Witheachwashcycle.
Compartment
For pro gramm es with pre-wash only.
(Follow the user instructions !)
Electric indicator on control panel (if provided).
Check the rinse aid level
(On models w ith water softener system only.)
Electric indicator on control panel (if provided).
If there is no salt warning light in the control panel
(for some models), you can estimate when to f ill the salt into
the softener by the number of cycles the dishwasher has run.
Check the regeneration
salt le vel
Load the baskets
Select a p rogramme
Turnonthewatertap,closethedoor.Themachinewillstartworkingafterabout10seconds.
Running the dishwasher
Switch off the applia nce
Turn off the water tap,
unload the baskets
Fill the detergent dispenser
Warning: wait a few minutes (about 15 min utes) before unloading the dishwa sher to avoid handling
the dishes and utensils while they are still hot and more susceptible to break.
The y will a lso dry better.Unload the appliance, starting from the lower b asket.
Changing the programme
Add forgotten dishes in the
dishwasher.
Scrape off any large amount of leftover food. Soften remnants of burnt food in pa ns,
then l oad the baskets. Refer to the dishwashe r loading instruct ions.
Press the Programm e Button until the selected programme lights up.
( See the section entitled Operationg instruction )“”
When the working cy cle has finished, the buzzer of the
dishwasher will sound 8 times, then stop.
Turn off the appliance using the On/Off Button.
If the appliance is switched
off during a wash cycle.
Op en t he do or carefull y.
Hot st eam may escape
when the door is opened!
If the appliance is switched off during a wash cycle, when switched
on agai n, plea se re-select th e washing cycle and operate the dishwasher
according to the original Power-on state ).
Switch on the applia nce Open the door,press the On/Off button to switch on the applia n ce .
1.Open the door a little to sto p the dishwasher.
2.After the spra y arms stop working, you can ope n the door completely.
3.Add the forgotten dishes.
4.Close the door, the dishwa sher will star t running again after 10 se c onds.
For detailed operating method read the corresponding content on the instructio n manual.
1. A running cycle can only be modified if it has been running for a short time. O therwise the deterg ent
m ay have alre ady be en released and the water already drained. If this is the case, the de tergent
dispenser must be refilled.
2. Press the for more than 3 seconds to cancel the running programme.
3. Select a new programme.
4. Restart the dishwash er.
Programme Button
