Dito Sama 603797 Manual


Læs gratis den danske manual til Dito Sama 603797 (6 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 3 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 2 anmeldelser. Har du et spørgsmål om Dito Sama 603797, eller vil du spørge andre brugere om produktet?

Side 1/6
Standard all stainless steel equipment :
X Hook for kneading dough.
Y Paddle for mixing.
Z Whisk for emulsifying
1.1 DESCRIPTION
This electronic beater-mixer is a small appliance for bakery-pa-
tisserie and cooking designed for kneading, mixing and whipping
all kinds of food products all kinds of pastry ,stulling ,cream
conical push-t and square shaft of 12, type K). It is lightweight
and compact and easy to handle.
2.2 LOCATION
This beater mixer is designed to be tted on a stable, non-vibrating
worktop between 600 and 900 mm in height.
2.1 DIMENSIONS WEIGHT (FOR INFORMATION ONLY)
A Stainless steel bowl, 5.5 litre capacity
B Bowl cradle
C Safety guard
D Built-in accessories hub
E Cover
Introduction
Installation
- Gross weight packaged : 15 Kg
- Net weight with equipment : 12.6 Kg with tools
- Dimensions of packaging : 450 x 350 x 490 mm
- Machine overall dimensions : 388 x 280 x 438 mm
1.1b
Refer to the numbered drawings
that go with the numbered paragraphs in the instructions.
Introduction 1
Installation 1
Use, safety 2
Cleaning and hygiene 4
Fault nding 5
Maintenance 5
Conformity with regulations 6
Contents
GB
1
Electromix 5 GB 11 2023
2.1
1.1a
F Head
G On/O󰀨/Speed variation button
H Base
Introduction
The Operating Manual provides the user with useful information
or “appliance”).
The following should not under any circumstances be considered
as a long list of restrictive warnings, but rather as a set of instruc-
tions aimed at improving the performance of the machine in all
respects and particularly at preventing bodily injury or material
damage resulting from improper use and management.
It is essential that all the people responsible for transporting,
installing, commissioning, using, maintaining, repairing or dismant-
ling the machine should consult this manual and read it carefully
before proceeding with the various operations, in order to avoid
any incorrect or inappropriate handling likely to result in damage
to the machine or putting peoples safety at risk.
It is also important for the Manual to be ever available to the
operator and carefully kept at the workplace of the machine in
order to be easily and immediately consulted in the event of a
doubt or, in any case, as required.
If, after reading this Manual, you still have doubts or uncertainties
the Manufacturer or approved After-Sales Service who remain at
your disposal in order to guarantee a quick and thorough service
with a view to optimum operation and e󰀩ciency of your machine.
standards currently applicable in the country where the machine
is installed must always be applied during use of the machine.
Consequently, it is the users responsibility to ensure that the
machine is operated and used solely under the optimum safety
conditions laid down for people, animals and property.
The machine can be transported holding it either side of the cradle
with the guard shut. Do not use the control button as a handle.
11/2023
Use the machine in a sufficiently lit room (see technical
standard currently applicable in the country of use, for
Europe, refer to standard EN 12464-1)
THE REFERENCE LANGUAGE FOR THESE INSTRUCTIONS IS FRENCH.
2.3 ELECTRICAL CONNECTION
ATTENTION!!
Connection to the electrical power supply must be done according to proper professional practice by a qualied and authorised
person (see current standards and legislation in the country of installation).
If an adapter is used on the socket, a check must be made that the electrical characteristics of this adapter are not lower than
those of the machine.
Do not use multiple plugs
The AC power supply to the machine must comply with the following conditions (EN60204-1);
- Maximum voltage variation: ±10%
- Maximum frequency variation: ±1% on a continuous basis, ± 2% over short periods
ATTENTION: the electrical installation must comply (for design, creation and maintenance) with the legal and standard
requirements in the country where used.
- Check that the electric mains voltage, the value shown on the specication plate.
- The machine’s electrical power supply must be protected against voltage surges (short-circuits and excess voltages) using a
circuit breaker compliant with IEC60947-2 properly sized, of the appropriate gauge relative to the place of installation and machine
specications –
ATTENTION: Concerning protection against indirect contact (depending on the type of power supply provided and
connection of the exposed conductive parts to the equipotential protection circuit), refer to point 6.3.3 of EN 60204-1 (IEC
60204-1) with the use of protection devices for automatic shut-o󰀨 of power in the event of an insulation fault with a TN or
TT, system, or for the IT system, with the use of a permanent insulation or di󰀨erentials controller for automatic shut-o󰀨.
The requirements of IEC 60364-4-41, 413.1 must apply for this protection.
For example: in a TN or TT system, a di󰀨erential circuit breaker must be installed upline of the power supply, with a
suitable power cut-o󰀨 (e.g.: 30 mA) on the earthing installation for the place where it is planned to install the machine.
ATTENTION: Failure to comply with these instructions means the customer runs the risk of machine failure and/or acci-
dents due to direct or indirect contacts.
Electrical specications of machine:
This beater is to be supplied with single-phase current.
Provide an accessible standardized wall outlet with 2 poles +
ground, rated at 16A in accordance with IEC60309, and a cor-
responding waterproof plug to be installed on the power cord.
NO EARTH PLUG = NO PROTECTION = RISK OF
BREAKDOWN.
Voltage Rating Frequency Current
(V) (W) (Hz) (A)
220/240 500 50/60 2,3
The machine must be earthed using the green and yellow wire
Note: The earth values are dened according to the
residual dierential current. Non-compliance with these
instructions may result in invalidation of the warranty.
3.1 OPERATION - SAFETY
Use, safety
Read all the instructions.
- The appliance must be used by professional personnel.
- Do not put machine in water or any other liquid to avoid any
risk of electric discharge.
- Disconnect the plug of the appliance when not in use or before
any maintenance operation or cleaning.
- Check that the appliance is in position 0 when:
- it is not in use
- before attaching or removing tools, accessories
- before cleaning.
- Remove accessories and tools from beater before washing
- Never touch moving parts.
- Keep hands, hair, clothing, spatulas and other utensils away
from the tools when in operation to reduce any risk of injury
and/or damaging the appliance.
- Do not use the machine if:
- the cable or plug is damaged
- the safety component (guard) is faulty.
- the appliance has fallen or shows signs of damage.
Electromix 5 GB 11 2023
2


Produkt Specifikationer

Mærke: Dito Sama
Kategori: Ikke kategoriseret
Model: 603797

Har du brug for hjælp?

Hvis du har brug for hjælp til Dito Sama 603797 stil et spørgsmål nedenfor, og andre brugere vil svare dig