Fantini Cosmi CH175 Manual


Læs gratis den danske manual til Fantini Cosmi CH175 (2 sider) i kategorien Termostat. Denne vejledning er vurderet som hjælpsom af 29 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 15 anmeldelser. Har du et spørgsmål om Fantini Cosmi CH175, eller vil du spørge andre brugere om produktet?

Side 1/2
1 RELAY WIRELESS ACTUATOR FOR SYSTEM
The CH175 unit is an actuator module which, connected to the Intellicomfort+ wireless network, allows a remote control of the boiler or the zone solenoid-
valve. The CH175 module also provides to the wireless repeater functionality, extending the radio range of the Intellicomfort+ wireless network.
SCOPE OF DELIVERY
1 CH175 actuator, 1 two poles removable terminal block, 1 three poles removable terminal block and this installation manual.
INSTALLATION AND CONNECTION
The installation must be carried out by qualied personnel, in compliance with the requirements concerning the installation of electrical devices. Make sure
that the power network is disconnected before making any connection or working on the device.
Make the electrical connections as shown in the picture 2 or 3 with the connection diagrams examples.
Notes
WARNING:The “L1” pole of the output terminal block is connected on the PCB board with the “L” pole of the power terminal block.
To control units with “free voltage contact”, adopt the connection example of the picture 2.
To control units with “powered contact”, adopt the connection example of the picture 3.
Picture 1
Picture 2 Picture 3
TECHNICAL DATA
²
Power supply: 230Vca ±10% - 50Hz
Power consumption: 20VA max (load excluded)
Transceiver frequency: 868MHz
Relay contacts rating: 16(4)A – 250Vca
Maximum cables size: 2,5 mm²
Degree of protection: IP20;
Operating temperature: 0 ÷ 50°C;
Storage temperature: -20 ÷ +70°C;
Shape type: gray ABS plastic;
Dimensions: 36x58x90 mm. - DIN-rail (2 modules)
Responding to Directive 2014/53 / EU (RED).
5679633C
COMMISSIONING AND NETWORK INCLUSION
The CH175 actuator, after power up, will work only after the INTELLICOMFORT+ wireless network inclusion step.
For this procedure it’s necessary to use a special Programmer tool (p/n 1590880) that provides all instructions by display
messages. When required, will be necessary to touch the “X” area of the actuator with the tool (see picture 4). For more details,
please refer to the wireless INTELLICOMFORT+ system manual.
ATTENTION!
               

pdf.fantinicosmi.it
ATTENZIONE!


http://www.fantinicosmi.it






Produkt Specifikationer

Mærke: Fantini Cosmi
Kategori: Termostat
Model: CH175

Har du brug for hjælp?

Hvis du har brug for hjælp til Fantini Cosmi CH175 stil et spørgsmål nedenfor, og andre brugere vil svare dig