1. Be Sure to carefully read and understand the instructions
before attempting to install these speakers.
2. For safety, disconnect the negative battery terminal from the battery
prior to beginning the installation.
3. For easier assembly, we suggest you run all wires prior to mounting speaker in place
4. Use high quality connectors for a reliable installation and to minimize signal or power loss
5. Think before you drill. Be careful not to cut or drill gas tanks, fuel lines, brake or hydraulic
lines, vacuum lines or electrical wiring when working on any vehicle. If installing in a boat,
take care not to cut or drill through the mail hull.
6. Never run wires underneath the vehicle. Running the wires inside the vehicle or hull
area provides the best protection.
7. Avoid running wires over or through sharp edges. Use rubber or plastic grommets to
protect any wires routed through metal - especially the firewall.
1. Determine where the speakers will be mounted. Ensure an area large enough for the
speaker to mount evenly. Be sure that the mounting location is deep enough for the
speaker to fit; only mount to a flat surface. Use extra caution when mounting on panels
2. Refer to the specification chart to determine the proper diameter hole to cut for the speaker.
3. Mark the locations for the mounting screws. Drill the holes with a 0.75” bit.
4. Feed the speaker wires through the cutout and connect to the speaker terminals. Be sure
to observe proper polarity when connecting the wires. The speaker’s positive terminal is
5. Fit the speaker and mount into place using six (6) screws.
6. Tighten the screws until the speaker is in place.
12” Marine & Motorsports Subwoofer
1 x 1.5M #16 Speaker Input Wired with Fast Terminal
1 x 1.5M #22 RGB LED Power Input Wired with Fast Terminal
6 x M5.2 Phillips Inner Hex Head 304 Stainless Steel (4mm Hex Tool)
MARINE & MOTORSPORTS 12” SUBWOOFER
IP65 Marine Grade Compliant 100% UV Stable
Continuous Power Handling: 350W RMS
Peak Music Power: 700W MAX
Nominal Impedance: 4 Ohms
Frequency Response: 30Hz-500Hz
Y35 Ferrite Main Magnet and Reverse N40H (Neodymium) Magnet
Integrated LED-RGB Lighting
Waterproof Injection PP Cone
Injection ASA Grill with Gloss UV-Coating
PC Injection Molded Composite Basket with Gloss UV-Coating
BT Control Module & App (LED-BTC) For Multi-Function for
RGB LED Lighting (sold separately)
Mounting Depth: 5.75"/146mm
Cut-Out Diameter: 10.71"/272mm
Overall Diameter: 12.81"/325.3mm
Overall Height: 7.68"/195mm
