Edifier T5s Manual

Edifier Subwoofer T5s

Læs gratis den danske manual til Edifier T5s (7 sider) i kategorien Subwoofer. Denne vejledning er vurderet som hjælpsom af 46 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 23.5 anmeldelser. Har du et spørgsmål om Edifier T5s, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/7

Powered Subwoofer

T5s

Quick Sta Guide

Model: EDF100100

1. What’s in the box?

2. Standby & wake-up

3. Cable connection

4. Setup

5.Specications

6.Troubleshooting

RCA to RCA audio cable

3.5mm - RCA audio cable

Power cable

Subwoofer

Impoant safety

instructions

Quick sta guide

①

②

Note:

•Images are for illustrative purpose only and may differ from the actual product.

•For the need of technical improvement and system upgrade, information and

specifications contained herein may be slightly different from actual product.

If any difference is found, the actual product prevails.

Power on: Switch the main power button on the rear panel to "ON".

Power off: Switch the main power button to "OFF".

Note:

* Power input: 100-240 V~ 50/60 Hz 400 mA

* This plug type is meant for illustration purpose only.

•If there is no audio signal input in 15 minutes, the subwoofer will enter standby

mode automatically (red LED steady lit). If audio signal input resumes, the

subwoofer will wake up automatically (green LED steady lit).

Note:

•Do not connect the subwoofer to the power output terminal of a powered

amplifier device.

•Unplug the power cables of subwoofer and audio source device from the wall

outlet prior to any connections.

Method 1:

If the main speaker system has a port for connecting an external subwoofer,

connect the port on the main speaker system and the Signal In ports on this

subwoofer, and then connect the main speaker system and the audio source

device.

Method 2:

If the main speaker system has no port for connecting an external subwoofer,

connect the audio input port on the main speaker system and the Signal Out

ports on this subwoofer, and then connect the Signal In ports on this subwoofer

and the audio output port on the audio source device.

Volume adjustment

Note: If the audio source device has a bass gain control, adjust it to 0dB before

setup.

1. Set the volume of this subwoofer to the minimum.

2. Set the volume of the audio source device to a desired level.

3. Set the volume of the main speaker system to a desired level.

4. Adjust the volume of this subwoofer to match the volume of the main speaker

system.

5. After the setup is complete, adjust the audio source device’s master volume to

control the subwoofer and the main speaker system’s volume simultaneously.

Low-pass filter adjustment

•If the audio source device is equipped with a low-pass filter, rotate the LPF

knob on the subwoofer to the rightmost. The crossover point is determined by

the audio source device.

•If not, rotate the LPF knob to set the crossover point. Only frequencies below

the set point are transmitted to the subwoofer driver.

Tips: If the main speaker system has a speaker over 4 inches, set the crossover

point of the subwoofer to 50~90 Hz. Otherwise, set the crossover point to

90~150 Hz. The smaller the speaker of the main speaker system, the higher the

crossover frequency of the subwoofer should be.

Phase selection

Switch the phase selector to 0° or 180° to obtain optimal bass performance at the

listening position.

Total output power (RMS): 70 W

Frequency response: 35 Hz~115 Hz

No power

•Make sure that the power cable is properly connected.

•Make sure that the power supply is not disconnected.

No sound

•Make sure that this product and your device is properly connected.

•Make sure that the correct audio input source is selected.

•Make sure that the playback is not paused.

•Increase the volume of this product and your device.

Noise coming from speakers

•EDIFIER speakers generate little noise, while the background noise of some

audio devices are too high. Please unplug audio cables and turn the volume

up. If no sound can be heard at 1 meter away from the speaker, there is no

problem with this product.

To learn more about EDIFIER, please visit www.edier.com

For EDIFIER warranty queries, please visit the relevant count page on

www.edier.com and review the section titled Warranty Terms.

USA and Canada: seice@edier.ca

South America: Please visit www.edier.com (English) or

www.edierla.com (Spanish/Pouguese) for local contact information.

Produkt Specifikationer

Mærke:	Edifier
Kategori:	Subwoofer
Model:	T5s

Har du brug for hjælp?

Hvis du har brug for hjælp til Edifier T5s stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Subwoofer Edifier Manualer

Edifier T5s Manual

20 August 2025

Subwoofer Manualer

Nyeste Subwoofer Manualer

Martin CW112 F Manual

16 November 2025

Martin CW110 F Manual

15 November 2025

Martin CW112 C Manual

15 November 2025

Martin ViroSub Manual

11 November 2025

Earthquake Sound MiniMe DSP P-10 Manual

11 November 2025

Martin TXS 18 Manual

10 November 2025

Monoprice SSW-8 Manual

7 November 2025

Earthquake Sound Nova FF6.5 Manual

6 November 2025

Eton RES 10 AR Manual

4 November 2025

Earthquake Sound Nova FF12 Manual

2 November 2025