Café CTS90DP2NS1 Manual

Café Ovn CTS90DP2NS1

Læs gratis den danske manual til Café CTS90DP2NS1 (24 sider) i kategorien Ovn. Denne vejledning er vurderet som hjælpsom af 10 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 5.5 anmeldelser. Har du et spørgsmål om Café CTS90DP2NS1, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/24
BEFORE YOU BEGIN
Read these instructions completely and
carefully.
• IMPORTANT — Save these
instructions for local inspector’s use.
• IMPORTANT — Observe all
governing codes and ordinances.
• Note to Installer – Be sure to leave these
instructions with Consumer.
• Note to Consumer – Keep these
instructions for future reference.
• Skill level – Installation of this appliance
requires a qualified installer or electrician.
• Proper installation is the responsibility
of the installer.
• Product failure due to improper installation
is not covered under Warranty.
• Product is for indoor use only.
Installation Instructions
27” & 30” Electric Built-In Wall Ovens
FOR YOUR SAFETY:
WARNING
Before beginning the installation, switch power off at the service panel and lock
the service disconnecting means to prevent power from being switched on accidentally. When the
service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a
tag, to the service panel.
Be sure the oven is securely installed in a cabinet that is firmly attached to the house structure. Weight
on the oven door could cause the oven to tip and result in injury. Never allow anyone to climb, sit,
stand or hang on the oven door.
Make sure the wall coverings, counters and cabinets around the oven can withstand the heat (up to
200°F [93.3°C]) generated by the oven.
MATERIALS YOU MAY NEED
Junction Box
Wire Nuts
Strain Relief Clamp for 1/2” Conduit
36” (91 cm) of String
TOOLS YOU MAY NEED
1/8” Drill Bit and Electric or Hand Drill
T20 Screwdriver
Phillips Screwdriver
Wire Strippers
7/16” Nut Driver (combination ovens)
1/4” Nut Driver (30” combination ovens)
ATTENTION INSTALLER: All electric wall ovens must be hard-wired (direct-wired)
into an approved junction box. A plug and receptacle is NOT permitted on these products.
Questions? Call us at 1.800.432.2737 or visit GEAppliances.com.
In Canada, call 1.800.561.3344 or visit GEAppliances.ca.
1 REMOVE PACKAGING MATERIALS
Failure to remove packaging materials could result in damage to the appliance. Remove all
packing parts from oven, racks and heating elements. Remove protective film and labels on
the outer door and control panel. Also, remove plastic on trims and panel, all tape around the
oven and any shipping screws securing the oven to the base pad. Open oven door and remove
literature pack and oven racks. Remove the bottom trim from the top of the oven. It will be
installed at the end of the installation process. The trim is wrapped separately and taped to the top
of the unit. Remove pedestal rails from separate box and set aside (30” Double Wall Ovens Only).
Consider recycling options for your appliance packaging material.
2 PREPARE THE OPENING
NOTE: If the cabinet does not have a solid
bottom, two braces or runners must be
installed to support the weight of the oven.
For single ovens, the runners and braces
must support 220 lbs (99 kg). For double and
combination ovens, the runners and braces
must support 400 lbs. (181 kg).
NOTE: If marks, blemishes or the cutout
opening are visible above the installed oven,
it may be necessary to add wood shims
under the runners until the marks or opening
are covered.
NOTE: If the cabinet does not have a front
frame and the sides are less than ¾” (1.9 cm)
thick, shim both sides equally to establish the
cutout width.
DESIGN INFORMATION
SINGLE OVEN INSTALLATIONS
The single oven may be installed in a cabinet alone or above a warming drawer. The single oven
may also be installed side by side, below a countertop, or below specified cooktops. See the label
on top of the oven for approved models.
DOUBLE AND COMBINATION OVEN INSTALLATIONS
A double or combination oven may be installed in a cabinet alone or above a warming drawer.
See the label on top of the oven for approved models.
IMPORTANT: Always refer to individual installation instructions packed with each product for
specific requirements.
Suitable
Bracing
to Support
Runners
2" x 4" (5 cm x 10 cm)
or Equivalent Runners Level
with Bottom of Cutout
and Flush with Sides of Cutout
C
L

Produkt Specifikationer

Mærke: Café
Kategori: Ovn
Model: CTS90DP2NS1

Har du brug for hjælp?

Hvis du har brug for hjælp til Café CTS90DP2NS1 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ovn Café Manualer

Café

Café Couture C9OAAAS2RS3 Manual

21 Juni 2025
Café

Café Couture C9OAAAS4RW3 Manual

20 Juni 2025
Café

Café Couture C9OAAAS3RD3 Manual

20 Juni 2025
Café

Café CEP90301NBB Manual

19 Februar 2025
Café

Café CTS90FP2NS1 Manual

4 Januar 2025
Café

Café CTD90DM2NS5 Manual

4 Januar 2025
Café

Café CTD90FP2NS1 Manual

4 Januar 2025
Café

Café CSB912M2NS5 Manual

4 Januar 2025
Café

Café CMB903P2NS1 Manual

4 Januar 2025
Café

Café CEP90362TSS Manual

4 Januar 2025

Ovn Manualer

Nyeste Ovn Manualer

BEKO

BEKO B45EAB Manual

3 November 2025
Haier

Haier HWO90S17TPB3 Manual

3 November 2025
BEKO

BEKO BBOB91271MDX Manual

3 November 2025
Haier

Haier HWO60S16TPB5 Manual

3 November 2025
Neff

Neff B4ACF1AN3B Manual

2 November 2025
Frigor

Frigor OV60BA Manual

1 November 2025
TurboTronic

TurboTronic TurboWave TT-EVS38 Manual

1 November 2025
Haier

Haier HWO60S14TPB6 Manual

1 November 2025
Tornado

Tornado TEO-48DGE Manual

31 Oktober 2025
Whirlpool

Whirlpool WOI5S8HM0SX Manual

31 Oktober 2025