Casio G-Shock GM110-1A Manual
Læs nedenfor 📖 manual på dansk for Casio G-Shock GM110-1A (5 sider) i kategorien Ur. Denne guide var nyttig for 62 personer og blev bedømt med 3.8 stjerner i gennemsnit af 31.5 brugere
Side 1/5
Operation Guide 5553
E-9
To set the time and date
1. In the Timekeeping Mode, hold down A for about two
seconds until “SET” appears on the lower display. This
is the setting mode.
• Note that keeping A depressed too long (for about
five seconds) will cause a different type of setting
mode to be entered (page E-33).
2. Use D and B to select the city code you want.
• Make sure you select your Home City code before
changing any other setting.
• For full information on city codes, see the “City Code
Table” at the back of this manual.
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
City code
E-8
Timekeeping
You can adjust the Home Time city date and time in the Timekeeping Mode.
• Pressing A in the Timekeeping Mode will toggle lower display between the
screens shown below.
A
Home City Date Home City Time
Day of the week Day of the week
Date PM indicator
Hour : Minutes
SecondsSeconds
E-7
Alarm Mode (page E-24)
Countdown Timer Mode (page E-17)
World Time Mode (page E-20)
Stopwatch Mode (page E-14)
C
C
C
E-6
General Guide
• Press C to change from mode to mode.
• To return to the Timekeeping Mode from any other mode, hold down
C for about
three seconds.
• In any mode (except a setting mode), press B to illuminate the display.
Timekeeping Mode
C
C
E-5
Hand Home Position Correction ……………………………………………………E-33
To adjust home positions ………………………………………………………E-33
Reference ………………………………………………………………………………E-35
To turn the button operation tone on and off …………………………………E-36
Specifications …………………………………………………………………………E-40
E-4
World Time ………………………………………………………………………………E-20
To view the current time in another time zone ………………………………E-21
To toggle a city code time between Standard Time and
Daylight Saving Time ………………………………………………………E-22
To swap your Home City and World Time City ………………………………E-23
Alarms ……………………………………………………………………………………E-24
To set an alarm time ……………………………………………………………E-25
To test the alarm ………………………………………………………………E-26
To turn an alarm on and off ……………………………………………………E-27
To turn the Hourly Time Signal on and off ……………………………………E-28
Illumination ……………………………………………………………………………E-29
To illuminate the display manually ……………………………………………E-29
To specify the illumination duration……………………………………………E-30
To turn the auto light switch on and off ………………………………………E-32
E-3
Contents
Getting Acquainted …………………………………………………………………… E-1
General Guide ………………………………………………………………………… E-6
Timekeeping …………………………………………………………………………… E-8
To set the time and date ……………………………………………………… E-9
To change the Daylight Saving Time (summer time) setting ………………E-12
Stopwatch ………………………………………………………………………………E-14
Countdown Timer………………………………………………………………………E-17
To use the countdown timer ……………………………………………………E-18
To configure countdown start time settings …………………………………E-19
E-2
• Button operations are indicated using the letters shown in the illustration.
• Each section of this manual provides you with the information you need to perform
operations in each mode. Further details and technical information can be found in
the “Reference” section.
E-1
Getting Acquainted
Congratulations upon your selection of this CASIO watch. To get the most out of your
purchase, be sure to read this manual carefully.
• Be sure to keep all user documentation handy for future reference.
About This Manual
• Depending on the model of your watch, display text appears either as dark figures
on a light background or light figures on a dark background. All sample displays in
this manual are shown using dark figures on a light background.
MO1710-EA © 2017 CASIO COMPUTER CO., LTD.
Operation Guide 5553
E-19
To configure countdown start time settings
1. While the countdown start time is on the display in the
Countdown Timer Mode, hold down A for about two
seconds until the hour setting of the countdown start
time starts to flash. This is the setting mode.
• Holding down A will initially cause “Hold” to appear
on the screen. Keep A depressed until “Hold”
disappears.
• If the countdown start time is not displayed, use the
procedure under “To use the countdown timer” (page
E-18) to display it.
2. Press C to move the flashing in the sequence shown
below, and select the setting you want to change.
Start Time
(Hours)
Start Time
(Minutes)
C
C
3. Press A to exit the setting mode.
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
Start time
(Hours : Minutes)
E-18
To use the countdown timer
Press D while in the Countdown Timer Mode to start the countdown timer.
• When the end of the countdown is reached, the alarm will sound for 10 seconds or
until you stop it by pressing any button.
• The countdown time is reset to its starting value automatically after the alarm stops.
• Press D while a countdown operation is in progress to pause it.
Press D again to resume the countdown.
• To stop a countdown timer operation completely, first pause it (by pressing D),
and then press A. This returns the countdown time to its starting value. Note that
the countdown start time cannot be changed while a countdown timer operation is
ongoing or paused. To change the start time, you first need to stop the countdown
timer operation completely as described above.
