit has charged for 12 hours you can 
switch it on.
Before you do, move the Parent unit at least one metre 
from the Baby unit. Any closer and you might get audio 
feedback sounds.
Press the   button and hold for 2 seconds to turn the 
Parent unit on.
The Parent and Baby unit are automatically linked so 
they are now ready to use.
What’s the range?
The maximum range between your Parent and Baby 
units is about 250 metres outdoors and about 50 metres 
indoors. Thick walls and doors reduce the units’ range 
and aect how they link to each other.
Guarantee
Your Video Baby Monitor 6000 is 
guaranteed for a period of 24 months 
from the date of purchase.
Subject to the terms listed below, the 
guarantee will provide for the repair of, 
or at BT’s or its agent’s discretion the 
option to replace the Video Baby Monitor 
6000, or any component thereof, which 
is identied as faulty or below standard, 
or as a result of inferior workmanship or 
materials. Products over 28 days old from 
the date of purchase may be replaced 
with a refurbished or repaired product.
The conditions of this guarantee are:
•  The guarantee shall only apply to 
defects that occur within the 24 month  
guarantee period.
•  Proof of purchase is required.
•  The equipment is returned to BT or its 
agent as instructed.
This guarantee does not cover any faults 
or defects caused by accidents, misuse, 
fair wear and tear, neglect, tampering 
with the equipment, or any attempt at 
adjustment or repair other than through 
approved agents.
This guarantee does not aect your  
statutory rights.
To nd out what to do, if your monitor is 
in or outside of the 24 month guarantee,  
go to bt.com/producthelp
Mic
Menu
OK
Talk
Need some help?
Frequently asked questions are available online.
  bt.com/producthelp
If you cannot nd the answer to your question online, 
call our free Helpline. Our dedicated advisors are more 
likely to be able to help you than the retailer where you 
bought your baby monitor.
    0808 100 6554*
This user guide is also available in other formats: large 
print, Braille and audio CD. Call the helpline for a copy.
* Calls made from within the UK mainland network are free. 
Mobile and international call costs may vary.
Video Baby Monitor 6000
User Guide