Clas Ohlson 34-7357 Manual

Clas Ohlson Skridttæller 34-7357

Læs gratis den danske manual til Clas Ohlson 34-7357 (8 sider) i kategorien Skridttæller. Denne vejledning er vurderet som hjælpsom af 82 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 41.5 anmeldelser. Har du et spørgsmål om Clas Ohlson 34-7357, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/8

GREAT BRITAIN

For consumer contact, please visit www.clasohlson.co.uk and click on customer service.

ENGLISH

Step Counter Art. Nr 34-7357

Please read the entire instruction manual before using and save it for future use.

Step counter’s buttons

S1 – Mode/UP

S2 - Down

S3 - Clear

S4 - Set

Use

Step counting

1. Push until “STEP” shows on display.MODE/UP

2. The display now shows the total amount of steps.

3. Push and hold in to programme the length unit. SET

4. Use and to change between Km or Miles. Push to MODE/UP DOWN SET

conﬁrm.

5. Push to reset the counter in the display.CLEAR

Distance counter

1. Push to walk with distance counter. “KM” or “MILE” is shown on MODE/UP

the display.

2. Push to choose ”KM” or MILE”.DOWN

3. The distance counter is reset to zero at the same time as the step counter.

Set the stride length

1. Push MODE/UP until the distance counter (the distance you have walked

in km or miles) is shown on the display.

2. Push and hold in SET for 2 seconds. The length of strides blink in the display.

3. Use and to set the stride length (your length of strides).MODE/UP DOWN

4. Push to conﬁrm.SET

Calorie counter

1. Push MODE/UP to walk with distance counter. “KCAL” is shown on the display.

2. Push and hold in for approx. 2 secs to indicate your weight. Set weight SET

blinks in display.

3. Use and to set the weight.MODE/UP DOWN

4. Push to conﬁrm.SET

Use stopwatch

1. Push to activate the stopwatch.MODE/UP

2. Push to start or stop the timer.DOWN

3. When the timer is stopped, push to reset the timer. SET

• For time intervals, push once on while the timer is in progress. The SET

display stops and shows the time interval. The timer continues in the

background.

• Push again to resume the time keeping.SET

Use assault alarm

Activate: Pull out the alarm pin from the back of the step counter to activate the

assault alarm.

Shut off: Replace the alarm pin to shut off the alarm.

Open the battery cover

• Take away the battery cover by

unscrewing the screws and then pushing

the battery cover backwards according to

the picture.

Adjust the step counter’s sensitivity

1. Remove the battery cover.

2. Change the step counter’s sensitivity by

pushing the control laterally. Try it out by

ﬁnding the correct position.

• Example: Walking 100 steps. If the step

counter shows more than 100 steps

adjust your sensitivity downward.

If the step counter shows less than 100

steps adjust your sensitivity upward.

Change of battery

1. Remove the battery cover.

2. Lift out the batteries with the help of a

small screwdriver and replace them with

new ones. Be careful to put the battery

in with correct polarity according to the

picture.

Disposal

Follow local ordnances when disposing this product. If you are unsure about how

to dispose this product contact your municipality

Speciﬁcations

Battery type : 1x SR54 (included)

Battery, assault alarm: 2x CR2016 (included)

Step counter: Up to 99 999 steps

Calorie counter: Up to 9999.9 kcal

Distance: Up to 9999.9 km/mile

Preparations

Step counter’s menus

Push to choose function in following order:MODE/UP

TMR (clock) -> ALM (alarm) -> STEP (step counting) -> KM (distance) ->

KCAL (calorie measurement) -> STW (stopwatch)

Set time

1. Push until “TMR” is shown on display.MODE/UP

2. Push and hold for approx. 2 secs to walk in setting position.SET

3. Use and to change the hours. Conﬁrm with .MODE/UP DOWN SET

4. Use and to change the minutes. Conﬁrm with .MODE/UP DOWN SET

5. Push to change between 12 or 24 hour display.DOWN

Set alarm

1. Push until “ALM” is shown on display.MODE/UP

2. Push to change between 12 or 24 hour display.DOWN

3. Push and hold for approx. 2 secs to walk in setting position.SET

4. Use and to change the hours. Conﬁrm with .MODE/UP DOWN SET

5. Use and to change the minutes and conﬁrm with . MODE/UP DOWN SET

The alarm time now blinks on the display.

6. Push to turn on/off the alarm. An alarm symbol shows on the MODE/UP

display when the alarm is activated.

7. Push to conﬁrm.SET

Wearing the step counter

• Attach step counter to belt or to another item of clothing at waistline height

on the side of the body. For the step counter to function correctly it is

important that it is attached in a horizontal position.

Ver. 200802

Produkt Specifikationer

Mærke:	Clas Ohlson
Kategori:	Skridttæller
Model:	34-7357

Har du brug for hjælp?

Hvis du har brug for hjælp til Clas Ohlson 34-7357 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Skridttæller Clas Ohlson Manualer

Clas Ohlson 34-7357 Manual

7 Februar 2024

Skridttæller Manualer

Nyeste Skridttæller Manualer

Crivit IAN 278509 Manual

30 Juni 2025

Irox PE-DRO Manual

9 Marts 2025

Timex W180-M621 Manual

13 Januar 2025

TFA 42.2003 Manual

5 September 2024

Silva ex connect Manual

27 August 2024

HMM smartLAB walkP plus Manual

26 August 2024

BandeeFit BFX-4 Manual

25 August 2024

Dexford PE 500 Manual

24 August 2024

Dexford PE 200 Manual

24 August 2024

Dexford PE 400 Manual

24 August 2024