Caliber MCD 171 Manual

Caliber Bilradio MCD 171

Læs gratis den danske manual til Caliber MCD 171 (36 sider) i kategorien Bilradio. Denne vejledning er vurderet som hjælpsom af 12 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 6.5 anmeldelser. Har du et spørgsmål om Caliber MCD 171, eller vil du spørge andre brugere om produktet?

Side 1/36
E N G L I S H
1
S P E C I F I C A T I O N S
GENERAL
Power Supply DC 11 -14V
Polarity Negative Ground
Speaker impedance 4 ohms
Power Output 4 x 55W
CD PLAYER
System Compact disc audio system
Usable disc Compact disc
Sampling frequency 44.1KHz
No of quantization bits 1bit
Frequency 5-20,000Hz
Number of channels 2 stereo
S/N Ratio 90dB
RADIO SECTION
FM
Frequency Range 87.5-108 Mhz
Usable Sensitivity Better than 15dB at S/N 30 dB
Stereo Separation 25 dB at 1KHz
S/N Ratio 50 dB
AM/MW
Frequency Range 522-1620 Khz
Intermediate Frequency 450KHz
Usable Sensitivity Better than 45dB
S/N Ratio 40 dB
REMARK :
Specifications subject to change without notice.
1. PANEL RELEASE BUTTON
2. PEQ (FLAT-CLASSIC-POPM-ROCKM-DSP OFF)
3. AF BUTTON
4. TA BUTTON
5. PTY BUTTON
6. DISC EJECT
7. POWER BUTTON
8. ROTARY VOLUME KNOB
AUDIO SELECT BUTTON/ MP3 FILE SEARCH
9. MODE BUTTON
10. AUTOMATICALLY STORE/PRESET SCAN (AS/PS)/MENU BUTTON
11.PRESET STATIONS BUTTONS (1~6)
12.PAUSE BUTTON
13.INTRO BUTTON
14.REPEAT BUTTON
15.SHUFFLE (RANDOM) BUTTON
16.PREVIOUS FOLDER BUTTON
17.NEXT FOLDER BUTTON
18.AUX IN JACK
19.BAND/LOUD/MP3 ENTER BUTTON
20.TUNING UP/DOWN,TRACK UP/DOWN BUTTONS
21.DISPLAY BUTTON/ MP3 ID3 BUTTON
22.RESET BUTTON
E N G L I S H
2
D I S C P L A Y
P R E C A U TI O N S
Use only in a 12-volt DC negative-ground electrical system.
Disconnect the vehicle's negative battery terminal while mounting and connecting the
unit.
When replacing the fuse, be sure to use one with an identical amperage rating.
Using a fuse with a higher amperage rating may cause serious damage to the unit.
DO NOT attempt to disassemble the unit. Laser beams from the optical pickup are dan-
gerous to the eyes.
Make sure that pins or other objects do not get inside the unit; they may cause mal-
functions, or create safety hazards such as electrical shock or laser beam exposure.
If you have parked the car for a long time in hot or cold weather, wait until the tem-
perature in the car become normal before operating the unit.
Keep the volume at a level at which you can hear outside warning sounds (horns
sirens, etc.).
CD NOTE S
Playing a defective or dusty CD can cause dropouts in sound.
Hold CDs as illustrated.
DO NOT touch the unlabeled side.
DO NOT attach any seal, label or data protection sheet to either side of a disc.
DO NOT expose a CD to direct sunlight or excessive heat.
Wipe a dirty CD from the center outward with a cleaning cloth.
Never use solvents such as benzine or alcohol.
This unit cannot play 3-inch ( 8cm ) CDs.
NEVER insert a 3-inch CD contained in the adapter
or an irregularly shaped CD.
The unit may not be able to eject it, resulting in a
malfunction.
B E F O R E OP E R ATI O N
DO NOT raise the volume level too much, as this
will block outside sounds, making driving dangerous.
Stop the car before performing any complicated
operation.
C A U T I O N
DO NOT open covers and do not repair by yourself.
Consult the dealer or an experienced technician for help.
Installation procedures
First complete the electrical connections, and then
check them for correctness.
Anti-Theft System
This unit is equipped with a detachable panel.
Removing this panel makes the radio totally inoperable.
Removing the panel
1. Switch off the power of the unit.
2. Remove the detachable panel (REL button).
3. Gently press the button of the case and open the
cover. Place the panel into the case and take it with you
when you leave the car.
Install detachable panel
1.Fix right part of face plate in the right part of panel slot
of the unit.
2.Press down the left side of the face plate until it clicks
into the panel slot of the unit.
Remove the unit
Switch of the power of the unit.
1. Remove the panel and the trim plate.
2. Insert both T-Keys into hole in front of the set until
they lock.
3. Pull out the unit.
1. Insert mounting bracket into the
dashboard, and bend the mounting
tabs out with a screwdriver. (Make
sure that lock lever is flush with
the mounting bracket. Not projec-
ting outward)
2. Secure the rear of the unit After
fixing mounting bolt and power
connector, fix the rear of the unit
to the car body by rubber cushion.
3. Insert trimplate


Produkt Specifikationer

Mærke: Caliber
Kategori: Bilradio
Model: MCD 171

Har du brug for hjælp?

Hvis du har brug for hjælp til Caliber MCD 171 stil et spørgsmål nedenfor, og andre brugere vil svare dig