Closer Pets Fish Mate 473 Manual

Closer Pets Vandpumpe Fish Mate 473

Læs gratis den danske manual til Closer Pets Fish Mate 473 (2 sider) i kategorien Vandpumpe. Denne vejledning er vurderet som hjælpsom af 7 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 4 anmeldelser. Har du et spørgsmål om Closer Pets Fish Mate 473, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

FISH MATE 1200

IMPORTANT SAFETY

INSTRUCTIONS

WARNING - To guard

against injury or death,

basic safety precautions

should be observed,

including the following:

READ AND FOLLOW

ALL SAFETY

INSTRUCTIONS

• Register your purchase on-line

at www.pet-mate.com/uk (see

guarantee overleaf).

• All electrical work must be carried out

by a competent electrician.

• Check that the voltage label on the

motor (H) (see Fig. 1) conforms with

your supply voltage.

• The pump MUST be wired into an

R.C.D./G.F.I. circuit breaker

(maximum 30mA) and a 3 AMP

(maximum) fuse. Ensure breaker is

regularly tested in accordance with

manufacturers instructions.

• Connection to the power supply

should be made through a CE

approved weatherproof outdoor

socket or double pole switched

enclosure with minimum 3mm (1/8”)

contact separation in all poles. If

product is hard wired to electrical

supply this must comply fully with the

wiring regulations of the national and

local electricity authority. The pump

must be protected by a 3 AMP

(maximum) fuse.

• This appliance must be earthed. It is

essential that all connections are

securely made using the following

code:

Brown - Live

Blue - Neutral

Green/Yellow - Earth

• Do not carry or pull the pump using

the supply cord.

• Disconnect electrical supply from all

appliances in the pond including

pumps and filters before contact with

the pond water or pump.

• Closely supervise children when near

to pond or pond equipment.

• Use pump only for ponds - do not use

pump in connection with swimming

pools, showers, etc.

• Use conduit approved by your

electricity authority to protect supply

cord where damage from gardening

equipment, children and animals may

occur.

• Discard pump if motor (H) shows

visual defects (e.g. cracks or

swelling).

• The supply cord of this appliance

cannot be replaced; if the cord is

damaged the appliance should be

discarded.

• Do not allow the pump to run dry.

• Do not operate the pump in freezing

conditions. Remove, disassemble and

dry pump if there is a risk of pump

being frozen.

• This pump is provided with a thermal

cut-out switch that temporarily

switches off the pump in case of

overheating. The pump may restart

when it has cooled.

SAVE THESE

INSTRUCTIONS

1. PUMP INSTALLATION

For convenience the pump should be positioned

within reach from the side of the pond on a solid

platform (e.g. paving slabs) approximately 250mm

(10") below the pond surface. The pump should be

at least 200mm (8") below water level to avoid

problems of freezing and low water levels in summer

and no more than 1000mm (40") deep. We

recommend using the foam filter (B) only if clogging

of the fountain head is a major problem.

Only use pump if completely immersed in water.

A. Waterfall/Filter Only

For use with a pond filter you will often get improved

results with the pump sited at the opposite end of the

pond to the filter return.

The pump may be connected to a waterfall or filter

using 12mm (1/2") or 19mm (3/4") bore hose. Fit

outlet adapter (J) and flow valve (K) into pump outlet

(I). Insert adapter (O) if required and connect hose to

required outlet (see Fig 2). Insert plug (P) in unused

outlet and adjust flow using the flow control knob (L).

B. Fountain (and Waterfall/Filter)

Insert fountain components as shown in Fig. 3a

(conventional fountain) / 3b (bell fountain). If

required tube (Q) may be shortened with a hacksaw.

For plume fountain do not fit any parts to tube (Q). If

required, connect waterfall/filter with hose to outlet

(N or O). Alternatively, use blanking plug (P). The

Fountain heads may be unscrewed anticlockwise for

cleaning. Adjust fountain height/width using the flow

control (L) turning clockwise for increased height. If

using the bell fountain you will also need to manually

adjust the gap between parts (T) and (U) for the

required effect. (Try starting with approximately 1mm

(1/16”) gap.)

2. MAINTENANCE / FAULT FINDING - IMPORTANT

SAFETY INSTRUCTIONS

• Disconnect electrical supply from pump before

removing from pond or contacting pond water.

• Do not carry or pull the pump by the cable.

A. ROUTINE MAINTENANCE OR WHEN FLOW

FROM YOUR PUMP IS NOTICEABLY REDUCED

OR FOUNTAIN DISPLAY HAS DETERIORATED:

i) Remove strainer cover (A) and foam filter (B) as

shown by arrow in Fig.1.

ii) Rinse foam filter (B) in water until clean.

iii) Remove and clean fountain head in water with a

brush.

iv) Reassemble.

IMPORTANT

If flow is still poor check:

• Flow control (L) is correctly set.

• No blockage or kinks in outlet hose.

B. ONCE A YEAR OR IF FLOW IS STOPPED

(CHECK POWER SUPPLY FIRST!):

Completely disassemble pump to the component

parts shown in Fig. 1. Wash all parts in clean water

and replace impeller assembly if required as follows:

i) Disconnect all items fitted to pump outlet (I).

ii) Remove strainer cover (A) and foam filter (B) as

shown in Fig. 1.

iii) Remove impeller cover (C) by rotating anticlockwise.

iv) Carefully pull out pump impeller assembly (F) then

(G).

v) After cleaning of all components:

• Check for wear of impeller (F) on shaft (G) and

condition of rubber bushes (E). Replace with new

impeller assembly if required.

• Check cable and pump body (H) for any damage

or deterioration and discard pump if suspected

faulty.

vi) Carefully reassemble all parts in reverse sequence.

IMPORTANT - READ BEFORE USE

B C

F G

E I

M N

39002/1118

Pond Pump · Instructions

www.pet-mate.com +44 (0)1932 700 001

IMPORTANT: Dispose of damaged/faulty/end-of-

life products in accordance with locally applicable

regulations for your country. EU: Refer to Terms

and Conditions section

EU Waste Electrical and

Electronic Equipment (WEEE) Directive

www.pet-mate.com for more information.

Hereby, Pet Mate Ltd., declares that this product is

in compliance with the essential requirements and

other relevant provisions of EU Directives. All

Declarations of Conformity (DoC) may be viewed

at www.pet-mate.com/eudoc.

Produkt Specifikationer

Mærke:	Closer Pets
Kategori:	Vandpumpe
Model:	Fish Mate 473

Har du brug for hjælp?

Hvis du har brug for hjælp til Closer Pets Fish Mate 473 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Vandpumpe Closer Pets Manualer

Closer Pets Fish Mate 473 Manual

23 September 2025

Closer Pets Fish Mate 1200 Manual

9 September 2025

Closer Pets Fish Mate 9000 Manual

9 September 2025

Closer Pets Fish Mate 7000 Manual

9 September 2025

Vandpumpe Manualer

Nyeste Vandpumpe Manualer

Little Giant 501020 Manual

11 December 2025

Little Giant P-AAA Manual

10 December 2025

Little Giant 5-ASP-FS Manual

10 December 2025

Little Giant PE-1 Manual

9 December 2025

Vevor NMDP42-G30-55-12 Manual

1 December 2025

Vevor HCP370-D Manual

1 December 2025

Eden PAS 3000 Manual

1 December 2025

Vevor FLO500 Manual

1 December 2025

Vevor HM14075LCb Manual

30 November 2025

Vevor HCP2200 Manual

30 November 2025