Ferroli i29 Manual

Ferroli Centralvarmekedel i29

Læs gratis den danske manual til Ferroli i29 (24 sider) i kategorien Centralvarmekedel. Denne vejledning er vurderet som hjælpsom af 45 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 23 anmeldelser. Har du et spørgsmål om Ferroli i29, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/24

cod. 3541I730 — Rev. 02 - 11/2016

i25 / i29

EN -

INSTRUCTIONS FOR USE, INSTALLATION AND MAINTENANCE

“i25” GC n° 47-267-64

“i29” GC n° 47-267-65

i25 / i29

2EN cod. 3541I730 - Rev. 02 - 11/2016

1. GENERAL WARNINGS

• Carefully read and follow the instructions contained in this instruction booklet.

• After boiler installation, inform the user regarding its operation and give him this

manual, which is an integral and essential part of the product and must be kept with

care for future reference.

• Installation and maintenance must be carried out by professionally qualified person-

nel, in compliance with the current regulations and according to the manufacturer's

instructions. Do not carry out any operation on the sealed control parts.

• Incorrect installation or inadequate maintenance can result in damage or injury. The

Manufacturer declines any liability for damage due to errors in installation and use,

or failure to follow the instructions.

• Before carrying out any cleaning or maintenance operation, disconnect the unit from

the electrical power supply using the switch and/or the special cut-off devices.

• In case of a fault and/or poor operation, deactivate the unit and do not try to repair

it or directly intervene. Contact professionally qualified personnel. Any repair/re-

placement of the products must only be carried out by qualified personnel using orig-

inal replacement parts. Failure to comply with the above could affect the safety of

the unit.

• This unit must only be used for its intended purpose. Any other use is deemed im-

proper and therefore hazardous.

• The packing materials are potentially hazardous and must not be left within the

reach of children.

• The unit must not be used by people (including children) with limited physical, sen-

sory or mental abilities or without experience and knowledge of it, unless instructed

or supervised in its use by someone responsible for their safety.

• The unit and its accessories must be appropriately disposed of, in compliance with

the current regulations.

• The images given in this manual are a simplified representation of the product. In

this representation there may be slight and insignificant differences with respect to

the product supplied.

2. OPERATING INSTRUCTIONS

2.1 Introduction

Dear Customer,

i25 / i29 is a high-efficiency sealed chamber condensing heat generator for heating and

hot water production using natural gas or LPG, and equipped with a microprocessor con-

trol system.

THIS UNIT IS IDEAL FOR COMBINING WITH CONVENTIONAL HIGH TEMPERA-

TURE SYSTEMS. IT CANNOT BE COMBINED OR INSTALLED WITH DIRECT DELIV-

ERY TO LOW TEMPERATURE RADIANT PANEL SYSTEMS.

2.2 Control panel

Panel

fig. 1 - Control panel

Panel key fig. 1

1DHW temperature setting decrease button

2DHW temperature setting increase button

3Heating system temperature setting decrease button

4Heating system temperature setting increase button

5Display

6Summer/Winter mode selection - Reset button

7Unit On/Off - Economy/Comfort mode selection button

8DHW symbol

9DHW mode

10 Summer mode

11 Multifunction

12 Eco (Economy) mode

13 Heating

14 Heating symbol

15 Burner lit and actual power level

17 Water gauge

Indication during operation

Heating

A heating demand (generated by the Room Thermostat or Remote Timer Control) is in-

dicated by flashing of the hot air above the radiator on the display.

The display (detail 11 - fig. 1) shows the actual heating delivery temperature and, during

heating standby time, the message “d2”.

Domestic hot water (DHW)

A DHW demand (generated by drawing domestic hot water) is indicated by flashing of

the hot water under the tap on the display.

The display (detail 11 - fig. 1) shows the actual DHW outlet temperature and, during

DHW standby time, the message “d1“.

Comfort

A Comfort demand (reinstatement of temperature inside the boiler) is indicated by flash-

ing of the water under the tap on the display. The display (detail 11 - fig. 1) shows the

actual temperature of the water in the boiler.

Fault

In case of a fault (see cap. 4.5) the display shows the fault code (detail 11 - cap. 4.5) and

during safety pause times the message “d3”.

2.3 Lighting and shutdown

Connection to the power supply

• During the first 5 seconds the display will also show the card software release.

• Open the gas cock ahead of the boiler.

• The boiler is now ready to function automatically whenever domestic hot water is

drawn or in case of a heating demand (generated by Room Thermostat or Remote

Temperature Control).

Switching the boiler off and on

Press the On/Off button (detail 7 - fig. 1) for 5 seconds.

fig. 2 - Turning the boiler off

When the boiler is switched off, the electronic board is still powered. Domestic hot water

and heating are disabled. The antifreeze system remains activated. To relight the boiler,

press the On/Off button (detail 7 fig. 1) again for 5 seconds.

fig. 3

The boiler will be immediately ready to work whenever domestic hot water is drawn or in

case of a heating demand (generated by the Room Thermostat or the Remote Timer

control).

BThe antifreeze system does not work when the power and/or gas to the unit are

turned off. To avoid damage caused by freezing during long shutdowns in win-

ter, it is advisable to drain all water from the boiler, the DHW circuit and the

heating system water; or drain just the DHW circuit and add a suitable anti-

freeze to the heating system, as prescribed in sec. 3.3.

2.4 Adjustments

Summer/Winter Switchover

Press the summer/winter button (detail 6 - fig. 1) for 2 seconds.

The display activates the Summer symbol (detail 10 - fig. 1): the boiler will only deliver

domestic hot water. The antifreeze system remains activated.

To deactivate the Summer mode, press the summer/winter button (detail 6 - fig. 1)

again for 2 seconds.

Heating temperature adjustment

Use the heating buttons (details 3 and 4 - fig. 1) to adjust the temperature from a min. of

30°C to a max. of 80°C; in any case, it is advisable not to operate the boiler below 45°C.

fig. 4

DHW temperature adjustment

Use the DHW buttons (details 1 and 2 - fig. 1) to adjust the temperature from a min. of

40°C to a max. of 55°C.

fig. 5

eco

comfort

reset

79 15

51 2 17

3 414

Produkt Specifikationer

Mærke:	Ferroli
Kategori:	Centralvarmekedel
Model:	i29

Har du brug for hjælp?

Hvis du har brug for hjælp til Ferroli i29 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Centralvarmekedel Ferroli Manualer

Ferroli Optimax HE Plus 25 OV Manual

22 Maj 2024

Ferroli F 24 Manual

26 Marts 2024

Ferroli F30 Manual

8 Marts 2024

Ferroli Optima 901 Manual

13 August 2023

Ferroli Prextherm RSW N Manual

18 Juni 2023

Ferroli Modena 80 E Manual

10 Juni 2023

Ferroli DIVAtech D LN C24 Manual

28 Maj 2023

Ferroli BlueSense 3 Manual

14 April 2023

Ferroli i29 Manual

26 Februar 2023

Ferroli F 24 B Manual

12 Februar 2023

Centralvarmekedel Manualer

Nyeste Centralvarmekedel Manualer

Atmos DC60GSX Manual

7 Juni 2025

ACV E-Tech P 201 Manual

15 Januar 2025

Intergas H22VRTW Manual

13 Januar 2025

17 November 2024

10 Juni 2024

10 Juni 2024

9 Juni 2024

Baxi Solo 3 30 PF Manual

13 Maj 2024

Vokèra Mynute 14e Manual

13 Maj 2024

Vokèra 20/80 RSS Flowmatic Manual

5 Maj 2024