Canarm GSQ135-D Manual

Canarm Ventilator GSQ135-D

Læs gratis den danske manual til Canarm GSQ135-D (10 sider) i kategorien Ventilator. Denne vejledning er vurderet som hjælpsom af 4 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 2.5 anmeldelser. Har du et spørgsmål om Canarm GSQ135-D, eller vil du spørge andre brugere om produktet?

Side 1/10
GSQ-D SERIES
GSQ-D EC SERIES
DIRECT DRIVE GALVANIZED SQUARE INLINE BLOWER
OPERATION INSTRUCTIONS AND MANUAL PARTS
PLEASE READ AND SAVE THESE INSTRUCTIONS
M_GSQ_D_06_16_2022 Page 1 of 5
GENERAL SAFETY
GSQ-D SERIES MODELS: GSQ105-D, GSQ120-D, GSQ135-D, GSQ150-D, GSQ165-D, GSQ180-D
2. Prior to wiring ensure the power supply is locked in the position and that the motor nameplate voltage matches the supply OFF
voltage.
3. Do not install or operate this fan in an environment where combustible materials, gases or fumes are present.
4. the fan contains rotating parts and electrical service. Appropriate safety precautions should be taken during installation, Caution:
operation and maintenance.
5. Before starting the unit, ensure the wheel rotates freely.
6. Check and tighten where necessary all nuts, bolts & set screws prior to fan start up (as some may have loosened during shipment).
7. Please follow all applicable national, state/provincial and local codes, all of them will supersede this manual.
8. Failure to follow the safety instructions in this manual may cause serious injury or death due to electrical shock or high
speed rotating parts.
The purpose of this manual is to aid in the proper installation and operation of the blowers. These instructions are intended to supplement
good general practices and are not intended to cover detailed instruction procedures.
IT IS THE RESPONSIBILITY OF THE PURCHASER TO ENSURE THAT THE INSTALLATION AND MAINTENANCE OF THIS
EQUIPMENT IS HANDLED BY QUALIFIED PERSONNEL.
Inspect all shipments carefully for damage. THE RECEIVER MUST NOTE ANY DAMAGE ON THE CARRIER’S BILL OF LADING
AND FILE A CLAIM IMMEDIATELY WITH THE FREIGHT COMPANY.
GSQ-D SERIES
GSQ-D EC SERIES
DIMENSIONS
INSTALLATION
Suspension mounting: move the mounting brackets to desired
corners using the hardware provided, secure the unit to 4 customer
provided suspension rods.
Base mounting: move the mounting brackets to desired corners
using the hardware provided, secure the unit to the base. Vibration
isolators (available as accessory) are recommended for both
suspension and base mount to provide quiet operation.
In order to change the direction of discharge, relocate the access
door to leave desir
ed direction open.
M_GSQ_D_06_16_2022 Page 2 of 5
!"#$% & ' &( '( )
*+,-.-/#/$0 !"#"$%&' !!#"$%&' !(#)*$%& !! !"#*$!%'
*+,(-1/#/$0 !*#!$(' !&#"$(' +!#!$+' !"#)$(' !(#!"$!%'
*+,(2-/#/$0 +,' !*' +&#)$(' !*#)$&' +!#!)$!%'
*+,(31/#/$0 ++' !(#)$&' +%#)$(' !-#!$+' +)#!)$!%'
*+,(1-/#/$0 +&#!$+' +,#*$(' )(#)$(' +!#"$(' +%#"$!%'
*+,(41/#/$0 +%#)$&' +)' )!#!$(' +)#)$&' +(#-$!%'
*+,(5-/#/$0 +-#"$(' +"#)$(' )&' +%#!$(' )!#*$!%'
*+,/#/$06#78$096#87:$6'&0;<&8#67=0%7=$#6+,>&8$67=%7=$6'%"<$8
A1
B1
A A
A
B
B
The 8 brackets provided in parts bag could accommodate different
mounting direction/style, either base or suspension mounting.


Produkt Specifikationer

Mærke: Canarm
Kategori: Ventilator
Model: GSQ135-D

Har du brug for hjælp?

Hvis du har brug for hjælp til Canarm GSQ135-D stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ventilator Canarm Manualer

Ventilator Manualer

Nyeste Ventilator Manualer