DataComm 50-6653-WH-KIT Manual

DataComm Ikke kategoriseret 50-6653-WH-KIT

Læs gratis den danske manual til DataComm 50-6653-WH-KIT (5 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 26 personer og har en gennemsnitlig bedømmelse på 4.2 stjerner ud af 13.5 anmeldelser. Har du et spørgsmål om DataComm 50-6653-WH-KIT, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/5

WARNING

DataComm Electronics’ products shall be installed and used ly as indicated in DataComm Electronics’ product instruction sheets. on

Instruction sheets are available online at w.datacommelectronics.com. ww

CAUTION

For shock protection, this dev e must be pr erly grounded.ic op

Use copper wire only with this device.

IMPORTA INSTRUCTIONS NT

Read and understand all instructions.

Follow all warnings and instructions marked on the product.

Do not use this product near water, for example near a bath tub, wash bowl, kitchen sink, la dry tub, in a wet basement, or near aun

sw p .imming ool

SA VE THESE INSTRUCTIONS.

Instruction / Installation Sheet

Recessed TV Cable & Media

Organizer Kit with Duplex Power

Part # 50-6653-WH-KIT

DataComm Electronics, Inc.

6349 Peachtree Street

Norcross, GA 30071-1725

888.223.7977

770.662.8205

www.DataCommElectronics.com

Parts Included:

• Recessed Media Box II (Top Plate)

• Old Work Electrical Box with four (4) Mounting Screws

• 15 Amp/125 Volt Tamper Resistant Duplex Receptacle

• Flexible Pass-Through Accessory Plate

• Six (6) Port Keystone Accesory Plate

• Blank Accessory Plate

• Bottom Plate w/ Easy Push-In Connectors

• 8 ft. Extension Cord with 360 Rotating Flat Head˚

Tools Required:

• Drill with Phillips Bit or Phillips Head Screw Driver

• Pen or Pencil

• Sheetrock Saw or Utility Knife

• 6 Ft. Tape Measure

Use the Recessed TV Cable Organizer Kit with Duplex Power to install low voltage cables behind your HDTV

or other display device. The Media Box can be installed with the receptacle on the left or right side (see

Installation Diagram below).

Features of the Recessed TV Cable Organizer Kit with Duplex Power include:

• Compact size fits behind small and large TV’s

• Snap-in side plate features cutouts for 1” and 2” conduit or tubing

• HDTV/display device plug recesses completely into the wall when plugged into the Media Box

• Flexible Pass-Through Accessory Plate conceals low voltage pass-through opening

• Bottom plate features easy-snap in connectors for a fast and easy install

Page 1 of 5

11/16/16

Installation Diagram

Front View

Installation Diagram

Back View

Concealed Wiring

(hidden in wall)

Flat Screen TV

Concealed Wiring

(hidden in wall)

Receiver

Receptacle

Receiver

Receptacle

2Fig.

Fig. 3

Fig. 1

Fig. 4

Fig. 6

Installation Instructions:

Figure 1:

Cut out the supplied templates for the top and bottom plates from pages 4 & 5 of this

instruction sheet. Place the templates on the wall in the desired install location. Note: the

top plate will install high on the wall in the location where you will hang your TV. The

bottom plate installs directly below the top plate near the floor.

Using your pen or pencil, trace the templates on the wall. Then use a drywall saw or utility

knife to cut holes in the drywall the size of the templates.

Figure 2:

Take the pre-wired electrical box and run the electrical building wire into the wall.

Figure 3:

Use the four provided screws to secure the Old Work Electrical Box and Receptacle to

the mounting studs on the backside of the Top Plate.

Figure 4:

Important: Before installing the Top Plate into the template opening, make sure to pull

your low voltage cables through the low voltage cable opening.

After low voltage pass through: Starting with the receptacle side of the Top Plate

slowly sliding it into the opening. Swing the opposite side of the plate into position until the

entire box is flush with the wall. Now screw down the screws with wings; these wings

fasten tightly against the back of the drywall.

Figure 6:

The top plate is now installed. You can now install your TV wall mount and hang your flat

panel display.

Page 2 of 5

888.223.7977

770.662.8205

www.DataCommElectronics.com

Instruction / Installation Sheet

Recessed TV Cable & Media

Organizer Kit with Duplex Power

Part # 50-6653-WH-KIT CONTINUED

11/16/16

Fig. 5

Figure 5:

Before installing the Top Plate into the wall opening, make sure to pull your low voltage

cables through the top and bottom openings or the side opening.

If you are using flexible tubing, cut out either the 1” or 2” knockout (depending on your

flexible tube hole size) from the snap-in cover plate, now run your cables through the

snap-in plate opening, then attach your flexible.

Produkt Specifikationer

Mærke:	DataComm
Kategori:	Ikke kategoriseret
Model:	50-6653-WH-KIT

Har du brug for hjælp?

Hvis du har brug for hjælp til DataComm 50-6653-WH-KIT stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret DataComm Manualer

DataComm 45-8021-1S Manual

31 Juli 2025

DataComm 50-6653-WH-KIT Manual

30 Juni 2025

DataComm 45-0022-WH Manual

14 August 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

IFM SU9030 Manual

13 September 2025

IFM O2U554 Manual

13 September 2025

Speco Technologies HTi70TM Manual

13 September 2025

QSC RMXa Manual

13 September 2025

Tineco Floor One S2 Series Manual

13 September 2025

Tineco Floor One S3 Breeze Manual

13 September 2025

Tineco Floor One S5 Steam Manual

13 September 2025

Osram VX500-CB Manual

13 September 2025

Zelmer ZTS7990 Manual

13 September 2025

Osram VX250-SP Manual

13 September 2025