Fluval CP2 Manual

Fluval Vandpumpe CP2

Læs gratis den danske manual til Fluval CP2 (18 sider) i kategorien Vandpumpe. Denne vejledning er vurderet som hjælpsom af 35 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 18 anmeldelser. Har du et spørgsmål om Fluval CP2, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/18
IMPORTANT SAFETY INSTRUCTIONS
WARNING – To guard against injury, basic safety precautions should be observed, including the
following.
1.
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
and all important notices on the appliance before using. Failure to do so may result in damage to
the unit.
2. DANGER – To avoid possible electric shock, special care should be taken since water is employed in
the use of aquarium equipment. For each of the following situations, do not attempt repairs yourself;
return the appliance to an authorized service facility for service or discard the appliance.
A. If the appliance shows any sign of abnormal water leakage or if RCD (or GFCI- Ground Fault Current
Interrupter) switches off disconnect the power supply cord from mains and remove the circulation
pump from water.
B. Carefully examine the appliance after installation. It should not be plugged if there is water on parts
not intended to be wet.
C. Do not operate any appliance if it has a damaged cord or plug, or if it is malfunctioning or it is
dropped or damaged in any manner. The power cord of this appliance cannot be replaced; if the cord
is damaged, the appliance should be discarded. Never cut the cord.
D. To avoid the possibility of the appliance plug or receptacle getting wet, position the appliance to
one side of a wall mounted receptacle to prevent water from dripping onto the receptacle or plug.
A “drip loop” (see illustration 1) should be arranged by the user for the
cord connecting appliance to a receptacle. The “drip loop” is that part of
the cord below the level of the receptacle or the connector if an extension
cord is used, to prevent water travelling along the cord and coming in
contact with the receptacle. If the plug or receptacle does get wet, DON’T
unplug the cord. Disconnect the fuse or circuit breaker that supplies
power to the appliance. Then unplug and examine for presence of water in
receptacle.
3. WARNING – Close supervision is necessary when any appliance is used
by or near children. This appliance is not intended for use by persons
(including children) with reduced physical, sensory ormental capabilities,
or lack of experience and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the appliance.
4. To avoid injury, do not touch moving parts or hot parts.
5. CAUTION – Always unplug or disconnect all appliances in the aquarium from electricity supply
before placing hands in water, before putting on or taking off parts and whilst the equipment is being
installed,maintained or handled.When inserting or removing the circulation pump from the water,
always pull out the main electricity plug. Never yank cord to pull plug from outlet. Grasp the plug and
pull to disconnect. Always unplug an appliance from an outlet when not in use.
CP1
CP2
CP3
CP4
INSTRUCTION MANUAL
MODE D’EMPLOI
MANUAL DE INSTRUCCIONES
BEDIENUNGSANLEITUNG
INSTRUCTIEHANDLEIDING
MANUAL DE INSTRUÇÕES
6. This is an aquarium circulation pump. Do not use this circulation pump for other than intended use
(i.e.: do not use in swimming pools, bathrooms, etc.). The use of attachments not recommended or sold by
the appliance manufacturer may cause an unsafe condition.
 •Donotusethiscirculationpumpinswimmingpoolsorothersituationswherepeopleareimmersed.
 •Thiscirculationpumpissuitableforuseinwatertemperaturesupto35°C.
 •Donotusethiscirculationpumpwithinammableordrinkableliquids.
7. This circulation pump is suitable for INDOOR/HOUSEHOLD use only. Do not install or store the appliance
where it will be exposed to the weather or to temperatures below freezing.
8. Make sure that the circulation pump is securely installed before operating it. Do not allow pump to run dry.
The circulation pump must be immersed in water completely. This circulation pump must never operate
outside of water.
9. WARNING – For North American market only. This appliance has a polarized plug (one blade is wider than
the other). As a safety feature, this plug will fit in a polarized socket only one way. If the plug does not fit
fully in the socket, reverse the plug. If it still does not fit, contact a qualified electrician. Never use with an
extension cord unless plug can be fully inserted. Do not attempt to defeat this safety feature.
10. If an extension cord is necessary, a cord with proper rating should be used. A cord rated for less amperes
or watts than the appliance rating may overheat. Care should be taken to arrange the cord so that it will not
be tripped over or pulled. The connection should be carried out by a qualified electrical installer.
11.
SAVE THESE INSTRUCTIONS
For the complete use and understanding of this product it is recommended that this manual is thoroughly
read and understood. Failure to do so may result in damage to this product.
INTRODUCTION
Fluval Sea CP series circulation pumps are designed to work in small reef aquariums. The
exclusivedesignguaranteesacontinuousandpowerfulwaterowwith270°directionalow
capability. The suction cup(s) will safely hold the CP circulation pumps on glass (or acrylic) up
to 10mm - 3/4” thick.
DESCRIPTION (FIG. 1)
A. Upper chamber E. Motor mount bracket
B. Impeller Suction cupF.
C. Shaft G. Suction cups
D. Pump body / Lower chamber
ATTENTION!!!
Fluval Sea Circulation Pumps are specially designed for use in aquariums and tanks for water
movement. It is not a filtration pump. Please refer to your dealer for any other application.
SAFETY INFORMATION
Attention: please verify that all components of the pump are undamaged before putting it into function.
Before any kind of intervention, ALWAYS disconnect electrical supply of the pump and any other
appliance placed in the water. Be sure that the voltage of the mains supply corresponds to the voltage
shown on the unit’s label.
•Thepumpisintendedforindooruseonlyinwaterwithatemperatureofmax.35°C(95°F).
•Donotconnecttoelectricalsupplyifpumpisnotcompletelyimmersedinwater.
•Donotconnecttoelectricalsupplyifpumpismissingparts.
•Donotconnecttoelectricalsupplyifpumpisnotpositionedusingthesuppliedsuction-cup.
•Thecordofthispumpcannotbereplacedorrepaired;incaseofdamagetheentireunitmust
be substituted.
•Donotcutorpullontheelectricalcord.
•Alwaysdisconnectfrommainpowersupplygentlyandmakesurehandsaredry.
•Wheninoperation,makesurethatthepumpsurfaceisnotblocked.
•Wheninoperation,makesurethatthepumpdoesnottakeinsand,asthiscouldseriously
damage the unit and void the guarantee (read carefully the maintenance paragraph)
•Alwayscleantheaquariumsidebeforeplacingthesuctionscup(s),anydirtonthesurface
might prevent the suction cup(s) from attaching properly and the pump might slip on the
bottom of the aquarium causing damage to livestock and itself.
•Pleasekeeptheseinstructionsinasafeanddryplace.
INSTALLATION
Attention: please verify that all components of the pump are undamaged before putting it
into operation. Before any kind of maintenance, always disconnect electrical supply of the
pump and any other appliance placed in the water. Be sure that the voltage of the main power
supply corresponds to the voltage shown on the unit’s label. In order to prevent noise and
disturbance caused by vibration we suggest to position the pump avoiding lateral contact with
the aquarium glass or in an upward position on the bottom.
•Unwindtheelectriccable.
•Insertthepumpontothesuctioncup(Fig.2).
•Immersethepumpcompletely andturnitinaverticalpositioninordertoallowanyairto
come out of the impeller chamber.
•Attachthepumpinthedesiredlocation(Fig.3)bypressingrmlytoensurethesuctioncup(s)
adhere to the glass. Remember to clean the surface before affixing to glass.
•Directthewaterowasdesired(Fig.4).
•Connecttoelectricalsupply.
MAINTENANCE
Attention: Before any kind of maintenance, ALWAYS disconnect electrical supply of the pump
and any other appliance placed in the water.
•Regularcleaningandmaintenancewillguaranteethepumpbetterandlongerperformance.
•Removepumpfromaquarium.
•Disassembleasshown(Fig.5).
•Cleantheimpellerassemblyremovingdepositswithasoftbrush.Donotusedetergentsor
solvents.
• Reassemble everything in reverse order, make sure the notches on the pump chambers
correspond and that the motor mount bracket is placed correctly (Fig. 6).
• In case of abnormal noise and /or reduced performance caused by sudden changes in
electricity supply, it is sufficient to restart the pump.

