Eliminator Lighting Amber Fog 700 LED Manual

Eliminator Lighting Ikke kategoriseret Amber Fog 700 LED

Læs gratis den danske manual til Eliminator Lighting Amber Fog 700 LED (3 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 14 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 7.5 anmeldelser. Har du et spørgsmål om Eliminator Lighting Amber Fog 700 LED, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/3

07/18/2022

- 2 -

Warning:

- The smokemachine must be placed at least 100 cm away from inammable materials such as curtains,

books, etc. Make sure that the housing cannot be touched by accident.

- Use only water-based smoke uid recommended by your dealer. sinfen

- Poor smoke liquid caused permanent damage, bad eect, clogging, spitting of unevaporated liquid etc.

- Never add ammable uids (oil, gas, perfume) to the fog liquid.

- Always keep enough smoke liquid in the tank.

Use of the device without liquid will cause damage to the pump and heater.

- Do not obstruct the openings on top of the case to guarantee a good ventilation.

- ut any objects on the smoke machine. Don’t p

- For indoor use only.

- During installation, nobody should stand beneath the mounting area.

- Prior to the rst use, have the unit checked by a qualied person.

- The unit contains voltage carrying parts. DO NOT open the smokemachine

- Never plug or unplug the unit with wet hands.

- If the plug and/or mains lead are damaged, they need to be repaired by a qualied technician.

- If the unit is damaged to an extent that you can see internal parts, do not plug the unit into a mains outlet. It

needs to be repaired by a qualied technician.

- Only connect this unit to an earthed mains outlet of 220- Vac/50Hz . 240

- Always unplug the unit during a thunderstorm or when it is not in use.

- If the unit has not been used for a longer period of time, condensation can occur inside the housing. Please

let the unit reach room temperature prior to use.

- When you unplug the unit from the mains always pull the plug, never the lead.

- In order to prevent dropping of the unit, a safety fastening needs to be installed. This can be a solid chain, a

steel cable, etc. which has to be fastened separately from the mounting bracket.

- The supplied bracket is the main xing and must be used to solidly mount the light eect.

- In order to avoid accidents in public premises, the local legal requirements and safety regulations/warnings

must be fullled.

- Keep out of the reach of children.

Location

Select a location where it is easy to ll the tank. It is also possible to hang the unit by means of the supplied

holder and xing screws.

Intro : A compact 700W smoke machine with orange LEDs for an astonishing and unique flame eect while

producing fog. The smoke machine has a built in reservoir for the smoke uid. The LEDs flame eect can be

switched o on the back of the smoke machine. Smoke production can be activated on the supplied remote

control.

Installation and Use

Unpack the fog machine. Do not connect yet the net cable. Fill the uid tank by means of a funnel. Plug the unit

into a mains outlet. Thus the heating element is automatically switched on. Depending on the room temperature,

it takes about 3 minutes until the working temperature is reached. Then the thermostat is clicking and the LED

on the manual control lights up. Push the switch once and the smoke machine will produce a nice thick fog.

Once the smoke machine has reached its working temperature (the LED is lit) the smoke machine can produce

fog for a while. After this period of time, the fog generator is cooled so much down that the thermostat switches

o. Wait a while until the working temperature is reached again. It is recommended to produce smoke with small

pauses in between so that the temperature is maintained and th e thermostat doesn’t switch off.

Make sure that there is always enough liquid smoke contained in the tank. Use of the smoke machine without

liquid can permanently damage the unit. Once the smoke machine generates little smoke or pump generate

another 'rattling' sound i turn o the unit direct. Check the uid level and ll the tank when it is empty, check the

hose and lter blockages and restore it. Plug in the unit and check if the problem is resolved. If problem persists,

switch unit direct off to prevent further damage and contact your dealer.Switching the unit off :Switch the unit off

by unplugging it from the mains. Otherwise the 700W heating element will draw unnecessarily current.

Produkt Specifikationer

Mærke:	Eliminator Lighting
Kategori:	Ikke kategoriseret
Model:	Amber Fog 700 LED

Har du brug for hjælp?

Hvis du har brug for hjælp til Eliminator Lighting Amber Fog 700 LED stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Eliminator Lighting Manualer

Eliminator Lighting MBMHD1 Manual

30 Maj 2025

Eliminator Lighting Furious Three RG UV Manual

28 December 2024

Eliminator Lighting SC8 II PAD SYSTEM Manual

19 November 2024

Eliminator Lighting Bubbletron EX Go Manual

4 September 2024

Eliminator Lighting Mister Kool EP Manual

3 September 2024

Eliminator Lighting BUBBLETRON EX Manual

3 September 2024

Eliminator Lighting UVLED 48EL Manual

3 September 2024

Eliminator Lighting Micro Galaxian Three Manual

3 September 2024

Eliminator Lighting VF Snow Flurry HO EP Manual

3 September 2024

Eliminator Lighting BUBBLETRON EXL Manual

3 September 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Tripp Lite Protect It! TLP606 Manual

30 Juli 2025

AMX NMX-WP-N2510 Manual

30 Juli 2025

Yealink SIP-T23G Manual

30 Juli 2025

Rothenberger ROBEND 4000 Manual

30 Juli 2025

Tripp Lite SUPDMB710 Manual

30 Juli 2025

Tripp Lite IBAR6ULTRAUSBB Manual

30 Juli 2025

Advantech PCM-34R1TP Manual

30 Juli 2025

Tripp Lite SRIN4141410 Manual

30 Juli 2025

Tripp Lite TLM609GF Manual

30 Juli 2025

Tripp Lite Protect It! TLP368CUBEUAM Manual

30 Juli 2025