
zdroj: m:\INDESIGN\_Skupinove navody Vanoce\manual_23_multifunkcni_remote.indd 105 × 148 mm
GB | Christmas LED Lights
Do not connect the chain to power supply if it
Light sources are not replaceable.
Do not connect another light.
When handling, disconnect from the power
In case of malfunction, do not remove bulbs and
Do not interfere with the connection.
Use only with the power source supplied with
Suited for both indoor and outdoor use.
Should the light source rupture or become
damaged, do not use the light chain or leave it
connected to the power supply. Instead, dispose
of it in a safe, environment-friendly way.
The product is designed for decorative lighting.
The product is not a toy; do not put it in the
WARNING – THIS LIGHT CHAIN MUST NOT BE USED WITHOUT THE APPROPRIATE GASKETS!
WARNING – RISK OF INJURY BY ELECTRICAL CURRENT! DO NOT USE WITH MISSING OR DAMAGED
The light chain can be switched to eight dierent light modes by repeatedly short pressing the
button on the transformer or pressing the corresponding button on the controller:
1. Automatic rotation between the dierent modes.
2. Flashing at a 0.5 s interval, then at a ca 0.25 s interval.
3. Alternating between fast and slow ashing.
4. Slow lighting up and dimming of LEDs including gradual transition.
5. Flashing at a 1 s interval, then at a ca 0.5 s interval.
6. Slow lighting up and dimming of all LEDs.
7. Rapid alternating ashing, then all LEDs light up and switch o.
The light chain can be switched to eight dierent light modes using the remote.
Remove the protective battery foil from the rear of the remote before use.
TIMER – pressing this button turns the chain on for 6 hours. The chain then automatically turns o
for 18 hours. The chain will run automatically in these intervals (6 hours on/18 hours o) until
turned o using the OFF button. If the „TIMER“ function is active, a red light (LED) will glow on
DIM – changes light intensity
1 – 8 buttons for switching to dierent lighting modes