Frigidaire 5304473845 Manual


Læs gratis den danske manual til Frigidaire 5304473845 (3 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 46 personer og har en gennemsnitlig bedømmelse på 3.6 stjerner ud af 23.5 anmeldelser. Har du et spørgsmål om Frigidaire 5304473845, eller vil du spørge andre brugere om produktet?

Side 1/3
4' Rubber Fill Hose 2 Pack
5304473845
Paquete de 2 mangueras de llenado de caucho de 4'
Paquet de 2 tuyaux de remplissage en caoutchouc de 4 pi
Installation
1. Run some water from the hot and cold faucets to ush the
water lines and remove particles that might clog the water
valve screens and to determine which faucet is hot and
which is cold supply. (Fig. 1).
5304473845 (August 2022)
Fig. 1
Fig.2
Cold Hot
Fig. 3
2. Check to ensure the inlet hoses have the rubber washer
rmly in place. (Fig. 2).
3. Connect the HOT inlet hose (color: red) to the HOT inlet
connection on the washer and the COLD inlet hose to the
COLD inlet connection (color: blue) on the washer. (Fig. 3).
4. Tighten by hand until snug. Then tighten each supply
connection another 2/3 turn with pliers. Do not cross thread
or overtighten these connections. (Fig. 4).
5. Connect the HOT inlet hose to the HOT water supply and the
COLD inlet hose to the COLD water supply. (Fig 5).
Fig. 4
7. Turn on the water and check for leaks. (Fig. 7).
Fig. 5
6. Tighten by hand until snug. Then tighten each supply
connection another 2/3 turn with pliers. Do not bend, kink or
pinch water inlet hoses. (Fig. 6).
Fig. 6
The water supply pressure must be between 14.5 PSI and 116 PSI.
If the water supply pressure is more than 116 PSI, you must install
a pressure reducing valve. The washer requires both a hot NOTE:
and a cold water supply to be attached. The water supply for the
hot water valve should be at least 120˚F.
Replace water supply hoses every 2 to 3 years.
Fig. 7
Paquete de 2 mangueras de
llenado de caucho de 4'
5304473845
Instalación
1. Deje correr un poco de agua de los grifos fríos y calientes
para enjuagar las líneas de agua y eliminar las partículas que
podrían obstruir las rejillas de las válvulas de agua y para
determinar qué grifos están calientes y cuál es el suministro

5304473845 (agosto 2022)
g. 1
g.2
Frio Caliente
g. 3
2. 

3. Conecte la manguera de entrada CALIENTE (color: rojo) a la
conexión de entrada CALIENTE en la lavadora y la manguera
de entrada FRÍA a la conexión de entrada FRÍA (color: azul) en

4. Ajuste a mano hasta que quede apretado. Luego apriete cada
No cruce
la rosca ni apriete en exceso estas conexiones.
5. Conecte la manguera de entrada CALIENTE al suministro de
agua CALIENTE y la manguera de entrada FRÍA al suministro

g. 4
7. 
g. 5
6. Ajuste a mano hasta que quede apretado. Luego apriete
No
doble, retuerza ni pellizque las mangueras de entrada de
agua.
g. 6
La presión del suministro de agua debe estar entre 14,5 PSI y 116
PSI. Si la presión del suministro de agua es superior a 116 PSI,
debe instalar una válvula reductora de presión. NOTA: La lavadora
requiere la conexión de un suministro de agua fría y caliente. El
suministro de agua para la válvula de agua caliente debe ser de al

Reemplace las mangueras de suministro de agua cada 2 a 3 años.
g. 7


Produkt Specifikationer

Mærke: Frigidaire
Kategori: Ikke kategoriseret
Model: 5304473845

Har du brug for hjælp?

Hvis du har brug for hjælp til Frigidaire 5304473845 stil et spørgsmål nedenfor, og andre brugere vil svare dig