Fibaro FGBRS-001 Manual
Fibaro
Luftfugter
FGBRS-001
Læs nedenfor 📖 manual på dansk for Fibaro FGBRS-001 (27 sider) i kategorien Luftfugter. Denne guide var nyttig for 14 personer og blev bedømt med 4.3 stjerner i gennemsnit af 7.5 brugere
Side 1/27
CONTENTS
#1: Description and features 3
#2: Basic activation 4
#3: Adding to Z-Wave network 5
#4: Removing the device 6
#5: Controlling the temperature 7
#6: Extra temperature sensor 8
#7: Dismounting the device 9
#8: Menu 10
#9: Local protection 11
#10: Head calibration 12
#11: Standby Mode 13
#12: Factory reset 14
#13: Z-Wave range test 15
#14: Battery and charging 16
#15: Normal Schedules 17
#16: Override Schedule 18
#17: Z-Wave specication 19
#18: Advanced parameters 23
#19: Specications 24
#20: Accessory specication (FGBRS-001) 26
#21: Regulations 27
O P E R A T I N G
M A N U A L
EN
v1.0
THE HEAT CONTROLLER
RADIATOR THERMOSTAT
FGT-001
2
Important safety information
Read this manual before attempting to install the device!
Failure to observe recommendations included in this manual
may be dangerous or cause a violation of the law. The manufacturer,
Fibar Group S.A. will not be held responsible for any loss or damage
resulting from not following the instructions of operating manual.
!
This product is not a toy. Keep away from children and animals!
CR2032 coin cell battery is harmful if swallowed!
Battery pack warning!
The Heat Controller contains lithium-ion polymer battery pack, heed all
following warnings:
• If an unusual odor or malfunction is detected, avoid sources of
open ame and remove the device from the radiator.
• In the event of damage from crashes, etc., carefully remove to a
safe place for at least a half hour to observe.
• Do not leave the device unattended while charging.
• Do not attempt to replace the battery!
General information about
the FIBARO System
FIBARO is a wireless smart home automation system, based on the
Z-Wave protocol. All of available devices can be controlled through
a computer (PC or Mac), smartphone or tablet. Z-Wave devices are
not only receivers, but can also repeat the signal, increasing the
Z-Wave network’s range. It gives advantage over traditional wireless
systems that require direct link between transmitter and receiver, as
a result the construction of the building could aect network’s range
negatively.
Every Z-Wave network has its unique identication number (home
ID). Multiple independent networks can exist in the building without
interfering. Transmission security of FIBARO System is comparable to
wired systems.
Z-Wave technology is the leading solution in smart home automation.
There is a wide range of Z-Wave devices that are mutually
compatible, independently of manufacturer. It gives the system the
ability to evolve and expand over time. For more information visit:
www.baro.com.
Produkt Specifikationer
| Mærke: | Fibaro |
| Kategori: | Luftfugter |
| Model: | FGBRS-001 |
Har du brug for hjælp?
Hvis du har brug for hjælp til Fibaro FGBRS-001 stil et spørgsmål nedenfor, og andre brugere vil svare dig
Luftfugter Fibaro Manualer
13 August 2024
9 August 2024
7 August 2024
Luftfugter Manualer
- Luftfugter Samsung
- Luftfugter ATen
- Luftfugter Air&Me
- Luftfugter EQ3
- Luftfugter Motorola
- Luftfugter Dimplex
- Luftfugter Sinbo
- Luftfugter Ravanson
- Luftfugter Venta
- Luftfugter Toshiba
- Luftfugter Caso
- Luftfugter Breville
- Luftfugter Vitek
- Luftfugter Mitsubishi
- Luftfugter Olimpia Splendid
Nyeste Luftfugter Manualer
18 Marts 2025
7 Marts 2025
7 Marts 2025
7 Marts 2025
7 Marts 2025
4 Marts 2025
24 Februar 2025
24 Februar 2025
23 Februar 2025
7 Februar 2025