Produkt Specifikationer

Mærke: Fluval
Kategori: Vandpumpe
Model: CP2

Har du brug for hjælp?

Hvis du har brug for hjælp til Fluval CP2 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Vandpumpe Fluval Manualer

Fluval

Fluval CP3 Manual

13 Juli 2024
Fluval

Fluval SP6 Manual

13 Juli 2024
Fluval

Fluval CP2 Manual

10 Juli 2024
Fluval

Fluval CP4 Manual

10 Juli 2024
Fluval

Fluval SP4 Manual

10 Juli 2024
Fluval

Fluval CP1 Manual

10 Juli 2024

Vandpumpe Manualer

Nyeste Vandpumpe Manualer

Hydro-Pro

Hydro-Pro 18 Manual

12 Oktober 2025
Hydro-Pro

Hydro-Pro 22T Manual

12 Oktober 2025
Hydro-Pro

Hydro-Pro 22 Manual

11 Oktober 2025
Euromac

Euromac SPV900i Manual

8 Oktober 2025
DAB

DAB NOVA Salt W Manual

4 Oktober 2025
DAB

DAB Genix VT 030 Manual

4 Oktober 2025
DAB

DAB Verty Nova 200 Manual

3 Oktober 2025
DAB

DAB E.Swim 150 M Manual

3 Oktober 2025
DAB

DAB Esybox Mini 3 Manual

3 Oktober 2025
DAB

DAB JetInox 112 M Manual

3 Oktober 2025