2
DISCLAIMER
CSAV, Inc., and its affiliated corporations and subsidiaries
(collectively, "CSAV"), intend to make this manual accurate and
complete. However, CSAV makes no claim that the information
contained herein covers all details, conditions or variations, nor
does it provide for every possible contingency in connection
with the installation or use of this product. The information
contained in this document is subject to change without notice
or obligation of any kind. CSAV makes no representation of
warranty, expressed or implied, regarding the information
contained herein. CSAV assumes no responsibility for
accuracy, completeness or sufficiency of the information
contained in this document.
IMPORTANT WARNINGS AND
CAUTIONS!
WARNING: A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION: A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING: Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all components are
properly assembled and installed using the instructions
provided.
WARNING: Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the structure to which this component is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component.
Dimensions Projector Size Limit
Model Height Width Depth Height Width Depth
10.18” 20.52” 20.38” 7.50” 20.375” 20.00”*
PG-1A
258.589mm 521.320mm 517.525mm 19.05 cm 51.75 cm 50.8 cm
10.18” 16.15” 16.38” 7.50” 16.00” 16.00”*
PG-2A
258.589mm 410.195mm 415.925mm 19.05 cm 40.46 cm 40.64 cm
* Height dimension from bottom of RPA to surface of rivets (at bottom of projector guard).
Height dimension does NOT include SLB/SLM interface. You must allow for .25" to .75" less height to
account for the SLB/SLM interface.
RPM series mount reduces maximum height by 1.00".
Maximum height using RPA series mount is 7.25" to 6.75".
Maximum height using RPM series mount is 6.25" to 5.75".
The PG1A weighs 19.95 lbs (9.06 kg)
The PG2A weighs 15.20 lbs (6.88 kg)
PROJECTOR GUARD SPECIFICATIONS
