Extech DA50 Manual


Læs gratis den danske manual til Extech DA50 (1 sider) i kategorien Måling. Denne vejledning er vurderet som hjælpsom af 2 personer og har en gennemsnitlig bedømmelse på 3.5 stjerner ud af 1.5 anmeldelser. Har du et spørgsmål om Extech DA50, eller vil du spørge andre brugere om produktet?

Side 1/1
DA50-EU-V2.0 12/08
Users Guide
DA50 Non-Contact Current Detector
Safety
WARNING: Risk of Electrocution. Before use, always test the Current
Detector on a known current carrying circuit to verify proper
operation
handle of the probe and away from the probe tip
WARNING: If the equipment is used in manner not specified by
manufacturer, the protection provided by the equipment may be
impaired
CAUTION: Read, understand and follow Safety Rules and Operating
Instructions in this manual before using this product.
Do not attempt to repair this unit. There are no user serviceable parts.
Do not expose the unit to extreme temperatures or high humidity
Do not use the unit if it is wet or damaged
Do not apply more than the rated voltage between the probe tip and
ground.
Do not operate with the case open
This symbol, adjacent to another symbol or terminal, indicates
the user the user must refer to the manual for further
information.
This symbol, adjacent to a terminal, indicates that, under normal
use, hazardous voltages may be present
Double insulation
Specifications
Current Sensitivity 200mA AC at 0.2
Bandwidth 50/60Hz
Operating Temperature 32 to 122
o
F (0 to 50
o
C)
Storage Temperature -4 to 140
o
F (-20 to 60
o
C)
Altitude Operating below 2000 meters
Relative Humidity 80% up to 31
o
C, decreasing to 50% at 50
o
C
Battery 2 x 1.5V button batteries (LR44/AG13)
Dimensions/Weight 7.7x2.4x1.2(195x62x30mm)/ 5.2oz (148g)
Safety For indoor use and in accordance with
Overvoltage Category IV 600V, Overvoltage
Category III 1000V, Pollution Degree 2.
Description
1. Current sensor
2. ON and Current indicator lights
3. Sensitivity adjustment (rear)
4. ON/OFF switch
5. Battery compartment
6. Telescoping rod
7. Probe storage area
8. Handle
Operating Instructions
AC CURRENT DETECTION
1. Lift the probe tip from the storage area and extend the
telescoping rod.
2. Twist the rod into the LOCKED position as indicated.
3. Slide the ON/OFF switch to the ON position. The green ON light
will illuminate and the red detection light may ash.
4. Adjust (decrease) the sensitivity adjustment until the red flashing
voltage indicator light and the beeper just stop.
5. Move the probe tip near the current carrying conductor until the
tip flashes and beeper sounds.
6. Slowly adjust the sensitivity and reduce the distance between the
probe and conductor to pinpoint and identify the conductor.
7. To turn off the audible beeper, slide the ON/OFF switch to the
position.
NOTE: RF signals in close proximity to the detector may cause the light
and beeper to latch into a constant tone and light indication. Wait until
the RF signal has disappeared before proceeding with detection.
Battery Installation
1. Unscrew the probe tip..
2. Insert two 1.5V button batteries (observe polarity).
NOTE: If your meter does not work properly, check the battery to make
sure that it still good and that it is properly inserted.
You, as the end user, are legally bound (Battery
ordinance) to return all used batteries and accumulators;
disposal in the household garbage is prohibited!
You can hand over your used batteries / accumulators,
gratuitously, at the collection points for our branches in
your community or wherever batteries / accumulators
are sold!
Disposal
Follow the valid legal stipulations in respect of the
disposal of the device at the end of its lifecycle
Copyright © 2008 Extech Instruments Corporation (a FLIR company)
All rights reserved including the right of reproduction in whole or in part in
any form


Produkt Specifikationer

Mærke: Extech
Kategori: Måling
Model: DA50

Har du brug for hjælp?

Hvis du har brug for hjælp til Extech DA50 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Måling Extech Manualer

Extech

Extech IR201A Manual

28 November 2025
Extech

Extech DV23 Manual

28 November 2025
Extech

Extech RHT10 Manual

28 November 2025
Extech

Extech DA50 Manual

28 November 2025
Extech

Extech 480836 Manual

28 November 2025
Extech

Extech MA3110 Manual

28 November 2025
Extech

Extech EA25 Manual

28 November 2025
Extech

Extech MA150 Manual

28 November 2025
Extech

Extech EA20 Manual

28 November 2025
Extech

Extech CA250 Manual

28 November 2025

Måling Manualer

Nyeste Måling Manualer

FLIR

FLIR E75 Manual

28 November 2025
Terraillon

Terraillon COACH Manual

27 November 2025
FLIR

FLIR T530 Manual

27 November 2025
FLIR

FLIR TG268 Manual

27 November 2025
Testo

Testo 558s Manual

26 November 2025
Eastron

Eastron SEM1 Manual

25 November 2025
Vevor

Vevor SC256M Manual

25 November 2025
Vevor

Vevor SD304 Manual

25 November 2025