Extron SM 26 Manual

Extron Højttaler SM 26

Læs gratis den danske manual til Extron SM 26 (4 sider) i kategorien Højttaler. Denne vejledning er vurderet som hjælpsom af 33 personer og har en gennemsnitlig bedømmelse på 3.8 stjerner ud af 17 anmeldelser. Har du et spørgsmål om Extron SM 26, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

Number of Wires

per Connection Point

Maximum

Wire Gauge

1 12 GAW

2 16 GAW

4 18 GAW

Wire Gauge Table

5.1"

(13.0 cm)

6.0"

5.2 )cm

2.6"

(6.6 cm)

3.5"

(8.9 cm)

R = 0.28"

(0.71 )cm

SMK P SM 26/28 Pivot Mount Kit • Setup Guide

This setup guide contains installation information about the Extron SMK P SM 26/28 Pivot Mount Kit.

WARNING: Installation and service must be performed by authorized personnel only.Potential risk of severe injury.

AVERTISSEMENT : Risque potentiel de blessure grave ou de mort. L’installation et l’entretien doivent être effectués par

le personnel autorisé uniquement.

ATTENTION: The final installation should be able to continuously support the speaker weight. The final installation should

also be able to support any short term overloading. Since applications can vary considerably, it is assumed that the

installer will exercise good judgment when selecting the mounting location, method, and hardware. Installation and service

must be performed by authorized personnel only.

Installing the Pivot Mount Kit

The pivot mount enables the speaker to be positioned

and locked at various angles due to the adjustable ball

joint feature.

NOTE: Observe all applicable building codes and

local ordinances when installing the speaker.

ATTENTION: Attaching a secondary support

cable to the SM 26/28 speaker is required when

using the pivot mount kit.

1. Locate a suitable mounting location where the

pivot mount will be installed. Allow for the

dimensions of the SM 26 and SM 28, as shown

below.

SM 28 SM 26: :

2. All four mounting plate

screw holes must be secured

with at least two

screws attached to

a wall stud. Mark

the four holes on

the wall as indicated

by the wall plate

holes.

NOTE:

Mounting

hardware

is not

provided.

3. Drill the four holes

for the wall plate.

4. Drill a hole for the speaker wire.

5. Route the speaker wire through the speaker wire hole

while leaving enough slack for connection to the wall

plate.

NOTE: If the speaker wire is not being routed

through the wall, a notch on the wall plate allows

the wire to enter the wall plate from a raceway.

6. Attach speaker wires to the Euroblock on the wall plate.

Quick Connect Contacts

11.50"

(29.21 cm)

2.44 - 3.35"

(6.20 - cm 8.51)

7.28"

(18.50 cm)

16.50"

1.91 )cm

9.2"

(23.37 )cm

8.45"

(21.46 cm)

2.44 - 3.35"

(6.20 - cm 8.51)

6.45"

(16.38 cm)

12.98"

(32.97 )cm

9.16"

(23.27 cm)

Produkt Specifikationer

Mærke:	Extron
Kategori:	Højttaler
Model:	SM 26

Har du brug for hjælp?

Hvis du har brug for hjælp til Extron SM 26 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Højttaler Extron Manualer

Extron SF 26X Manual

28 August 2025

Extron CA 163 Manual

11 Marts 2025

Extron SM 28 Manual

20 November 2024

Extron SF 3CT LP Manual

20 November 2024

Extron CS 1226T Plus Manual

7 September 2024

Extron CS 26T Plus Manual

7 September 2024

Extron FF 120T Manual

6 September 2024

Extron SM 3 Manual

6 September 2024

Extron SM 26 Manual

6 September 2024

Extron SF 28PT Manual

6 September 2024

Højttaler Manualer

Nyeste Højttaler Manualer

Energy Sistem TempoRave Manual

11 December 2025

RCF C 5215-W MKIII Manual

10 December 2025

RCF X 28 L Manual

10 December 2025

Fostex PM0.4d Manual

8 December 2025

Amphion Argon 3LX Manual

8 December 2025

Amphion Argon 7LX Manual

8 December 2025

8 December 2025

8 December 2025

7 December 2025

7 December 2025