FLOWCINE Black Manual

FLOWCINE Stativ Black

Læs gratis den danske manual til FLOWCINE Black (15 sider) i kategorien Stativ. Denne vejledning er vurderet som hjælpsom af 23 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 12 anmeldelser. Har du et spørgsmål om FLOWCINE Black, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/15

BLACK ARM SET UP INSTRUCTIONS V0.75

Please read through the full documentation, before using the arm for the first time! The documentation includes configurations and

help for troubleshooting most problems encountered on set.

QUICK GUIDE SETUP AND CONFIGURATIONS FOR: BLACK ARM STANDARD & BLACK ARM COMPLETE

NOTE! The current manual contains instruction/placement

for the first generation dampeners. There is another manual

out soon for second generation (shorter) dampeners soon.

You can tell difference by looking at the soft end stops on the

dampeners. ALL first generation dampeners will be replaced

by Flowcine, as soon as possible, due to production errors

emailed earlier. If you have a urgent problem with your

dampener, please email info@flowcine.com. Thank you!

1st gen dampener (thin rubber end stop opposite end of ball joint)

2nd gen dampener (thick rubber end stop)

337mm

297mm

SINGLE SPRING 7.0 (Pre-installed for BLACK ARM STANDARD users): 2 x 7 mm (1x7 per side) for payload up to / payload. Max extension 25mm. 14kg 31 lbs

NOTE! Always insert tension screw equally on each side when mounting a new spring.

Dual nuts (Optional). Keeps the spring from unintentionally wind/un-wind itself.

And keep track on which side to tension from.

Single nut & washer (Optional). Helps keep the dual spring bracket to align straight and not rotate, while there is no load on the springs. Always loosen these

before ANY tensioning is done. You can use a nut&washer on each side, on one side or not use them at all (not necessary when the arm is in action).

Dual nuts (Optional ). Helps you keep track of the maximum safety tension limit of 25mm.

The distance is set, from a relaxed spring (before any tensioning). Use a caliper

or equal to check distance between spring and nut before usage or change of springs.

BLACK ARM SPRING GUIDE:

Single 7.0

SINGLE SPRING 7.5 (Pre-installed for BLACK ARM COMPLETE users): 2 x 7.5 mm (1x7.5 per side) for payload up to payload. Max extension 25mm. 19 kg / 42 lbs

Single 7.5