Thank you for selecng the Extech DCP36 laboratory grade W Switching DC Power Supply. The 80
DCP36 is auto-ranging and oers a 0.5~36V and 0~5A output capability. Its maximum current
output at 36V is 2.2A (80W/36V). The maximum voltage output at 5A is 16V (80W/5A).
The voltage/current spectrum is greater than three convenonal power supplies of the same
power rang. Adjustable Upper Voltage/Current Limit features protect sensive devices from
wide output variaons. Three user presets allow for easy programming and recall of commonly
used output conguraons. Master/Slave capability for up to 30 units in parallel connecon. The
DCP is perfect fo benchwork, eld service and hobbyists. 36 r ,
The DCP36 is shipped with the following accessories: AC power cord, RJ11 cable, alligator clip test
leads, and an RJ11 terminator plug.
This power supply is shipped fully tested and calibrated and, with proper use, will provide years of
reliable service lease visit the Extech website for the latest user manual and for customer . P
support.
Safety
This manual contains importa informaon illustrang the safe and proper use of th power nt is
supply. Read the enre manual and carefully observe the markings and labels this unit and on on
the equipment to which it will be connected.
Failure to observe may cause injury to persons and damage to the power supply or the connected Warnings
equipment. Failure to observe Cauon statements may result in damage to connected equipment improper and
funconing of the power supply.
WARNINGS
1. Do not use this power supply near water.
2. Do not operate or touch this power supply with wet hands.
3. Do not open the casing of the power supply when it is connected to mains. AC
4. Refer all servicing, including fuse replacement, to qualied service personnel.
CAUTIONS
1. Use a grounded 3-terminal source. AC
2. This t is intended for indoor use only. uni
3. Do not operate or place this unit in a humid or dusty environment.
4. Do not expose this device to direct sunlight or place it near a source of heat.
5. Before plugging into the local AC mains, check the rang label at the ck of the unit. ba
6. Do not block any of the venlaon openings the unit. on
7. This unit must be used within the specified ratings; Continuous and excessive loading may cause damage to
the power supply.
8. The gauge size of input power cable must be at least 0. m75m 2 (18awg) and the total length of power
cable must not exceed 3m (10).
