•Images are for illustrative purposes only and may dier from the actual product.
•For the need of technical improvement and system upgrade, information and specications
contained herein may be slightly dierent from actual product. If any dierence is found, the
EN Impoant safety instruction
•Please read the instructions carefully. Keep it in safe place for future reference.
•Use only accessories approved by the manufacturer.
•Install the instrument properly by following the instructions in the device connection section.
•Using the product in a 0-45°C environment is recommended. Shipping and storing the
product in a 0-45°Cenvironment is recommended.
•To reduce the risk of re and electric shock, do not expose the product to rain or moisture.
•Do not use this product near water. Do not immerge the product into any liquid or have it
exposed to dripping or splashing.
•Do not install or use this product near any heat source (e.g. radiator, heater, stove, or other
devices that generate heat).
•Do not place any object lled with liquids, such as vases on the product; neither should any
open re, such as lighted candles be placed on the product.
•Do not block any ventilation openings. Do not inse any object into ventilation openings or
slots. It may cause re or electric shock.
•Keep sucient clearance around the product to maintain good ventilation (minimum 5cm
•Do not force a plug into the jack. Before connection, check for blockage in the jack and
whether the plug matches the jack and is oriented to the right direction.
•Keep the provided accessories and pas (such as screws) away from children to prevent
from being swallowed by mistake.
•Do not open or remove the housing yourself. It may expose you to dangerous voltage or
other hazardous risks. Regardless the cause of damage (such as damaged wire or plug,
exposure to liquid splash or foreign object falling in, exposure to rain or moisture, product
not working or being dropped, etc.), the repair has to be peormed by an authorized
seice professional immediately.
•Before cleaning the product with d cloth, always turn o the product and disconnect
•Never use strong acid, alkali, gasoline, alcohol, or other chemical solvents to clean the
product suace. Use only neutral solvent or clear water for cleaning.
•The product must be used at an altitude of lower than 2000m.
•Wireless product may generate showave radio frequencies and inteere with the normal
use of other electronic devices or medical equipment.
•Turn o the product when it’s disallowed. Do not use the product in medical facilities,
on airplane, at gas stations, near automatic gates, automatic re alarm system or other
•Do not use the product in the vicinity of a pacemaker within a 20cm range. The radio waves
may aect the normal operation of the pacemaker or other medical devices.
Excessively loud music may lead to hearing loss. Please keep the volume in a safe range.
Correct Disposal of this product. This marking indicates that this product should not be
disposed with other household wastes. To prevent possible harm to the environment or
human health from uncontrolled waste disposal, recycle it responsibly to promote the
sustainable reuse of material resources. To return your used device, please use the
return and collection systems or contact the retailer where the product was purchased.
They can take this product for environmental safe recycling.
This symbol indicates that the product is for indoor use only.
1. Mode Indicator/Light Eect
Red: USB audio streaming input
Press and hold: power on/o
Press: switch USB audio streaming/
Press and hold: light eects on/o
Press: switch light eects
Press and hold: previous track
Press and hold: disconnect Bluetooth
and clear pairing records (Bluetooth
Press and hold: next track
1. When in USB audio streaming input or connected to a Bluetooth device, the mode indicator
is steady lit, and the light eect will be lit after 5s; When in Bluetooth mode and if no devices
are connected, the lightbar will blink in Blue continuously.
2. If the light eect is turned o, the corresponding mode indicator (Red/Blue color) will blink
once when operating the buttons on the speaker; if the light eect is turned on, the
corresponding light eect color will blink once when operating the buttons on the speaker.
3. Restore to facto settings: press and hold "+" and "-" buttons for 3s simultaneously.
1. Inse the USB cable from the speaker into the USB po on a computer, the speaker will
2. Press the " " button to switch to USB audio streaming input. Red LED will be steady lit,
and the light eect indicator will be lit after 5s.
3. For USB audio streaming input, the microphone built in the speaker is used as your
computer's microphone for voice recording or phone calls.
1. Inse the USB cable from the speaker into the USB po on a computer, the speaker will
2. It is USB audio streaming input by default when the speaker is powered on for the rst time.
3. After the computer auto-install USB audio streaming driver, the speaker is ready to use.
1. Manual switching of devices is required for Mac users in USB audio streaming mode.
Please open the sound settings of the Mac operating system and select "EDIFIER MG250"
2. In USB audio streaming mode, the speaker does not suppo volume sync. If need to adjust
the volume, please separately adjust the speaker volume and the computer volume.
● USB audio streaming connection
1. To enjoy all Bluetooth functions of this product, please ensure your audio source device
has A2DP, HFP and AVRCP proles.
2. Pin code for connection is "0000" if needed.
Blue LED blinks slowlyBluetooth in pairing
Blue LED is steady lit for 5s,
then the ambient lightbar will be lit
The speaker is connected to mobile phone through Bluetooth and there is an incoming call:
•press and hold the " " button to reject call
•press the " " button to answer call
•when in a conversation, press the " " button to end call
1. Power on and press the " " button to switch to Bluetooth input.
2. Select "EDIFIER MG250" in your device setting to connect.
3. Bluetooth speakerphone
Press to switch to Bluetooth input
1. Scan the QR code for the app.
2. Install Edier Connect app from App Store or Google Play.
Download Edier Connect app
Total output power: 2.5W+2.5W
Frequency response: 80Hz-19kHz
Frequency Band: 2.402GHz ~ 2.480GHz
RF Power output: ≤10 dBm (EIRP)
There is no restriction of use.
Cannot nd "EDIFIER MG250" in Bluetooth mode
•Ensure the speaker is powered on.
•Ensure the speaker is in Bluetooth mode.
•Disconnect from any Bluetooth device by pressing and holding the " " button on the speaker, and
search "EDIFIER MG250" again.
•Disconnect the speaker from the power source and reconnect, switch to Bluetooth mode and search
for "EDIFIER MG250" again.
Sound break occurs in Bluetooth mode
•Ensure the Bluetooth device is within the eective operating range and there are no obstacles
between the speaker and the Bluetooth device.
No sound from the speaker
•Ensure the USB power is connected.
•Ensure the signal output from the audio source is normal.
•If the volume of the speaker or audio source is too low, turn up the volume.
•Disconnect the speaker from the power source and reconnect.
•Manual switching of devices is required for Mac users in USB audio streaming mode. Please open
the sound settings of the Mac operating system and select "EDIFIER MG250" as the output device.
Noise coming from speakers
•EDIFIER speakers generate little noise, while the background noise of some audio devices are
too high. Please unplug audio cables and turn the volume up, if no sound can be heard at 1
meter away from the speaker, then there is no problem with this product.
To learn more about EDIFIER, please visit www.edier.com
For EDIFIER warranty queries, please visit the relevant count page on www.edier.com and
review the section titled Warranty Terms.
USA and Canada: seice@edier.ca
South America: Please visit www.edier.com (English) or www.edierla.com (Spanish/Pouguese)
for local contact information.
@Edier_Global @Edier_Global@Edierglobal
For more information, please visit our website:
Edier International Limited
© 2023 Edier International Limited. All rights reseed.
For the need of technical improvement and system upgrade, information contained herein may be subject
to change from time to time without prior notice.
Products of EDIFIER will be customized for dierent applications. Pictures and illustrations shown on this
manual may be slightly dierent from actual product. If any dierence is found, the actual product prevails.
