Creda W120FW Manual

Creda Vaskemaskiner W120FW

Læs gratis den danske manual til Creda W120FW (16 sider) i kategorien Vaskemaskiner. Denne vejledning er vurderet som hjælpsom af 44 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 22.5 anmeldelser. Har du et spørgsmål om Creda W120FW, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/16
Washing Machine
W100FW / W120FW / W120VW
Retention of this Instruction Book
Keep this book in a handy place for reference. It contains important details on
the safe and proper use of your appliance. If you sell the appliance, pass it on
to someone else, move house and leave it behind, make sure that you provide
this book so that the new owner can become familiar with the appliance and
safety warnings.
Please remember your new appliance is a complex piece of equipment.
DIY repairs or unqualified and untrained service people may put you in
danger, could damage the appliance and might mean you lose cover
under Creda’s Part Guarantee.
Model W120VW is shown
Positioning & Adjusting the feet
Choosing the position of your appliance will influence its performance.
★Position where possible on a solid floor. Some vibration may occur with a wooden floor.
★Take care with vinyl floor coverings.The weight of the appliance may cause indentations in
some vinyl floor coverings.
★For your safety and to comply with IEE regulations, you should not install your appliance in
a bath or shower room. Seek professional advice if you wish to do so.
★Ensure sufficient space is allowed for the appliance. Dimensions should be a minimum of:-
600mm Wide (235/8”), 600mm Deep (235/8”) and 900mm High (351/2”).
★Ensure the electrical socket and water taps are easily accessible and that the water supply
can be isolated if necessary.
Your appliance may become noisy or move about the floor if it is not stabilised.
To adjust your appliance it must be in an upright position, then :-
★Release locking rings on the two front feet.
★Screw feet in or out until the appliance is standing firm and level.
★Ensure all feet are in firm contact with the floor.
★Tighten the locking rings on the front feet.
Dear Customer,
Congratulations on the purchase of your
new ‘Creda’ appliance.
We recommend for your own safety and to
get the best possible results from your
machine that you read through this
handbook thoroughly before using your
appliance for the first time.
★Transit Brackets MUST be removed
before using the appliance.
★DO NOT plug in and switch on at the
mains until installation is complete.
Recycling & Disposal Information
As part of Creda’s continued commitment to helping the environ-
ment, Creda may use quality recycled components to keep down
customer costs and minimise material wastage. Please dispose of
packaging and old appliances carefully. To minimise risk of injury to
children, remove the door, plug and cut mains cable off flush with the
appliance. Dispose of seperately to ensure that the appliance can no
longer be plugged into a mains socket.
2
Electrical Requirements
This appliance should be connected to the mains supply via a suitable switched socket in an
accessible position.
WARNING: This appliance must be earthed.
FUSES
Your appliance comes fitted with a plug and a 13A fuse. If you need to replace the fuse, only
those rated at 13A and ASTA approved to BS1362 should be used.To change fuse, lift holder
to vertical position and lift fuse out. To replace, insert fuse and push fuse holder down into
locked position. Correct replacement is identified by colour coding, or marking on base of
plug.
WARNING: Do not use plug unless fuse holder is in locked position.
CHANGING THE PLUG
Cut off and dispose of the supplied
plug if it does not fit your socket.
WARNING: To avoid a shock haz-
ard do not insert this plug into a
socket anywhere else.
IMPORTANT: WIRES IN THE MAINS
LEAD ARE COLOURED IN
ACCORDANCE WITH THE
FOLLOWING CODE:
Green/Yellow – Earth
Blue – Neutral
Brown – Live
If you change the plug, the colour of wires in the mains lead may not correspond with the
colour of the markings identifying terminals in the plug.You should therefore wire it as
shown (see illustration). If the mains lead needs to be replaced at any time, it should be
replaced by a special lead obtainable from your local authorised Creda Service Centre.
A charge will be made if you have damaged the existing lead or require a longer one.
It is strongly advised that this work is carried out by a qualified electrician.
CE marking certifies that this appliance complies with requirements laid down in EEC
Directive 89:336 (Electromagnetic compatibility) and subsequent modifications and Low
Voltage Directive 73/23/EEC.
Green and yellow
(Earth) wire to the
terminal marked
‘E’or with the
symbol ,
or coloured
green and
yellow.
Brown (Live)
wire to the
terminal
marked ‘L’ or
coloured
red.
Blue (Neutral) wire
to the terminal marked
‘N’or coloured black.
Cord clamp
13A ASTA
approved
fuse to
BS1362.
Contents
Electrical requirements 2
Recycling & Disposal Information
Choosing a Location
Adjusting the Feet
Installation Instructions 3-4
Transit Bracket Removal
Connecting to the Water Supply
Removing the Polystyrene Pyramid
Connecting to a Drainage System
Getting to Know your Machine 5
Wash Load Guides
Interlocking Door System
Washcare tips
A Typical Wash Programme 6
Controls 7
Choosing A Wash Programme 8
Optional Wash Features 9
Dispenser Drawer 10-11
Care and Cleaning 12
Maintenance Wash
Regular Checks and Stain Removal 13
Something wrong with your appliance 14
Service Cover 15
Key Contact Numbers Back page

Produkt Specifikationer

Mærke: Creda
Kategori: Vaskemaskiner
Model: W120FW

Har du brug for hjælp?

Hvis du har brug for hjælp til Creda W120FW stil et spørgsmål nedenfor, og andre brugere vil svare dig


Vaskemaskiner Creda Manualer

Creda

Creda W120FW Manual

8 Oktober 2024

Vaskemaskiner Manualer

Nyeste Vaskemaskiner Manualer

Bosch

Bosch WAQ28440EX Manual

15 Januar 2025
Siemens

Siemens WM14Q472DN Manual

15 Januar 2025
BEKO

BEKO WTV8740A1 Manual

15 Januar 2025
Hoover

Hoover DST 10166PG-80X Manual

15 Januar 2025
Asko

Asko 15605 Manual

15 Januar 2025
Hisense

Hisense WFPV9014EM Manual

15 Januar 2025
BEKO

BEKO WRE 6532 ZSBS Manual

14 Januar 2025
Miele

Miele V 9545 WPS Meteor Manual

14 Januar 2025
Zanussi

Zanussi ZWF 91483 WR LINDO 300 Manual

14 Januar 2025
Corbero

Corbero E-CLA5018W Manual

14 Januar 2025