DSC WS4949 Manual

DSC Fjernbetjening WS4949

Læs gratis den danske manual til DSC WS4949 (7 sider) i kategorien Fjernbetjening. Denne vejledning er vurderet som hjælpsom af 40 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 20.5 anmeldelser. Har du et spørgsmål om DSC WS4949, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/7

WS4949 Wireless Panic Button

Operating Instructions

Introduction

The WS4949 is a 2 button, 3 function remote that can be

used to arm and disarm as well as a variety of other

remote functions. Please discuss all WS4949 options with

your installer in order to program the best possible com-

bination to suit your needs.

NOTE: Signals will not be received if the key is not within the

range of the wireless receiver.

Operation of the WS4949

To activate function 1 or 2 press and hold the appropriate

button for approximately 1 second. For function 3 press and hold both buttons for approxi-

mately 3 seconds. The LED located between buttons 1 and 2 will light up indicating a sig-

nal has been sent to the control panel receiver. The typical functions are as follows:

Away Arming

Press this button to arm your system in the Away mode. Both the interior and

exterior zones will be armed, allowing you to exit the premises.

Disarm

Press this button to disarm your system. You do not have to enter your access

code when you use the key to disarm the system.

Panic

Press and hold both buttons to notify your central monitoring station of a situation

requiring the police, such as a break-in (requires a monitored account).

NOTE: By default, the user must press and hold the buttons for 3 seconds to activate the panic function.

How to Enroll the WS4949

This section describes how to set up and program your remote and should be done by the

installer. When programming the functions keys in the receiver, Function Key #1 is not used

for the WS4949.

• Button 1 (Left Button) sends Function Key #2

• Button 2 (Right Button) sends Function Key #3

• Both buttons pressed simultaneously and held for 3 seconds sends Function Key #4

The following outlines the basic steps for programming and enrolling this device on

PowerSeries receivers. For additional options or for other receivers please refer to the

specific receiver installation manuals.

Step 1 - Program Electronic Serial Number (ESN)

Section [804], subsections [41] - [56]

[41] Key #1 |______|______|______|______|______|______| . . . [56] Key #16 |______|______|______|______|______|______|

Step 2 - Program Function Buttons

Section [804], subsections [59] - [60]

For the RF5501-433 v5.0 Receiver, Section [804], subsections [61] - [68]*

Button 1 Button 2

[59] Paritition 1 Wireless Key Options *[61] Partition 1 Wireless Key Options (RF5501-433)

Replacing the Batteries

Under normal conditions the batteries can last from 5-8 years. If

the battery is low, the trouble light on the keypad will turn ON.

To replace the batteries, remove the top cover by inserting a

coin into the slot located on the bottom right corner and twist.

Remove the screw at the center of the board to expose the bat-

teries. Replace both batteries with Panasonic CR-2025 lithium

batteries (see diagram).

NOTE: The polarity of the battery must be observed, as shown in the diagram above. Improper han-

dling of lithium batteries may result in heat generation, explosion or fire, which may lead to per-

sonal injuries.

WARNING: Danger of explosion if batteries are installed incorrectly. Replace only with the

same or equivalent type recommended by the manufacturer. Keep away from small children.

If batteries are swallowed, promptly see a doctor. Do not try to recharge these batteries. Dis-

posal of used batteries must be made in accordance with the waste recovery and recycling

regulations in your area.

Compatibility

Please refer to the installation sheets of the following receivers for more information. The

WS4949 is compatible with the following receivers:

• PC5132-433 • PC4164-433 • RF5501-433

• NT9005-433 • RF5108-433

Specifications

• 32°to 120°F (0°-49°C)

• 5-93% RH

• Water Resistant

FCC COMPLIANCE STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)

This device may not cause harmful interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

IC 160A-WS4949: The term 'IC:' before the radio certification number only signifies that Industry Canada

technical specifications were met.

0 0 Button 1 Not used for WS4949 0 0 Button 1 Not used for WS4949

0 4 Button 2 Away Arming 0 4 Button 2 Away Arming

2 7 Button 3 Disarm 2 7 Button 3 Disarm

3 0 Button 4 Panic 3 0 Button 4 Panic

Panasonic

CR2025

Toronto, Canada • www.dsc.com

Tech Support: 1-800-387-3630, 905-760-3036

Printed in Taiwam

2 9 0 0 7 0 5 0 R0 0 2

Produkt Specifikationer

Mærke:	DSC
Kategori:	Fjernbetjening
Model:	WS4949

Har du brug for hjælp?

Hvis du har brug for hjælp til DSC WS4949 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Fjernbetjening DSC Manualer

DSC WS4949 Manual

8 Oktober 2024

DSC WS4939 Manual

1 September 2024

Fjernbetjening Manualer

Nyeste Fjernbetjening Manualer

Insignia NS-RMT8D21 Manual

29 September 2025

ProMaster PRO5439 Manual

29 September 2025

Insignia NS-RMTVIZ21 Manual

29 September 2025

ProMaster PRO7599 Manual

29 September 2025

ProMaster PRO1782 Manual

29 September 2025

ProMaster PRO7337 Manual

29 September 2025

ProMaster PRO7606 Manual

29 September 2025

Neets 310-0350 Manual

29 September 2025

Nikon MC-DC3 Manual

28 September 2025

Neets 310-0202 Manual

27 September 2025