
Note: in normal operation the controller turns the compressor off at the set temperature,
and back on after the temperature had risen by around 5°c. As such, the reading in the
electronic controller is almost always a few degrees above set-point, and that is perfectly
LOOKING AFTER THE PRODUCT - DEFROSTING:
Ice may build up on the evaporator if the unit is put to work constantly for a period.
When ice begins to build up to approx 10 mm or 1/5 inch thick, defrost is required.
Empty the cabinet of the products that must stay at cold condition. Switch the
thermostat to 'OFF ‘position.
The ice will start to melt. When the ice has melted and drained away, dry off any
residual moisture with a soft cloth.
Switch on the power again via thermostat.
Please note it will take around 12 hours for the cabinet to get back down to
1. UNPLUG your chiller and remove any stock to a suitable back-up chiller.
2. Wash the inner compartment with warm water and neutral detergent. DO NOT
allow the control panel, cables or plug to get wet.
NEVER use corrosive detergents, wire brushes, or abrasive scourers to clean your
NEVER use metal or sharp implements to remove debris.
3. Dry all surface thoroughly.
4. To ensure trouble-free operation the condenser should be cleaned every three
months where appropriate using a vacuum hose. The condenser is located behind
lower grill of the cabinet. In exceptionally dusty locations the condenser should be
Please register the warranty for this product on www.cooklogy.com
Ireland : Cookology Limited, Ground floor, 71 Lower Baggot Street,
United Kingdom : Cookology Limited, Unit 2 Piperell Way, Haverhill,
se mild soapy water to clean the gasket and seals.
1. Unplug the power plug.
2. Remove the screws on both end of the light cover, take down the lamp cover,
pull out the wires, then take away the lamp.
3. Install the new lamp, connect the wires, place the lamp cover and fasten it.