Emos KT2244 Manual

Emos Ikke kategoriseret KT2244

Læs gratis den danske manual til Emos KT2244 (8 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 46 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 23.5 anmeldelser. Har du et spørgsmål om Emos KT2244, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/8

Beta400

GB TILT WALL MOUNT

CZ NAKLÁPĚCÍ DRŽÁK

SK NAKLÁPACÍ DRŽIAK

PL UCHWYT PRZECHYLNY

HTILT FALI TARTÓ

SLO

NASTAVLJIVO DRŽALO

DKLAPPBARER HALTER

UA КРОНШТЕЙН НАХИЛЬНИЙ

RO SUPORT RABATABIL

www.emos.cz

Beta400-manual KT2244 0-0-0-K

EMOS spol. s r. o., cz

TV Wall Mount Installation Instructions

Caution:

1. It is recommended for this product to be installed by at least two persons, of

which at least one person should be physically t enough to handle heavy

loads and technically skilled.

2. Before installing, please read this manual and make sure that there are no

electrical cords, gas or water pipes in the place designated for mounting the

holder.

3. We are not responsible for any damage incurred during installation, improper

installation or subsequent use.

4. If in doubt, contact your nearest dealer and ask for assistance with installation.

5. For installation it is necessary to use safe and appropriate tools. Disregarding

the instructions may cause property damage or injury.

6. If you intend to remove the TV from the wall, always make sure all electrical

cords are unplugged.

7. If you are unsure of your wall load, select adierent location for your installation

or carrying capacity and increase the strength of the wall with renovation.

8. The product can be installed only for at screen televisions or televisions

containing mounting holes and have aat back wall. To ensure that this holder

is compatible with your TV search for acompatible holder on the following

website www.emos.eu/DRTV

Tools necessary for installation (not included):

Philips Head Screw Driver

Electric or Portable Drill

Drill bit with 10 mm in Diameter (for Wood, Concrete, or as needed)

Plaster Board or Chipboard Anchors (as needed)

Pencil

Level (if not included)

Included:

Picture Type of Installation Material Pieces

A Anchor 10/50mm 4

B Wall Anchor Bolt 8/63mm 4

C Magnetic Level 1

D Anchor Bolt 4/12mm 4

E Anchor Bolt 4/22mm 4

H Anchor Bolt 6/12mm 4

I Anchor Bolt 6/22mm 4

J Anchor Bolt 8/15mm 4

K Anchor Bolt 8/30mm 4

L Screw Pads 4.5/10mm 4

N Screw Pads 6.3/14mm 4

O Rubber Gasket 15*8/15mm 4

Prior to every installation, remove the entire contents of the package and carefully

lay-out all its parts.

Diagram:

Wall Piece

Mounting Rail

Locking Laces Screws

Attaching the Wall Mount:

Carefully consider the location of your TV screen. To install the wall mount it is

necessary to drill into the wall. It is advisable to nd the position of mounting holes

on the back of your TV and mark their approximate position on the wall. Given

the construction of the wall mount you can then determine the position of the

so-called “wall piece”.

Once you are sure of the place to position your TV and the “wall piece”, take the “wall

piece” (part of the wall mount used to attach to your wall) and with the help of alevel

measure its exact position on the wall. In the opening or openings draw aposition of

anchor bolts on the wall with apencil (B). The number of bolts is at most types of wall

mounts random (the more the better), but mostly 4 anchors are sucient enough.

Take adrill and drill holes deep and wide enough to accommodate the anchors.

Hammer the anchors into the wall and make sure it is fully embedded and xed

in the wall. (If it easily falls out, it is possible that the drill hole is too big and the

anchor bolt is not big enough to stay in the wall – repeat the boring with adrill with

corresponding diameter).

Grasp the wall piece and attach it to the desired location. Attach it to the wall

with anchor bolts and tighten the screws suciently. Mounting of the wall piece

is completed.

NOTE: It is not recommended to install the mount straight on plasterboard walls.

Should you still insist on the installation, we recommend consulting a building

expert rst. You must also use astud detector and special anchors for plasterboard.

If the width of studs supporting the deployment of plasterboard wall is larger than

the width of the wall piece, try to x the wall piece in its centre with the help of

atapping screw into the metal post.

Mounting the TV:

The second part of the mount, the so-called “mounting rail“ is to be attached to the

television. Prior to the installation, it is recommended to rst take the rail and try to

attach it to the already mounted wall piece. This way you can try out the way it is

possible to attach your television to this wall mount or remove it.

Before attaching the rail, rst verify the diameter of screws securing the mounting

holes ready on the back of the TV (usually 4, 5, 6 a8 mm in diameter –these mounting

screws are included, if not otherwise). Mounting screws are provided in two lengths.

To select the proper screw length try to the screw it in the mounting screw hole so

there is remaining margin of 3-5 mm (CAUTION: never tighten with power – it can

cause damage to your television). If there is more space left, it is necessary to use

multiple pads or arubber gasket. It is usually used with longer types of screws (in

case you need agreater distance from the wall to manipulate with cables).To ensure

maximum capacity of the wall mount and prevent deformation of the wall mount it

is necessary to select appropriate types of mounting screws so that the mounting

screws are xed in the holes enough and threads are not exposed (leverage eect

on the mounting hole of the TV and the mount rail can occur).

Produkt Specifikationer

Mærke:	Emos
Kategori:	Ikke kategoriseret
Model:	KT2244
Bredde:	470 mm
Højde:	220 mm
Produktfarve:	Sort
Pakketype:	Kasse
Monteringstype:	Væg
Hældningsvinkelområde:	-10 - 0 °
Rotation:	Ingen
Maksimal vægtkapacitet:	40 kg
Hældningsindstilling:	Ja
Maksimal skærmstørrelse kompatibilitet:	55 "
Antal understøttede skærme:	1
Minimal skærmstørrelse kompatibilitet:	32 "
Montering interface kompatibilitet (min.):	200 x 200 mm
Montering interface kompatibilitet (maks.):	400 x 400 mm
Afstand til væggen (maks.):	25 mm
Dybde (maks.):	20 mm