Fantini Cosmi Sicurgas P73 Manual

Fantini Cosmi Gasdetektor Sicurgas P73

Læs gratis den danske manual til Fantini Cosmi Sicurgas P73 (2 sider) i kategorien Gasdetektor. Denne vejledning er vurderet som hjælpsom af 20 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 10.5 anmeldelser. Har du et spørgsmål om Fantini Cosmi Sicurgas P73, eller vil du spørge andre brugere om produktet?

Side 1/2
40
Sicurgas P73
Flush mounting carbon monoxide detector
for civil environments
Sicurgas is a device that through a sensitive sensor detects the presence of dangerous concentrations of carbon
monoxide in civil environments.
ELECTRICAL CHARACTERISTICS
Power supply: 230Vac 50Hz.
Output through electromagnetic relay.
Contacts rating: 5(3)A - 250Vac.
STANDARDS AND APPROVALS
Complies with EN 60730-1 standards.
Power
supply
Contacts
rating
Test
button
Operating
temperature
Protection
degree
P73 230 Vac 50Hz 5(3)A - 250Vac YES 0 ÷ 40 °C IP42
115
65
P73 monossido di carbonio
Dimensions (mm)
41
TECHNICAL FEATURES
Shockproof insulating material casing.
Internal visual and acoustic alarms.
Additional acoustic signal.
Sicurgas has three warning lights:
green LED - indicates that the detector works properly;
yellow LED - indicates detector failure;
red LED - indicates the gas presence in the environment (ALARM).
Semiconductor sensor for carbon monoxide detection.
Admissible humidity (without condensation): from 30 to 80% UR.
Unit weight: 0,41 Kg.
INSTALLATION
Flush mounting in 3-module 503 embedded boxes by means of 2 screws (supplied).
The detector should be fixed on the wall at a high level of
approximately 150 cm from the floor.
For a correct functioning of Sicurgas P73, avoid installing the
device:
behind or under cabinets or shelves that can prevent the
natural air circulation in the environment;
near air conditioning plants (minimum distance 2 meters);
on the vertical line of cooking units or steam sources
(bathtubs, etc.);
in places, that could be reached by spraying water, near
sinks, showers, etc.
~150 cm
OPERATION
P73 detector works with carbon monoxide concentrations considered not dangerous for an adult person in normally healthy conditions
even if breathed for several hours (see: researches of U.S. Army Human Engineering Laboratory USA).
In case of danger, Sicurgas P63 immediately activates the internal alarms, the intermittent red LED and an acoustic alarm.
At the same time with the visual and acoustic alarms, operates a relay with switching contacts for controlling an aerator that brings
fresh air from outside.
Sicurgas P73 is equipped with a test button for checking the system: button pressing activates a control procedure with duration of 30
seconds. During this procedure the internal and external components of the system are checked.
Sicurgas P73 can control an aerator/air conditioner to change the air in the controlled room if
contains carbon monoxide and can control a normally closed valve (NC) to intercept possible
fuel-gas.
To operate Sicurgas P73 connect the 230Vc - 50Hz line to the terminals 4 and 5.
If the aerator operates at 230Vac, make a jumper between the terminals 2-4 and connect the
aerator between the terminals 3-5.
1
230Vac - 50Hz
2 3 4 5
EXAMPLE OF CONNECTION
BTICINO Living International, Living di transizione
BTICINO Light, Light Tech
BTICINO Living-light round LNA and square LNB
BTICINO Axolute
VIMAR Idea, Rondò and Plana
GEWISS Playbus e Playbus Young
AVE sistema 45, Noir, Blanc
AVE Banquise, Ave Yes
Siemens Delta Futura Graphit
Legrand Vela square and round
COMPATIBLE PLATES


Produkt Specifikationer

Mærke: Fantini Cosmi
Kategori: Gasdetektor
Model: Sicurgas P73

Har du brug for hjælp?

Hvis du har brug for hjælp til Fantini Cosmi Sicurgas P73 stil et spørgsmål nedenfor, og andre brugere vil svare dig