•
DMP672/DMP672B
INSTALLATION
Preparation/Installation
Please read entire manual before installation.
Before
You
Start
• Disconnect negative battery terminal. Consult a qualified technician
for
instructions.
• Use extreme caution when drilling holes to avoid damaging fuel lines. hydraulic lines
or
existing wiring.
•
If
additional
wiring
is
required.
we
recommend that you run
all
wires
prior
to
mounting your speaker in place.
• Use the highest quality connectors
for
a reliable installation and to minimize signal
and power loss.
• Use caution before you drill
or
cut!
Be
careful not to cut
or
drill
into gas tanks. fuel lines.
hydraulic lines. vacuum lines
or
electrical wiring.
• Avoid running
wires
over. near.
or
through sharp edged surfaces.
We
suggest you
also use rubber grommets
to
protect any wires routed through metal.
Mounting
and
Installation
• Determine where the speakers
will
be
mounted. Ensure an area large enough for
the speaker to mount evenly.
Be
sure the mounting location
is
deep enough
for
the
speaker to fit.
• Using an appropriate tool. cut a 5.13" diameter mounting hole.
• Remove grille from speaker by inserting the release key into the locking tab slots
located at the top and bottom of the grille. Gently apply pressure towards the center
of
the grille to release the locking tabs.
• Use the speaker as a template to
mark
the locations for the mounting screws. Drill
the mounting screw holes with a 1 /8" pilot bit. Route speaker
wires
and connect to
speakers. observing speaker polarity.
• Install speaker into opening using supplied hardware and test
for
correct operation.
• Align the speaker
grille
locking tabs and snap
grille
into place.
RELEASE
KEY
0
TYPICAL
MOUNTING
2