E-17
Countdown Timer
You can set the countdown timer start time within a range
of one minute to 24 hours. An alarm sounds when the
countdown reaches zero.
• All of the operations in this section are performed in the
Countdown Timer Mode, which you enter by pressing
C (page E-7).
Start time
(Hours : Minutes)
Seconds
E-16
Stopwatch hand
Elapsed time seconds
Measured time or split time
Hours
• Alternates with “SPL” during
split time display.
Minutes, seconds,
1/100 seconds
• Pressing
D without resetting the displayed time will restart elapsed time
measurement from where it was last stopped (cumulative elapsed time
measurement).
• An ongoing elapsed time measurement operation continues even if you exit the
Stopwatch Mode. In this case, the stopwatch hand indicates the current minutes
count.
E-15
Elapsed Time Measurement
In the Stopwatch Mode, press D to start and stop elapsed time measurement.
• Pressing A while elapsed time measurement is in progress will display the current
split time.
Start Split Stop
Split
cancel
Display
time reset
D A DA A
(Measured time
displayed.)
(Measured time
displayed.)
(Split time
displayed.)
(Stopped) (Stopped)(Measurement)
E-14
Stopwatch
You can use the stopwatch to measure elapsed time and
split times.
• The digital display range of the stopwatch is 999 hours,
59 minutes, 59.99 seconds. The stopwatch continues to
run until you stop it. If it reaches the above limit, it will
restart the time measurement from zero.
• The stopwatch operation continues even if you exit the
Stopwatch Mode.
• All of the operations in this section are performed in the
Stopwatch Mode, which you enter by pressing
C (page
E-7).
E-13
3. Use D to toggle the DST setting on and off.
DST off ( ) DST on ( )
D
• The default DST setting is OFF ( ).
4. When the setting you want is selected, press
A to exit the setting mode.
• The DST indicator appears to indicate that Daylight Saving Time is turned on.
12-hour and 24-hour timekeeping
• With the 12-hour format, the PM indicator (P) appears on the lower display for times
in the range of noon to 11:59 p.m. and no indicator appears for times in the range
of midnight to 11:59 a.m.
• With the 24-hour format, times are displayed in the range of 0:00 to 23:59, without
the PM indicator (P).
• The 12-hour/24-hour timekeeping format you select in the Timekeeping Mode is
applied in all other modes.
E-12
Daylight Saving Time (DST)
Daylight Saving Time (summer time) advances the time setting by one hour from
Standard Time. Remember that not all countries or even local areas use Daylight
Saving Time.
To change the Daylight Saving Time (summer time) setting
1. In the Timekeeping Mode, hold down A for about two
seconds until “SET” appears on the display.
• Note that keeping A depressed too long (for about
five seconds) will cause a different type of setting
mode to be entered (page E-33).
2. Press C. This will display the DST setting screen.
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
DST indicator
E-11
Screen: To do this: Do this:
Reset the seconds to Press
D.
Change the hour and minutes
Use D (+) and B (–).
Change the year, month, or day
Toggle the button operation tone
between (on) and (off) Press D.
Toggle the display illumination duration
between 1.5 seconds ( ) and three
seconds ( ) Press D.
5. Press
A to exit the setting mode.
• The day of the week is displayed automatically in accordance with the date (year,
month, and day) settings.
E-10
3. Press C to change the flashing screen content in the sequence shown below to
select the other settings.
City
Code DST 12/24-Hour
Format Seconds Hour Minutes
YearMonthDay
Button
Operation Tone
Illumination
Duration
C C C C C
C C
CCCC
4. When the timekeeping setting you want to change is flashing, use
D or B to
change it as described below.
Screen: To do this: Do this:
Change the city code Use
D (east) and B (west).
Toggle the DST setting between
Daylight Saving Time ( ) and
Standard Time ( ).
Press D.
Toggle between 12-hour ( ) and
24-hour ( ) timekeeping Press D.
Produkt Specifikationer
| Mærke: | Casio |
| Kategori: | Ur |
| Model: | G-Shock GM110-1A |
Har du brug for hjælp?
Hvis du har brug for hjælp til Casio G-Shock GM110-1A stil et spørgsmål nedenfor, og andre brugere vil svare dig
Ur Casio Manualer
7 April 2025
7 April 2025
30 Marts 2025
22 December 2024
22 December 2024
21 December 2024
21 December 2024
21 December 2024
21 December 2024
21 December 2024
Ur Manualer
- Ur Guess
- Ur Habitat
- Ur Freestyle
- Ur So & Co
- Ur MICHELE
- Ur Klaus Kobec
- Ur Naitica
- Ur Huawei
- Ur Lynx
- Ur Elro
- Ur Weinberger
- Ur Vitek
- Ur Zeppelin
- Ur Muse
- Ur Bearware
Nyeste Ur Manualer
9 Juni 2025
8 Juni 2025
8 Juni 2025
7 Juni 2025
7 Juni 2025
6 Juni 2025
6 Juni 2025
6 Juni 2025
6 Juni 2025
6 Juni 2025