Doepfer A-101-1v Manual


Læs gratis den danske manual til Doepfer A-101-1v (6 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 27 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 14 anmeldelser. Har du et spørgsmål om Doepfer A-101-1v, eller vil du spørge andre brugere om produktet?

Side 1/6
doepfer System A - 100 Vactrol Multitype Filter A-101-1
1
1. Introduction Module A-101-1 is a special multitype filter based on
an idea by Nyle A. Steiner from the year 1974. Injecting
an audio signal into different points of a standard low
pass filter circuit leads to the three filter types low pass
(LP), band pass (BP) amd high pass (HP). For each
filter type a separate input is available and the sum of
the three filtered signals appears at the common out-
put. Even a notch filter can be realized.
In contrast to the original circuit so-called vactrols are
used instead of diodes as variable resistors for fre-
quency and resonance control. A vactrol is a combi-
nation of a light depending resistor (LDR) and a light
emitting diode (LED) both put into a small light-proof
case. Vactrol based circuits are known for their soft
low-distortion sound. For details about vactrols and
the A-101-1 circuit principles please use the correspon-
ding links in the A-101-1 info page on our web site
www.doepfer.com.
The three filter audio inputs are normalled via swit-
ching sockets, i.e. the BP input is connected to the LP
jack socket provided that no cable is plugged into the BP
socket (same applies for HP/BP inputs). Each audio
input is equipped with an attenuator. The audio inputs
are very sensitive and enable distorted sounds too.
For both frequency and resonance manual control and
several control voltage inputs are available.
Two LEDs display the current frequency and reso-
nance settings.
A-101-1 Vactrol Multitype Filter System A - 100 doepfer
2
Controls:
1 Frequency manual frequency control
2 CVF2 attenuator for FCV input "
3 CVF3 attenuator for FCV input §
4 Emphasis manual resonance control
5 CVQ2 attenuator for QCV input %
6 LP attenuator for LP audio input &
7 BP attenuator for BP audio input /
8 HP attenuator for HP audio input (
9a/b LED controls for frequency and resoance
Inputs / Outputs:
! CVF In 1 frequency control voltage input 1
" CVF In 2 frequency control voltage input 2
§ CVF In 3 frequency control voltage input 3
$ CVQ In 1 resonance control voltage input 1
% CVQ In 2 resonance control voltage input 2
& LP In low pass audio input
/ BP In band pass audio input
( HP In high pass audio input
)a Out 1 audio output 1
)b Out 2 audio output 2
2. Overview
&
/
(
)a
)b
!
"
§
$
%
1
2
3
4
5
6
7
8
9a
9b


Produkt Specifikationer

Mærke: Doepfer
Kategori: Ikke kategoriseret
Model: A-101-1v

Har du brug for hjælp?

Hvis du har brug for hjælp til Doepfer A-101-1v stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Doepfer Manualer

Doepfer

Doepfer A-100 Manual

1 September 2024
Doepfer

Doepfer Dark Link Manual

21 August 2024
Doepfer

Doepfer A-196 Manual

20 August 2024
Doepfer

Doepfer A-134 Manual

20 August 2024
Doepfer

Doepfer A-135-2v Manual

19 August 2024
Doepfer

Doepfer A-145 Manual

19 August 2024
Doepfer

Doepfer A-101-2 Manual

19 August 2024
Doepfer

Doepfer A-99 Manual

19 August 2024
Doepfer

Doepfer A-103 Manual

19 August 2024
Doepfer

Doepfer A-165 Manual

18 August 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer