Dimplex DEE 2102 Manual

Dimplex Kedler & kedler DEE 2102

Læs gratis den danske manual til Dimplex DEE 2102 (10 sider) i kategorien Kedler & kedler. Denne vejledning er vurderet som hjælpsom af 12 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 6.5 anmeldelser. Har du et spørgsmål om Dimplex DEE 2102, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/10
Montageanweisung
Installation instructions
Manuel de montage
Gebruiksaanwijzing
Instrucciones de instalación
Instrukcja monta˝u
DEE 1802 / DEE 2102 / DEE 2402
Durchlauferhitzer
Instantaneous water heater
Chauffe-eau instantané
Doorstroom heetwaterapparaat
Calentador de paso continuo
Podgrzewacz przep∏ywowy
4
Assemble the instantaneous water heater as shown in
the illustrations. Observe the information in the text.
Safety information
■
The instantaneous water heater must only be
connected and started up by an authorised technician.
■
The statutory regulations of the respective country, as well
as those of the local electricity and water suppliers must
be adhered to.
■
The instantaneous water heater is an appliance of protec-
tion class
I
and
must
be connected to the protective earth
conductor.
■
The unit have to be connected durably to the mains
electricity supply via an all pole disconnecting device with
contact gap must be at least 3 mm.
■
The instantaneous water heater is suitable for enclosed
(pressurised) operation only.
■
The tap fittings must be permitted for operation with
enclosed (pressurised) instantaneous water heaters.
■
The instantaneous water heater must only be connected
to a cold-water pipe.
■
The instantaneous water heater is suitable for connection
to DVGW-tested plastic pipes.
■
The instantaneous water heater must only be installed
in a frost-free room.
■
Prior to installation, the electric connecting cable
must be disconnected from the mains voltage and
the water supply cut off!
■
Only connect the electric supply after the water
supply.
■
When making holes in the rear panel, only make the
number of holes required for installation. If the appliance
is reinstalled, any holes that are not used must be made
watertight.
■
Live components must not be touched subsequent to
installation.
Assem bly
Unpacking/removing the
housing cover
■
Unpack the appliance and check for transportation
damage.
■
Dispose of the packaging and, where applicable, the old
appliance, in an environmentally conscious manner.
Preparation for assembly
Wall-mounted assembly
■
The instantaneous water heater must be fitted securely to
the wall. If required, secure the appliance using the lower
adjusting screws.
■
The distance from the wall is variable. This allows you to
compensate for any unevenness in the wall surface.
■
The sleeve in the rear panel must fit tightly round the con-
nection cable. If the sleeve is damaged during installation,
the holes must be sealed water-tight.
Water supply
■
The flow-through heater must be vented. Open the
warm water tap completely and allow to flow through
for one minute.
Electric supply
■
The mains connection can either be mounted above or
below. At least 40 mm of the connecting cord’s insulating
jacket must be clamped inside the appliance.
Startup
■
For low water line pressure, remove the flow limiter (see
Supplementary Information A).
■
Instruct the user with regard to the operation of the
instantaneous water heater.
■
Separate the required language version from the rest of
the operating instructions. This can be kept in the swing-
out control panel of the instantaneous water heater.
Additional inform ation
If the flow-through heater does not achieve adequate
flow as a result of water line pressure that is too low
in your house installation, remove the flow limiter.
Priority circuit for the combination with electro-
storage heating units:
For operation with the priority circuit, a special load
reducing relay (special accessory) is required. Other
already existing load reducing relays with the
exception of electronic load reducing relays could
cause malfunctions.
Status Indicator in the Heater
I.
LED Heater Status
Off Off
On Ready
Slow blinking (1/s) Heating
II.
III.
IV.
V.
VI.
A
B
C
GB

Produkt Specifikationer

Mærke: Dimplex
Kategori: Kedler & kedler
Model: DEE 2102

Har du brug for hjælp?

Hvis du har brug for hjælp til Dimplex DEE 2102 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Kedler & kedler Dimplex Manualer

Dimplex

Dimplex DES 2427 Manual

25 August 2024
Dimplex

Dimplex DEE 2427 Manual

25 August 2024
Dimplex

Dimplex DEE 2102 Manual

30 Juli 2024

Kedler & kedler Manualer

Nyeste Kedler & kedler Manualer

Daikin

Daikin EKHWSP180D3V3 Manual

9 April 2025
Daikin

Daikin SDGTB1209 Manual

9 April 2025
Daikin

Daikin SDGTB06 Manual

9 April 2025
SIME

SIME HOME PLUS Manual

1 April 2025
Corbero

Corbero CTEV350 Manual

10 Marts 2025
Corbero

Corbero CTM80 Manual

10 Marts 2025
Stiebel Eltron

Stiebel Eltron SHC 15 AU Manual

27 Februar 2025
Stiebel Eltron

Stiebel Eltron SNU 5 Plus Manual

27 Februar 2025
Stiebel Eltron

Stiebel Eltron DEM 6 Manual

27 Februar 2025
Stiebel Eltron

Stiebel Eltron DHCE 8/50 Manual

27 Februar 2025