Fisher & Paykel CG302DLPGB1 Manual

Fisher & Paykel Komfur CG302DLPGB1

Læs gratis den danske manual til Fisher & Paykel CG302DLPGB1 (16 sider) i kategorien Komfur. Denne vejledning er vurderet som hjælpsom af 24 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 12.5 anmeldelser. Har du et spørgsmål om Fisher & Paykel CG302DLPGB1, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/16

GAS-ON-GLASS COOKTOP

CG301D, CG302D, CG451D, CG603D, CG604D, CG752D, CG903D

& CG905D models

INSTALLATION GUIDE

NZ AU

590149I 03.18

IMPORTANT!

SAVE THESE INSTRUCTIONS

The models shown in this installation guide may not be available in all markets and are subject to change at any time. For current details about model and specification availability in your country, please go to our

website www.fisherpaykel.com or contact your local Fisher & Paykel dealer.

IMPORTANT SAFETY INSTRUCTIONS

Particular attention shall be given to the relevant requirements regarding ventilation.

Read these instructions carefully before installing this product.

Please make this information available to the person installing the appliance as it could

reduce your installation costs.

This appliance is to be installed and serviced only by an authorised person.

Installation must comply with your local building and local gas authority codes and

electricity regulations.

Incorrect installation, for which the manufacturer accepts no responsibility, may cause

personal injury or damage and could invalidate any warranty or liability claims.

These appliances are registered in: (New Zealand) at www.energysafety.govt.nz and

(Australia) with SAI Global at www.saiglobal.com.

Appliances are factory set for Natural gas but are convertible to ULPG. If in doubt, refer

to the local gas network operator or gas supplier to confirm gas type at installation site.

Do not modify this appliance.

Do not use or store flammable materials on or near this appliance.

Do not spray aerosols in the vicinity of this appliance while it is in operation.

Packing elements (eg plastic bags, polystyrene foam, staples, packing straps etc) and

tools should not be left around during and after installation, especially if they are within

easy reach of children, as these may cause serious injuries.

You must remove the transit screws before installing the cooktop. See step 8 of

installation instructions.

Before you install the appliance, please make sure that

the local distribution conditions (nature of gas and pressure) and the adjustment of the

appliance are compatible. For adjustment conditions for this appliance see ‘Gas rate

summary’.

a suitable disconnection switch is incorporated in the permanent wiring, mounted and

positioned to comply with the local wiring rules and regulations. A means of disconnection

with at least a 3 mm air gap contact separation in all poles must be incorporated into

the fixed wiring in accordance with the wiring rules, unless the local wiring rules allow for

alternative means.

the appliance is connected to a 220V - 240V 50Hz (10 A) power supply only and earthed

via the power supply cable.

there is a power outlet within reach of the power supply cable (900 mm from the centre

rear of the product). This must be accessible after installation. The power supply cable

should not touch any metal parts.

if the power supply cable is damaged, it is replaced only by the special cable: Part no.

534993 KIT SPARES TRMNL BLK-FLEX 10, obtainable from authorised Fisher & Paykel

Service Agents.

the supply connection point (gas shut-off valve) is accessible after installation.

the benchtop is made of a heat resistant material.

the installation complies with all the requirements of Australian and New Zealand Gas

Installation Standards (AS/NZS 5601.1.2010), including that the product has to be installed

so that the surface temperature of any nearby combustible surface will not exceed 65 OC

above ambient. See step 5 ‘Clearance Dimensions’.

When you install the appliance

As servicing requires removing of the cooktop from the benchtop we do not recommend

flush mounting. To the fullest extent permissible by law, the owner carries all risk for flush

mounting of the cooktop. The owner must ensure the cooktop has been cut out from the

benchtop before servicing can be carried out. Fisher & Paykel will not be liable for any

costs associated with removing or replacing a flush-mounted and/or sealed-in product,

nor for repairing any damage that may be incurred by doing this. Fisher & Paykel does not

exclude any statutory liability it may have and which by law cannot be excluded, because of

the giving of this notice.

If installed with an approved flexible hose, the hose should not come in contact with the

bottom of the appliance or any sharp edges. Flexible hose assemblies should be AS/NZS

1869 Class B or Class D certified with a maximum length of 1.20m.

Seal exposed bare edges of the cutout with an oil-based paint or moisture-proof

polyurethane to prevent possible moisture creeping between the cooktop trim and the

benchtop.

Take extreme care not to chip, crack, or break the top glass surfaces during installation. A

heavy metal tool or part accidentally dropped on the glass could damage it.

If, after following the instructions given, correct performance cannot be achieved, please

contact your nearest Fisher & Paykel Authorised Service Centre, Customer Care, or contact

us through our local website listed at the end of this document.

1 SAFETY AND WARNINGS

WARNING!

Electrical Shock Hazard

Before carrying out any work on the electrical section of the appliance, it

must be disconnected from the mains electricity supply.

Connection to a good earth wiring system is absolutely essential and

mandatory.

Alterations to the domestic wiring system must only be made by a qualified

electrician.

Failure to follow this advice may result in electrical shock or death.

WARNING!

Cut Hazard

Take care - panel edges are sharp.

Failure to use caution could result in injury or cuts.

Produkt Specifikationer

Mærke:	Fisher & Paykel
Kategori:	Komfur
Model:	CG302DLPGB1
Vekselstrømsindgangsspænding:	230 - 240 V
Bredde:	300 mm
Dybde:	530 mm
Højde:	64 mm
Produktfarve:	Sort
Kontroltype:	Dreje
Indbygget skærm:	Ingen
Strøm:	10 A
Placering af apparat:	Indbygget
Komfurtype:	Gaskomfur
Overfladetype:	Glas
Antal kogeplader / madlavningsområde:	2
Kontrolposition:	Øverst til højre
Nem at rengøre:	Ja
Tilsluttet belastning (elektrisk):	- W
Ovnbredde størrelse:	30 cm
Tilsluttet belastning (gas):	- W
Antal gasbrændere:	2
Elektronisk tænding:	Ja
Komfurlåg:	Ingen
Tændblussikring:	Ja