Emos E6018 Manual
Emos
Vejrstation
E6018
Læs nedenfor 📖 manual på dansk for Emos E6018 (76 sider) i kategorien Vejrstation. Denne guide var nyttig for 23 personer og blev bedømt med 4.7 stjerner i gennemsnit af 12 brugere
Side 1/76
2606162000_31-E6018_00_01_WEB 105 × 148 mm
E6018
GB Wireless Weather Station
CZ Bezdrátová meteostanice
SK Bezdrôtová meteostanica
PL Bezprzewodowa stacja meteorologiczna
HU Vezeték nélküli meteorológiai állomás
SI Brezžična meteorološka postaja
RS|HR|BA|ME Bežična meteorološka stanica
DE Drahtlose Wetterstation
UA Бездротовий метеорологічний пристрій
RO|MD Staţie meteorologică fără r
LT Belaidė meteorologinė stotelė
LV Bezvadu meteoroloģiskā stacija
EE Juhtmevaba ilmajaam
BG Безжична метеорологична станция
FR Station météo sans l
IT Stazione Metereologica Wireless
ES Estación meteorológica inalámbrica
NL Draadloos weerstation
www.emos.eu
4
wireless sensor: transmission frequency 433 MHz, 10 mW e.r.p. max.
station power supply: 3× 1.5 V AAA batteries (not included)
adapter AC 230 V/DC 5 V, 300 mA (included)
sensor power supply: 2× 1.5 V AAA (not included)
station dimensions and weight: 17 × 192 × 127 mm, 364 g
sensor dimensions and weight: 15 × 62 × 100 mm, 54 g
Getting Started
1. Connect the adapter to the station, then insert batteries rst into the weather station (3× 1.5 V
AAA), then into the wireless sensor (2× 1.5 V AAA). The battery compartment of the sensor is
protected by screws; use a suitable screwdriver.
2. When inserting the batteries make sure the polarity is correct to avoid damaging the weather
station or sensor. Only use alkaline batteries of the same type; do not use rechargeable batteries.
3. Place the two units next to each other. The weather station will automatically detect the sensor
signal within 3 minutes. If signal from the sensor is not detected, long-press the button on
the weather station to repeat the search.
4. We recommend placing the sensor on the north side of the house. The range of the sensor may
decrease substantially in areas with large number of obstacles.
5. The sensor is resistant to dripping water; however, it should not be exposed to sustained rain.
6. Do not place the sensor onto metal objects as this will reduce its transmission range.
7. If the low battery icon is displayed, replace batteries in the sensor or weather station.
Switching Channel and Connecting Additional Sensors
1. Choose the desired channel 1, 2, or 3 for the sensor by repeatedly pressing the button. Then,
long-press the button; the icon will start ashing.
2. Unscrew the cover from the battery compartment on the rear of the sensor and set the sensor
switch to the desired sensor channel number (1, 2, 3), then insert batteries (2× 1.5 V AAA). Data
from the sensor will be loaded within 3 minutes.
3. If sensor signal is not found, remove the batteries and proceed again in accordance with steps
1 and 2 or press the TX button.
Displaying Data from Multiple Sensors, Automatic Cycling through Values from
Connected Sensors
Press the button repeatedly to display data from all connected sensors on the weather station,
one by one.
You can also activate cycling through data from all connected sensors:
1. turning on cycling
Repeatedly press the button until the display shows the icon.
Data from all 3 sensors will be shown automatically and repeatedly one after another.
2. turning o cycling
Repeatedly press the button until the icon disappears.
Radio Controlled Clock (DCF77)
The wireless sensor will automatically start searching for DCF77 (hereinafter referred to as DCF)
signal for 5 minutes after pairing with the weather station; the icon is ashing. (The DCF sensor
is located in the sensor).
Signal detected – the icon stops ashing and displays the current time with the DCF icon .
Signal not detected – DCF icon will not be displayed. DCF signal will be synchronised daily between
2:00 and 3:00 am.
Note: If the weather station detects DCF signal but the current time on the display is incorrect (e.g.
shifted ±1 hour), you must always set the correct time zone for the country where you are using the
station, see Manual Settings.
In standard conditions (at safe distance from sources of interference, such as TV sets or computer
monitors), the reception of time signal takes several minutes. If the weather station does not detect
the signal, follow these steps:
Produkt Specifikationer
| Mærke: | Emos |
| Kategori: | Vejrstation |
| Model: | E6018 |
Har du brug for hjælp?
Hvis du har brug for hjælp til Emos E6018 stil et spørgsmål nedenfor, og andre brugere vil svare dig
Vejrstation Emos Manualer
14 December 2024
13 December 2024
13 December 2024
10 August 2024
10 August 2024
2 August 2024
1 August 2024
31 Juli 2024
29 Juli 2024
28 Juli 2024
Vejrstation Manualer
- Vejrstation Rebel
- Vejrstation Balance Meteo
- Vejrstation MOOOV
- Vejrstation EMOS SELECT
- Vejrstation UPM
- Vejrstation Ease Electronicz
- Vejrstation Vimar
- Vejrstation Jacob Jensen
- Vejrstation Brigmton
- Vejrstation Inovalley
- Vejrstation Daikin
- Vejrstation Cotech
- Vejrstation Ytora
- Vejrstation Otio
- Vejrstation Trevi
Nyeste Vejrstation Manualer
30 Maj 2025
14 Marts 2025
9 Marts 2025
9 Marts 2025
9 Marts 2025
9 Marts 2025
9 Marts 2025
9 Marts 2025
9 Marts 2025
9 Marts 2025