Fluke 6109A Manual

Fluke Temperaturregulator 6109A

Læs gratis den danske manual til Fluke 6109A (4 sider) i kategorien Temperaturregulator. Denne vejledning er vurderet som hjælpsom af 73 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 37 anmeldelser. Har du et spørgsmål om Fluke 6109A, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

PN 4924861

September 2017, Rev. 1, 3/21

All product names are trademarks of their respective companies.

Fluke Corporation

P.O. Box 9090

Everett, WA 98206-9090

U.S.A.

Fluke Europe B.V.

P.O. Box 1186

5602 BD Eindhoven

The Netherlands

Calibration Bath

Safety Information

Introduction

This document supplies safety information for the Calibration Bath (the Product).

Safety Information

A Warning identifies hazardous conditions and actions that could cause bodily harm or death.

A Caution identifies conditions and actions that could damage the Product, the equipment under test, or cause

permanent loss of data.

Symbols

The symbols used in the manuals and on the Product are shown below.

Symbols

Symbol Description

X Hazardous voltage. Risk of electric shock.

W Risk of Danger. Important information. See Manual.

» Consult user documentation.



XW Warning

To prevent possible electrical shock, fire, or personal injury:

• Read all safety information before you use the Product.

• Carefully read all instructions.

• Do not alter the Product and use only as specified, or the protection supplied by

the Product can be compromised.

Calibration Bath

Safety Information

• Do not use the Product if it is altered or damaged.

• Do not use the Product around explosive gas, vapor, or in damp or wet

environments.

• Use this Product indoors only.

• Do not use an extension cord or adapter plug.

• Replace the mains power cord if the insulation is damaged or if the insulation

shows signs of wear.

• Make sure the ground conductor in the mains power cord is connected to a

protective earth ground. Disruption of the protective earth could put voltage on the

chassis that could cause death.

• Do not put the Product where access to the mains power cord is blocked.

• Make sure that the space around the Product meets minimum requirements.

• Read the bath fluid safety data sheet (SDS) and take necessary precautions. Some

fluids are corrosive, toxic, or irritate the skin, eyes, nose, and respiratory organs.

• Use a ventilation system to remove vapor.

• Do not use fluids that are corrosive to stainless steel.

• Always use the provided access cover or other suitable metallic access cover if

the selected bath fluid is flammable. An exposed heater element, due to low-liquid

level or other external ignition sources, could lead to spread of fire from the bath

access port. The access cover limits air ingress into the bath headspace and

prevents ignition and helps to quickly extinguish any fire. The access cover may

be drilled to permit temperature probe insertion.

• Use only specified replacement parts.

• Have an approved technician repair the Product.

• Do not operate the Product with covers removed or the case open. Hazardous

voltage exposure is possible.

Provide Ventilation

Harmful substances such as benzene and formaldehyde can be produced above a certain temperature when

heating silicone bath fluids. Consult the safety data sheet of the specific bath fluid for the temperatures at which the

fluid begins to degrade and the byproducts that may be emitted.

Bath fluid vapors present a fire hazard, especially when the bath fluid is operated above its flash point. Bath fluid

vapors tend to condense onto surrounding surfaces. This can contaminate materials and inhibit laboratory

cleanliness. If enough condensation accumulates on the floor, the floor becomes slippery and creates a safety

hazard.

For proper fume extraction Fluke Calibration recommends to use at least a ventilation duct of 75 mm (3 in) or more

in diameter with a flow rate of at least 1.4 cubic meters per minute (50 cfm). Place the inlet of the ventilation duct

near the top of the tank.

Produkt Specifikationer

Mærke:	Fluke
Kategori:	Temperaturregulator
Model:	6109A

Har du brug for hjælp?

Hvis du har brug for hjælp til Fluke 6109A stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Temperaturregulator Fluke Manualer

3 August 2025

2 August 2025

2 August 2025

2 August 2025

2 August 2025

2 August 2025

2 August 2025

2 August 2025

2 August 2025

2 August 2025

Temperaturregulator Manualer

Nyeste Temperaturregulator Manualer

Daikin KRCS01-8B Manual

11 August 2025

Daikin BRC4C61 Manual

11 August 2025

IFM LT8922 Manual

9 August 2025

IFM TA1605 Manual

9 August 2025

Hager EK724 Manual

9 August 2025

Techno Line WS 7039 Manual

2 August 2025

Techno Line WS 9178 Manual

2 August 2025

Techno Line WS 6812 Manual

2 August 2025

Techno Line WS 9765 Manual

1 August 2025

Techno Line WS 9140 Manual

1 August 2025