DeWalt D28110 Manual

DeWalt Slibemaskine D28110

Læs gratis den danske manual til DeWalt D28110 (52 sider) i kategorien Slibemaskine. Denne vejledning er vurderet som hjælpsom af 17 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 9 anmeldelser. Har du et spørgsmål om DeWalt D28110, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/52
D28110, D28112, D28402, D28402N
Heavy-Duty Small Angle Grinder
Petites meuleuses angulaires de service intensif
Esmeriladoras angulares pequeñas para trabajo pesado
INSTRUCTION MANUAL
GUIDE D'UTILISATION
MANUAL DE INSTRUCCIONES
INSTRUCTIVO DE OPERACIÓN, CENTROS DE SERVICIO Y PÓLIZA
DE GARANTÍA. ADVERTENCIA: LÉASE ESTE INSTRUCTIVO
ANTES DE USAR EL PRODUCTO.
If you have questions or comments, contact us.
Pour toute question ou tout commentaire, nous contacter.
Si tiene dudas o comentarios, contáctenos.
1-800-4-DEWALT • www.dewalt.com
English
1
IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS
OR ANY DEWALT TOOL, CALL US TOLL FREE AT:
1-800-4-DEWALT (1-800-433-9258)
General Safety Rules – For All Tools
WARNING! Read and understand all instructions.
Failure to follow all instructions listed below may
result in electric shock, fire and/or serious personal injury.
SAVE THESE INSTRUCTIONS
WORK AREA
•Keep your work area clean and well lit. Cluttered benches
and dark areas invite accidents.
•Do not operate power tools in explosive atmospheres, such
as in the presence of flammable liquids, gases, or dust.
Power tools create sparks which may ignite the dust or fumes.
•Keep bystanders, children, and visitors away while operat-
ing a power tool. Distractions can cause you to lose control.
ELECTRICAL SAFETY
•Grounded tools must be plugged into an outlet properly
installed and grounded in accordance with all codes and
ordinances. Never remove the grounding prong or modify
the plug in any way. Do not use any adaptor plugs. Check
with a qualified electrician if you are in doubt as to whether
the outlet is properly grounded. If the tools should electrical-
ly malfunction or break down, grounding provides a low resist-
ance path to carry electricity away from the user. Applicable
only to Class I (grounded) tools.
•Double insulated tools are equipped with a polarized plug
(one blade is wider than the other.) This plug will fit in a
polarized outlet only one way. If the plug does not fit fully in
the outlet, reverse the plug. If it still does not fit, contact a
qualified electrician to install a polarized outlet. Do not
change the plug in any way. Double insulation eliminates
the need for the three wire grounded power cord and grounded
power supply system. Applicable only to Class II (double
insulated) tools.
•Avoid body contact with grounded surfaces such as pipes,
radiators, ranges and refrigerators. There is an increased risk
of electric shock if your body is grounded.
•Don’t expose power tools to rain or wet conditions. Water
entering a power tool will increase the risk of electric shock.
•Do not abuse the cord. Never use the cord to carry the tools
or pull the plug from an outlet. Keep cord away from heat,
oil, sharp edges or moving parts. Replace damaged cords
immediately. Damaged cords increase the risk of electric shock.
•When operating a power tool outside, use an outdoor
extension cord marked “W-A” or “W.” These cords are rated
for outdoor use and reduce the risk of electric shock. When
using an extension cord, be sure to use one heavy enough to
carry the current your product will draw. An undersized cord will
cause a drop in line voltage resulting in loss of power and over-
heating. The following table shows the correct size to use
depending on cord length and nameplate ampere rating. If in
doubt, use the next heavier gage. The smaller the gage number,
the heavier the cord.
Minimum Gage for Cord Sets
Volts Total Length of Cord in Feet
120V 0-25 26-50 51-100 101-150
240V 0-50 51-100 101-200 201-300
Ampere Rating
More Not more AWG
Than Than
0 - 6 18 16 16 14
6 - 10 18 16 14 12
10 - 12 16 16 14 12
12 - 16 14 12 Not Recommended

Produkt Specifikationer

Mærke: DeWalt
Kategori: Slibemaskine
Model: D28110

Har du brug for hjælp?

Hvis du har brug for hjælp til DeWalt D28110 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Slibemaskine DeWalt Manualer

DeWalt

DeWalt DWE4115 Manual

30 December 2025
DeWalt

DeWalt DWE46103 Manual

15 September 2024
DeWalt

DeWalt DW887-220 Manual

13 September 2024
DeWalt

DeWalt D28106-XE Manual

4 September 2024
DeWalt

DeWalt DW800 Manual

4 September 2024
DeWalt

DeWalt DW806 Manual

4 September 2024
DeWalt

DeWalt DWE4121 Manual

4 September 2024
DeWalt

DeWalt D28130 Manual

4 September 2024
DeWalt

DeWalt DWE46155 Manual

3 September 2024
DeWalt

DeWalt DWE4997 Manual

30 August 2024

Slibemaskine Manualer

Nyeste Slibemaskine Manualer

Einhell

Einhell BT-MG 160 KIT Manual

29 Marts 2025
Kraftronic

Kraftronic KT-WS 2000 Manual

29 Marts 2025
Kraftronic

Kraftronic KT-WS 750 Set Manual

29 Marts 2025
NEO Tools

NEO Tools 14-014 Manual

28 Marts 2025
Makita

Makita 9500D Manual

28 Marts 2025
Bosch

Bosch GWS 30-180 PB Professional Manual

5 Februar 2025
Metabo

Metabo WVBF 18 LT BL 11-125 Quick Manual

1 Februar 2025
Parkside

Parkside PEXS 270 A1 Manual

13 Januar 2025
Makita

Makita 9562CVR Manual

12 Januar 2025
Chicago Pneumatic

Chicago Pneumatic CP7255 Manual

11 Januar 2025